- Borla atak l99
- Question on long tube headers
- Camaro Exhaust
- Decision help
- Anyone have a CAI with Roto-fab reservoir and a Hotchkis Strut Tower Brace Installed?
- Question about JBA High Flow Cats fitment with Flowmaster American Thunder Catback
- Headers with NO TUNE?
- Question about the spark plug threads in the cylinder head
- Did I Make The Right Desicion?
- Valve & lifter questions for the engine builders
- Mbrp with headers??
- Problem after installing VARARAM
- How hard to change plug wires?
- A fun challenge, 10.99ET in a Vert with heavy restrictions...
- Blue Smoke sometimes
- Gonna Install cam in next month or so
- What is what on the stock exhaust system
- Dyno Day at Vette Doctors
- Vert x-pipe question
- GMPP EXHAUST
- Christmas- hmmmm
- Drone with headers (SW) and factory catback??
- Any tuned L99 guys have any Power train problems after tuning?
- Typhoon™ Air Intake System
- SW Retro 3" rattle
- Kooks Stepped Headers
- Surprised By The Small Gain With Cold Air Intake
- CHECK ENGINE LIGHT W/HF CATS
- which brace to get ?
- DMH Cutouts and clearance
- Is heavy rain or car wash a problem if you have the 69 series typhoon air intake?
- New Era Air Intake
- My oil breather gets dirty FAST! Why?
- The SS is at Livernois
- What are the best valve springs to run?
- Should I ditch the RX catch can?
- expected gains from mods
- WOW!!! New Stainless Power Line Headers
- Header Diameter
- Iconel valves
- Oh so pretty, coated dynatechs
- Does anyone know the stock exhaust brand of the 2011 Camaro?
- rating kooks vrs ARH headers
- Header install
- Headers with stock catback?
- Can someone explain this
- Sprint Booster who has it, who's tried it?
- DynaTech LT's installation questions to stock catback
- Had my Corsa Cat Back Installed Today on my LS3. Video
- 18" enough lift for LT installation?
- I'm a catch can believer!
- TSP Small Bore LS7 Production set (PICTURES)
- 416 vs 427
- Suggestions on rods and pistons?
- Stainless works headers vs kooks and AR
- Testing Rays 1K beast in the driveway
- GMPP Performance Exhaust + Solo High Flow Cats Sound
- Installed my catch can - L99
- After thoughts of my DynaTech LT's and high flow cats install
- thoughts and impressions of my dynatech LT install
- time to replace filer for CAI ?
- Anyone have a engine diagram?
- Stainless works headers. Input wanted
- CAI's Pending CARB Approval
- borla attack series cat back installation
- My Dealer said If They Installed Cam & LT's they would cover it under warranty
- Replacement TB to Vararam Coupler?
- How Many REAL Hours does it take to do a cam swap on a LS3?
- LS3 CATCH CAN INSTALL TODAY
- New valve covers installed
- have LT's now to the rest, your input needed
- Bending exhaust hangers
- Oiled and non oiled intake systems
- Anyone Ever Use This Product Good for 25hp?
- Am I required to re-program the ECM?
- 3" axle back with GFX
- I need a catch can, maybe you do too.
- flowmasters on ss?
- Vararam: change red coupler hose
- Cold start-up rattle with SOLO Mach XL?
- Fuel supply line
- Does a K&N intake require a tune?
- Lg g6x3 cam and yella terra 1.8 rockers
- Quietest 3" catback
- 12V Switched Source
- Difference between 91oct and 93oct on a dynojet?
- Mods
- witch one????
- Headers & Exhaust
- Low track times our of SLP ZL585
- Cal speed and performance.
- LS3 starter location?
- can the heads and cam from a 6.2 z71 swap with a l99
- Ready for exhaust UPGRADE... Need input!
- *** Cartek NA Heads & Cam raises the bar ***
- New dyno results
- stainless works vs american racing headers vs borla
- 110 lsa cam
- different Volant Cold air intakes
- Kooks stepped headers vs ARH ...??
- Who make a stroker kit?
- long tube headers
- Changing Mufflers with SLP Pipes
- F.A.S.T 102mm Intake Manifold.
- No more decel pop.
- Exhaust Tips
- What Scoop to use with C.A.I Intake?
- ARH/COPO Camaro/SEMA 2011
- Only five days old and,.......
- Obx headers with high flow cats??
- Changing Exhaust Tips
- 3" Stainless Works Retro Chambered Installed
- Unknown noise??
- FLAMES FROM EXHAUST?
- Methanol on n/a
- Vendor With Best Priced Kook's 1 7/8" Catted Mid With Flowmaster American Thunder
- Exhaust Lay out
- Its an all day job... $1000!!
- Gains with a CAI and a tune
- "flex" pipe with LT's and high flow cats on L99
- Headers catback question
- Just put the VMAX TB on
- which one?
- Exhaust Set-up
- adding a eforce with stock bottom end and manifolds.
- Across the power band cam upgrade help.
- UnderPulley Question
- CEL after intake/exhaust install and dyno tune?
- Just ordered headers
- Flowmaster Outlaw Exhaust
- Stainless Works Catback exhause question
- headers to close to fuel line?????
- 3" ARH, X-pipe, Magnaflo Comp
- ATI Gen5 dampers keyed?
- Borla Exhaust, Cat Back Vs Axel Back?
- New manifold done.
- What's up with the GMPP Air Intake?
- Ed Curtis cams? Go
- Does anyone know what cam these cars are running
- 1/4 mile times
- Opinions & Advice needed On Catted Or Off-Road Connections?
- Header Size?
- Tony Mamo ported LSXr 102mm runners assembled out of order?
- Vararam V8 Intake versus other intakes
- Whats the difference in LT Header sizes?
- richmond 410 gears
- No Cats...
- DMH cutout location
- Anybody running a 102mm throttle body?
- Catch Can Design question
- Please help identify this TSP cam pics inside
- Engine swap LS3 in a V6
- who has shorties on?
- SLP shorties discontinued.
- is it possible to get a true 500hp at the crank... just bolt ons?
- Weird noise after exhaust install
- How much louder are cutouts
- Lethal Performance cars at the track both LS3 based motors!!
- best place to get air for CAI
- Cold Air Inductions CAI installed this past weekend
- help me to find kooks part number
- I had my coil pack brackets powder coated
- what's the numer of HP can get with this simple add
- Any video, LS9 cam in a LS3?
- Cherry Bomb Extreme Cat-Back Installed!!!!!
- Can I push 600rwhp?
- jba highflow cats xpipe and muffler delete video
- 2010 camaro ss
- Opinions On Texas Speed Headers?
- LS3 and L99 Exhaust compatible?
- LS3 cam conversion for L99
- What Type Of Exhaust
- DT cat back vs. Cherry Bomb Extreme Cat-back.
- gmpp hot cam and heads
- Corroded header bolts
- Firing order
- Flowmaster AMT installed !!!
- Cold Air Intake
- Attitude Adjustment
- Tune?
- Need help
- Injectors
- ADM Scoop or not???
- noise from valvetrain
- Intakes legal in California?
- The process begins ARK Performance DTS!
- borla "S" type / MUFF DEL
- corsa vs borla
- What does a cam install cost? What other stuff do I need?
- Advantages of Cold Air Intake
- bad mileage = more power?
- question
- Hi flow converter cause drone?
- Any one do their own Cam install?
- A question regarding the VR intake !
- Coil Relocation
- Billet fuel rails
- Trying to find a good cylinder Head upgrade
- Four Throttle Blades vs. Only One
- what cam to choose?
- Full bolt on L99 Dyno Numbers
- 2010 2SS M6 cam HP numbers
- compression ratio?
- Headers Arrived!
- quick fuel rail ??
- Axle back came today
- 2012 6.2l Intake differences...??
- Whats my HP????
- Question about own Cam install
- Best Price On Flowmaster 817487 American Thunder Cat-Back Exhaust??
- ADM Scoop difference?!
- Halltech 102
- TSP VVT 3 Being installed Pics...
- Catback exhaust
- Got the Headers on and Tuned
- Would Borla S Type fit a v8 with GM GFX kit?
- Performance Mods needed for 12.5-12.8 ETA?
- Dynomax, good or bad?
- One chamber flowmasters
- Oil Leak questions
- Solo High Flow Cats
- California legal headers?
- Sct ???
- Stock Computer after CAI install
- ADM scoop and warranty
- JBA HF cats. extenders??
- Little 2011 Camaro hack and slash.
- 100 octane fuel
- Upgrades without voiding warranty
- Best deal on Headers and Cats. ?
- Check Engine light!!!
- SOLO EXHAUST
- CAI vs. Rotofab- best sound?
- Catback without drone?
- First $3k in mods?
- SSW 3" Retro VS stock video comparison
- So what does a Magnacharger with a Cog Drive Sound Like Under Load?
- ***Cartek Heads and Cam SS in the 10’s***
- Immediate Help (Which Exhaust)
- Atlanta Area X Pipe?
- adm performance stage 2 blower cam
- Finally a REAL HEADER 50 state Legal from American Racing
- Headers and High Flow Cats
- solo exhaust
- Looking for cam input
- LS3 Polished Intake Manifold
- Borla Touring and drone
- Dynatech 1 7/8 with muffler delete?
- Cats rattling??
- TSP long tube headers installed today!