Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Lethal Racing
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > ShadoChaser

Conversation Between ShadoChaser and Z28COP
Showing Visitor Messages 1 to 2 of 2
  1. ShadoChaser
    03-28-2010 11:24 AM
    ShadoChaser
    All I had to do was Disconnect the Battery (I let it sit like that for a about 20-30 Min). and then I followed techsupport's thread about installing the buttons

    The most nervous part for me was removing the air-bag. be very careful, because the wires aren't that long and if you tug too hard on them, it could break the SIR Coil (Clock Spring).

    Before you start removing the wheel, make sure you keep the column locked (I didn't even put the key in my column until it was done).

    After that I needed a T45 Torx Drive for my socket set, and just removed the steering wheel bolt that holds it to the column. With just a little pulling pressure, the wheel came off.

    Reinstall was just the reverse of removing in. The Torque Spec on the Steering bolt is 22ft-lbs.

    I hope that helps.
  2. Z28COP
    03-28-2010 10:53 AM
    Z28COP
    Hey, I got a 2SS steering wheel of ebay that was brand new, what does it entail. so i know thanks

All times are GMT -5. The time now is 10:59 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.