ARH and Borla Exhaust
 

So been doing some research on different exhaust setups thanks to the Exhaust Compilation. Found one setup that I'm really impressed with. This car has LT ARH with HF cats and X pipe. I checked online and all these components are sold together for around 1500. The rest of the exhaust is the Borla S type. Question I have is this. Should I only need to get the axle back portion of the borla S type to fit the ARH LT's, HF cats and Xpipe or will I still need to get the full catback system for the Borla part. Help and advice is greatly appreciated. Here is a video of what it will sound like. Low muscle roar with a bit of rasp and plenty loud enough.

2010 Camaro with ARH headers and Borla S exhaust - YouTube

You only need the axle back if you get the x pipe with the arh setup buying a cat back is pretty much buying a axle back with an x pipe

Love that setup.. You should also check out the full ARH EXHAUST.. I'll post a link to my vid

http://www.camaro5.com/forums/showthread.php?t=194362

It's camd but at the end I give it a rev. Sounds killer when driving

So this is all I would need to purchase?
CA201078W/C or CA201078N/C (i have no emissions law so should i run no cats or HF cats option?)

Borla Part Number: 11775

this :happyanim:

check out my full ARH system. it was windy when i took the video.

http://www.camaro5.com/forums/showthread.php?t=189548

Sounds good! But I think I've found the setup I'm going with :D.

a much better video/sound quality

http://www.camaro5.com/forums/showth...78#post4324278