Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - KMPrenger's Album: Random Stuff

You are browsing camaro5

Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com

Dynomax Exhaust

		Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > KMPrenger's Profile > Albums
Random Stuff

Mark Forums Read

Page 1 of 2

1

Random Stuff

Some randomz

My ported intake manifold from MACE that I polished and painted myself. Turned out decent..not perfect but good enough for me!

New premium floor mats

torx screw for door handle release.

door handle removed.

20120617 130635

20120617 130657

20120617 130907

My car with ZL1 side rockers photoshopped into place.

Insulator in place.

Manifold off!

My racheting box wrenches made this job easier for sure.

RX insulator with Permatex "Black" RTV sealant

Still an inch or so of clearance for the Vararam after installation of the insulator...which is plenty.

Inside of manifold fairly clean thanks to my Mike Norris elite catch can.

Tried out this Virtual Dyno program in conjuction with my Torque Android app to see if it could give me HP/TQ numbers. Seems a bit off but the program is pretty cool anyways.

Engine Cover done!.....for now!

Right after my Heritage grille and lower street scene grill with ducts was added. No 'RS' emblem yet.

New Kick Plates "2010 Camaro"

JC High Street car show

100 4180

radiator bracket cut

Over view of VR installed.

Making sure the clearance is good!

Radiator bracket cut

Vararam air scoop and inlet.

Vararam1

Back when I had my AirRaid intake...now I'm the proud owner of a Vararam.

Door trim/weather stripping clip placed into the door before replacing panel. You can see the raised weather stripping above.

Back of the new trim..you can see the underneath of one of the stock plastic rivets after being ground off in the middle, right is the new replacement screw. (left screw is an original hex screw)

100 3963

Page 1 of 2

1

All times are GMT -5. The time now is 06:48 PM.