which engine oil did you guys use during break in?
About to reach the 300 mile mark on my car, which engine oils did u guys use or recommend to the 1500 mile mark and after?
|
Conventional is better than synthetic during break in because it will help remove any deposits/debris from the engine. After break in switch, to a full synthetic such as Amsoil.
|
Seeing that he's brand new from the factory, he's already got synthetic in it now.
OP: If you're going to remain stock, or mostly stock for a little while, just use what GM recommends. In 2010 is was Mobil 1, not sure what they recommend now. As long as you use a good synthetic and use the same weight, you should be good to go. If you start adding a LOT of HP, you may consider switching to a specific brand for various reasons. |
Full syn wont allow the rings to seat properly....I would drain and run a good conventional like mikey states, then at 1400 change to a good premium full syn. Not M1 as it is not as good as say Castrol Edge, or up to Amsoil for top grade.
I still stay clear of RP due to past bad experiances, but many have good luck w/it. :thumbsup: |
@ SC1250 Im already running the shell rotella u advised me :) just checking for the next steps what the other drivers have experienced.
|
Quote:
|
The car came new with Mobil 1
It says to use Mobil 1 on the filler cap. ? This is on a SS not sure on the six |
All times are GMT -5. The time now is 02:39 PM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.