dabozz88 |
08-04-2017 11:10 AM |
Installed. Need load resistor harness before I say it's complete though.
Its a harder install than I expected because it's mostly gluing everything into place with silicone sealant. If that ever fails, I think I'll probably build a more 'bolt on' style frame to attach everything with. Cutting was ok. Getting the lights in and out was ok. The main problem I had was that the connector from the 'bulb' plug side to the LED board wasn't staying in properly, and would fall out. Easily fixed with a dab of silicone sealant on the latch/clip that was supposed to hold it in place.
I'm worried about long term having the silicone hold everything (including the bottom LED strip, because that was falling off when I got them), and DOT requirements, but they look great. Here's a vid of them, though its through a crappy iphone camera so it may not be the best quality. But they do look sweet.
https://youtu.be/o_kd_b3MSso
|