View Full Version : Suspension / Brakes / Chassis
- Vibration after lowering
- Loose sway bar link?
- Looking for new Brake set up. CTS-V Fronts?
- Next step? rear drag setup?
- Towing with Camaro?
- Trailing arm Suspension questions
- wheel spacer with coilovers ?
- QA1 double adjustment for the fifth gen??
- Changed my mind.
- stock ls skid pad?
- Anyone have any opionions on these?
- Hotchkis Adjustable Sport Sway Bars vs SS sway bars for 2LT upgrade - Opinions
- Sway bar setting
- Junkyard cts-v calipers
- --Wheel Hop Solution from LG Motorsports--
- Pfadt rear arms installed
- Alignment question for rear FE4 conversion
- NEW ZL1 Sway Bars and 1LE Balance Bar
- ZL1 Sway Bars installed!
- Do my coils look normal?
- any holiday specials on racing brake lightweight rotors?
- Pedders Track II kit
- Hotchkis springs installed today at Haddad Motorsports
- FE4 dampners/shocks on '10 SS?
- V6 SPRING RATE
- Pedders double bearing caster camber plates are just about done!!
- Making the Pedders ZL sway even better
- Should I upgrade to FE6 shocks/struts with my Hotchkis package?
- Adjustable Toe Rod Question
- looking for a good shop in Denver
- Look what the UPS man dropped off today!
- BMR split drop installed
- How to stop my brake pads from making my rims black
- Bleeding Brake Question
- Roll Control/Line Lock Kit
- Right rear locking up under load?
- Lift/Jacking points for the Camaros
- LG Motorsports Camaro G5 Sway Bar Package
- Drag Suspension Tech & Testing: Pfadt coilovers lower Ets and 60's
- thinking about brake upgrade for v6
- How many track days do your rotors last?
- How do the Big Dogs Roll at the Strip
- really quick: BMR or Hotchkis STB?
- Do we actually need front brake dust shields?
- Steering Rack Bushing
- New LCAs
- Pre-Buy Pedders Dual Bearing Camber Plates
- Best brakes for camaros!
- NEED ADVICE, BRAKE PADS
- ALL NEW LSR PERFORMANCE CAMARO BUMPSTEER KIT
- wheel swap
- my Pedders has arrived.....
- Hurst line lock and service stabili track help!!!
- Pfadt ZL Spec Sway Bars Question
- Kami says so long wheel hop!
- Tighten Steering?
- EBC Brake pads?
- Adjustable BMR Arms and Toe Rods Installed
- Pedders Camber Plates and springs
- Wheel hop cure ??
- Rear sways when on throttle
- Hotchkis Track Pack VS. Race Pack Stage 3
- ZL1 back brakes?
- Wheel Offset Changes VS Alighnment Question? Please Help
- wheel spacers
- Do i need an alignment if installing pedders front radius bushings??
- Are SS Brembo brakes all Brembo?
- Bushing removal and installation tool question
- UP GRADING BRAKE FLUID IS IT THAT EASY
- LSR Performance at PBIR autocross
- Sway Bars
- Who paints calipers in Los angeles?
- Brembo bleeder sizes?
- Best Chassis/Suspension setup for the Camaro
- Squeaking Front Brake
- Rear Chassis Brace
- power sport brake roters
- On to handling...help!
- Torque specs for hub bolts
- what to get first?
- Pedders Xa Coilovers Install Help
- BMR?
- 2012 LS3 Vert upgrades
- Removing struts to install hotchkis strut tower brace [cry]
- Am I good to go?
- pfadt, pedders, or eibach suspension?
- LCA
- BMR 2 point Install Clearance Issues - 2010 SS
- Opinion BMR Level 1 vs. Pfadt Stage 2
- Which spring drops more pedders or pfadt
- r1 concept
- I smell something fishy
- Pedders zl1 conversion sway bar end links
- What do i need with drop? Help
- Pedders XA coilovers questions
- Rear sways: ZL1/1LE vs. 2012-2013 1SS/2SS
- BBK Really Necessary? Also...Wilwood's?
- New Suspension goodies.....
- Bumpy ride! What can i do?
- Strut tower brace for early 2011
- Pedders Supercar coilovers, rear ride height
- One Person Brake Bleeder. Questions
- Front lower control arm ?
- Rear Feels Unsettled
- BMR 2 Point STB Installed
- Installed BMR trailing arms, still have wheel hop
- BMR Toe Rods wont fit 12'????
- Suspension upgrades - front or rear first?
- ZL1 Caliper Shields
- lowering the camaro
- Question about lowering springs
- Any MGP caliper install tips?
- ? for Suspension Guru's
- narrow body coilover?
- RUBBER, the enemy! Foundations in suspension
- Ss springs on a v6?
- Brembo Clarification
- Upgrade brake pads on v6?
- Considering eibach sways 2010/RS
- Lowering springs
- Suspension Upgrade
- Anyone who has installed a strut brace
- aftermarket front frame?
- I need a set of rear OEM swaybar brackets
- Need to change my 2LT's brake pads
- Urethane more brittle than rubber?
- Rear bushing help!
- My thoughts on the Camaro rear cradle.
- Need Help With Trailing Arm Bushings
- 2012 V6 Sway Bars
- Fluorescent yellow caliper paint
- Suspension question
- Suspension setup ideas
- Powder Coat Caliper question
- New motor mounts?
- Pfadt ZL-1 spec bars
- Factory struts worn out at 64xxx mi?
- Front ZL1 Bar, What Rear Bar?
- Using caliper paint on brembo calipers
- rear sway bar adjustment advice?
- Suspension work in Oregon
- ENERGY SUSPENSION BUSHINGS
- suspension question
- 2013 Stock Sway Sizes
- Stainless Brake Lines
- My Winter Project
- Finally doing brakes, need help...
- Replacement Rotors
- Pfadt end link washer
- Clanking in rear
- eBay Drilled Rotors? Second Pair of Rotors?
- Slight shudder on take off?
- Used SS calipers, how many miles until I should be worried
- pedders back orders
- BMR lowering spring question
- getting brake bleeder cap off
- Looking to get new Rotors and pads without breaking bank
- Suspension/chassis mods
- hotchkiss stage one suspension kit
- BMR spring question
- No Camber Screws Just Got Me Screwed
- BMR spring?
- Holy brake dust!
- Brake Bleed Procedure.
- Sway bar help!!!
- CTS-V Brakes
- what next?
- Lower spring/1le strut and shock vs..
- ZL1 Toe Links on V6?
- OEM Strut Tower Brace and Adapter
- Ever hear of poly bushings splitting ?
- Upgrading stock suspension comparable to 1LE?
- Brake Dust
- Brake bleed
- Granatelli chassis kit
- Brembo Decals
- 17" weld rts with bmr?
- Annoying squealing sound
- front end suspension makes alot of noise?
- Eibach Pro Kit Lowering Question?
- *Insiders Look* Upcoming Pfadt Featherlight Mag-Ride ZL1 Coilovers...
- Drilled Rotors
- cut springs to lower?
- Eibach sway bar question
- First step?
- Replacing right front/rear lower control arms
- v6 to ss shock and strut switch
- v6 Help
- Powdercoated Calipers - How much to have installed?
- 1" lowering springs
- Lowering springs and stock struts
- v6 to ss suspension ride quality issues
- Pedders Spring Install Help
- Pedders street z pack
- Front Radius Rod Install Help
- Questions for drivers that have solid subframe bushings
- Tech 2 ABS bleed
- Does anybody have these springs?
- Strut Tower Brace
- Need stock shocks/spring diagram
- Looking to get brake rotors from R1 concepts advice
- Anyone know whats up with Pedders lately?
- Cut the V6 rear dust shields?
- is this normal
- Brake Lines
- Anyone order Rotors from Brake Performance
- BMR level 2 package ?
- ** Best Brake Pads **
- Strut Tower Brace
- Eibach ewwww to buy or not to buy
- New Pedder's Suspension and CTSV Brake upgrades
- Question on SS brakes and HP
- Brembo caliper part #'s
- strut mounting bolts did not settle down
- Stuff on order.
- Traction issues was a bushing issue !
- Swaying After Pedders Xa Install
- Break squeak
- Lowering Spring Installation
- V6 suspension upgrade question
- Sways or wait
- Are the 1LE brakes worth the upgrade.
- Brake Pads
- Pedders and T and T Performance
- Pfadt Rear Trailing Arm Coating Peeling
- BMR toe rods
- Pfadt Camaro Alignment Recommendations
- V6 Brake upgrade
- Install new racing brake lines help
- Strut Tower Brace
- Ride Height After Pedders Xa
- steering problem need advice / help
- zl-1 sways
- Alignment after bushing timimg?
- new sway bar time front bar broke.
- ZL1 sway bar on a 2012 45th SS?
- Red or blue loctite for subframe bolts?
- Brake question
- GM says brakes squeak
- Bushing Company I never heard of
- Poor pedders steering rack bushing fit
- Lowering Car with help of control or trailing arms?
- Drag racing wheel hop
- scraping noise as wheels rotate
- Anyone have a DIY to change v6 rotors and pads?
- Race stars ?
- new to 5th gens, which suspension components aid in better 60's?
- Break pad recommendations
- PLEASE help me decide on lowering springs!
- How do I make my camaro ss handle better??
vBulletin® v3.8.9 Beta 4, Copyright ©2000-2024, vBulletin Solutions, Inc.