- Eratic chatter and noise under load from under shifter, Hurst!
- Clutch question
- Clutch shudder
- Motive Gears says no Camaro Gears
- Anyone who has had their aftermarket shifters installed.....
- Scratchy whistle noise from shifter area
- MGW is IN!!! A few install tips too
- 2010 camaro rear end strength???
- Hurst Shifter and Stock Leather Knob?
- Can I get some Lube with that Hurst install?
- AS PROMISED, PIC OF OUR NEW SHORT THROW.
- Installed SLP Skip Shift today and its harder to engage certain gears WHY?
- Why is my left half-shaft smaller than the right ???
- what fluid to use in the speed manual
- Hurst Shifter install pointers
- aftermarket parts for the TR6060
- Will Hurst shifter rod mount to stock linkage?
- what happened with ripshift?
- Tap Shift on the Stick
- Has anyone read this from Hurst?
- rear end problem at the strip?????
- TSB Number?
- Car is at the dealer...
- Hurst vs MTI vs MGW vs ???
- Some thing you can do on your Hurst shifter
- 1000 HP SEVERE DUTY AXLES ????
- Center section bearing cap bolt torque?
- Clutch Question
- Speed In Gears
- Ball, Pistol Grip, T-Bar on an M6 short-throw - thoughts?
- Heads Up - Clutch Spring noise
- Are there any adjustments on the Clutch?
- AY6 clutch problems
- How much is the short throw shifter?
- ATTN: GM LS Motor owners Fidanza Cares :) 1.0 Clutch
- Who is getting gears, when they come out?
- Transmision Output Shaft: Solution for GM
- Tremec shifter->Transmission interface
- INSTALL OF BARTON SHORT THROW SHIFTER
- CLUTCH NOISE ANSWER ....COMPLAIN !!!!
- Who is using a SLP Skip Shift Eliminator
- Transmission conversion
- difference in stabilatrack and competitive mode
- Engine lugging in the Camaro
- I installed both....
- Gforce Engineering 2010 Camaro race axles just about ready for testing
- Trans temp
- L99/V8 Automatic reliability issues with 500 rwhp+
- NEW HD QUALITY UPDATED INSTALL VIDEOS UP FOR MGW SHIFTER>>
- MY M6 SHIFTER PROBLEM
- 6L80 Trans-Brake?
- Strange noise...
- Clutch Question
- Clutch performance???
- PRI Update on Camaro Gears
- Aisin AY6 Trans Issues
- What are your A6 Tranny Temps?
- Lingenfelter Gears
- After Market Hurst Shifter
- Upgrades for the output shaft problem?
- Changing Gears on the L99
- Gear ratio
- 22 hours of ownership NO SECOND GEAR!
- Burnout - clutch instead of tires ?
- m6 transmission shifter pin and locks
- MTI Shifter knob and boot
- Rear End Gear Question
- Hurst Short Throw Shifter
- M6 5th & 6th gear shifts
- SS 6spd tranny failures
- LG Motorsports introduces our new Camaro Short Shifter!
- ATTENTION V6 GUYS WITH BARTON SHORT THROW SHIFTER
- vibration/chatter problem
- Barton Short Throw Shifter (Post-Installation)
- Isolated Clutch Reservoir
- a6 tranny shift properties.
- MGW shifter
- Hurst reviews?
- Is there a Dual Clutch Kit for the V8 6s
- Odd TR6060 problem..
- Installing hurst shifter knob
- Noise From Center Console area (Transmission)?
- IF YOUR ON THE FENCE ABOUT THE BARTON SHORT THROW SHIFTER....
- Just want a round shift knob!
- rear end re gear
- Skip shift eliminator
- MGW shifter review?
- Richmond 4.10 and 3.73 are here!
- Few Barton short shifter install tips....
- MTI shifter installed.... great improvement!
- shift tables for gear swap
- Half Shaft GM part number?
- Hendrix-Engineering aluminum drive shaft in testing
- Hendrix-Engineering gets 2010 camaro!!!
- LS3 Clutch Engagement
- Anyone got a pic of the TR6060 Drain hole?
- SKIP-SHIFT/ BARTON SHORT THROW
- Manual transmission, "grinding" noise?
- V6 auto differential swap to a SS,V6 manual?
- Torque Converters Explained
- Does anyone know of a Locker or improved LSD for the Camaro rear?
- GMPP short throw
- Richmond gears in the works
- YIKES !!! GRINDING FROM 2ND TO 3RD ! any thoughts ??
- Driveline for dragging
- Skip Shift?
- 4.10 Instal?
- AY6 grind, 1st to 2nd...
- Installed my Hurst shifter!!!
- MN6 Clutch ALignment tool?
- ZR1 Twin Disc Clutches now Available for 2010 Camaro!!
- New Aluminum and Carbon Fiber Driveshafts coming soon
- Automatic shifter
- Corvette Knob on Hurst Shifter
- Shifter gate?
- Skip Shift Eliminator
- OK SO YOU LOVE THE MGW SHIFTER BUT WANT THE RETRO LOOK >>>
- Top of 1st gear...
- Rear End Strength
- MTI Racing 2010 Camaro Clutch
- do you think the old school look could work?
- 94 Camaro V6-V8 swap questions
- Hurst Short Throw Shifter
- GM Hurst Shifter vs Hurst Shifter???
- MGW Short Throw Shifter
- Performance Clutch?
- Rear end gears
- mgw retro shift ball assemblies finished... first options look>>
- My NEW Steeda Short throw shifter
- LS3 manual trans fluid change - less noise, etc?
- Drive shaft noises
- hurst question
- *&(ked up transmission/clutch
- Ring & Pinion Swap Out
- Limited Slip Differential question
- AXLES
- New Hurst
- Does the L99/A6 automatic come with an oil cooler ?
- 8 ball shifter adapter Question
- weighted shifter
- PRESS RELEASE-V6 Camaro Shifters from MTI Racing
- 3.73 Gear?
- Transmission noise
- GearCalc
- Ring & Pinion INSTALL KITS.
- Flywheel Torque Specs?
- Hurst shifter questions
- 4:10s, some pictures......
- Locked in First?
- MTI Racing FREE V6 Shifter Install
- Factory Halfshaft PN or EC Changes?
- 1LT half shafts
- MGW OR MTI SHORT THROW SHIFTER?
- Reverse gear location
- If you have a V6M with the Hurst shift
- Will the 2010 Camaro clutch fit a 2002 Trans Am WS6?
- Clunk in 1st gear using tapshift
- Monster Clutches now available for the 2010 Camaro
- Strange/USGear working on 3:73's and 4:10's
- MTI Shifter install?
- Hurst shifter
- Hurst shifter with "T" Handle
- 1 to 4 skip shift?
- Is there a TSB for the clutch sticking?
- Richmond 4.10 impression after first 60 miles.
- Question Involving 4.10 gears & Bushings
- Pfadt Ultralight Shifter development pics!
- MGW vs Barton?
- Auto to 6 speed..o the regret
- Quiet kit for HURST
- drive shaft issues!!!
- NLP / GMHTP Converter Installation Article
- Just Installed My Hurst Short Throw Shifter
- Automatic 6 speed ...
- open differential question
- Axles snapping
- Transmission Cooler
- M6 V6/V8 rear end, whats the difference?
- Stuck Clutch Warranty Work
- Aftermarket Shift Boot
- short throw shifter
- now logging actual line pressure in A6, less than 100psi in 3rd
- Skip Shift Eliminator Question
- Can this be done??
- Muscle car or Not
- deleted post
- Is the M6 shifter supposed to move around so much while driving?
- NEW SS AND RS RETRO KNOBS FOR MGW SHIFTERS!!!!!
- ASAP! How did you M6 Owners refill the Tranny fluid?
- Think I'm going to be SHAFTED
- Pictures of FILL and DRAIN hole on TR6060
- 4.10s and 1/4 mile times ?
- Alternate Transmissions
- Hurst Shifter Issue
- clutch options
- CTS-V rear end?
- Okay blast me if you want
- Quiet kit install?
- 3rd gear release...
- Drivetrain loss?
- can you put posi in the v6 auto?
- SNOW/ICE MADE LINKAGE ON V6 COME OFF?
- The Camaro center section is a direct bolt in for the G8
- CAGS
- Hurst Shifter Installed!!!
- BARTON Flat stick Pic.
- Mantic Performance Clutch Installed
- Pic's of Aftermarket Shift Knob on Stock shifter stalk
- 2011 Camaro gear ratio?
- MGW Short Throw Shifter Installed - Pics
- Anything wrong with using the same Siphon Pump Tranny/Diff?
- My Shifter Review – Factory vs Hurst vs MGW
- Flaming Camaro 5 Ball Shifter
- When is the 4.10 Richmond Gears coming out for the V6???
- Is the V6 auto tranny limited?
- MGW Short throw shifter v6?
- PFADT POLY DIFF BUSHINGS (GEAR WHINING) NOW
- Please no... It's only one day old. Bad tranny or normal break in?
- Damn. What crappy luck.
- Anybody know what this knocking noise is?
- Sport Mode and 1st gear
- Hurst shift knob for the v6 pattern ?
- LSX454 Camaro
- New Black Shift Knob for Hurst Short Throw
- NEW! Katech LS9X clutch for 2010+ Camaro
- Gear choices? 3.90-ish?