Thanks for the link John! Got a few things going on with it right now, think I'm leaning toward the JBA shortie headers for it next..still trying to decide. I'm putting on the MRT2 exhaust this weekend and the gauge pack is on it's way, should have it this weekend as well - all top secret of course! Thanks for lookin out.
My Camaro was in the GM booth at SEMA, was my 35th car at the show since '96. I also had a Lincoln in the Ford booth. I did see pictures of that car on-line somewhere. I did not take any pictures of it. Nice car.
I ordered them from www.sfxperformance.com. Part ALS96118K for front and back. They are black powdered coated billet with a grooved border, they also have polished billet. Cost was $49 for the pair plus shipping ($34 + S&H if bought seperately). I masked them off and took the paint down to metal in the border then painted them with Chevy orange engine paint (I have IOM rally stripes) and clear coated the orange. If I were to do it again I don't think I would remove the paint with my dremel tool. I'd just mask and paint over the powder coat in the groove. That green auto masking tape is the key, very true edges, I got mine at Napa. My current avitar is the front one. I have since redone the rear one with IOM touch up paint and it looks a lot better, so I'll re-do the front one soon too.