"The Grey Eagle" Monstertodd's SS build
 

I picked up my CGM 2SS/RS M6 with SIM stripes on November 23rd 2009.

I purchased my car from Jimmy Johnson Chevrolet in San Diego, CA.
It was a dealer transfer car that was originally ordered by a dealership in New York.

It is VIN: 40196. It has the GM badges of excellence, as well as the GM performance division badge under the hood. It does not have back up sensors.

Here are some pictures from the day I picked her up. enjoy.

http://www.camaro5.com/forums/pictur...ictureid=12312
http://www.camaro5.com/forums/pictur...ictureid=12315
http://www.camaro5.com/forums/pictur...ictureid=12314
http://www.camaro5.com/forums/pictur...ictureid=12313

I've already modified the car somewhat. My first mod was a skip shift eliminator that I bought on Ebay. It's not an SLP unit. I haven't had ANY trouble from it, and it's worked flawlessly. No pictures of the install though sorry. I think I paid $12.95 plus shipping.

I'm not planning to do any serious drive train or engine mods, but I do have a laundry list of items I'd like to replace. It's going to be one thing at a time with this car though.

Here are a couple of smaller mods that I have performed thus far.

DIY foglight mod for RS equipped cars.

http://www.camaro5.com/forums/pictur...ictureid=14964

http://www.camaro5.com/forums/pictur...ictureid=14963

To be honest with you, I'm not real impressed with the light output of the fogs after this mod. I used the DIY method which involved soldering zener diodes in-line with the wire harness for the foglights. I'm seriously considering reversing this mod, and purchasing one of the plug and play harnesses.

I had SLP SS emblems on my front and rear, removed them and replaced them with Trailblazer SS logo's, and then finally removed those and installed Sparks Restoration SS logo's. Yes I know, they are ridiculously expensive, but in my opinion, completely worth it.

GM painted heritage grill

http://www.camaro5.com/forums/pictur...ictureid=67255

Sparks Restoration SS emblems

http://www.camaro5.com/forums/pictur...ictureid=67254

http://www.camaro5.com/forums/pictur...ictureid=67253

Fuzzy Dice Mod
 

Here is one of the most important modifications to date:

The Fuzzy Dice Mod

http://www.camaro5.com/forums/pictur...ictureid=23018

Barton short throw shifter with brushed aluminum knob

http://www.camaro5.com/forums/pictur...ictureid=35206

http://www.camaro5.com/forums/pictur...ictureid=35205

Lingenfelter aluminum racing pedals. These look rad!

http://www.camaro5.com/forums/pictur...ictureid=35229

http://www.camaro5.com/forums/pictur...ictureid=38802

http://www.camaro5.com/forums/pictur...ictureid=38801

http://www.camaro5.com/forums/pictur...ictureid=38800

http://www.camaro5.com/forums/pictur...ictureid=38799

http://www.camaro5.com/forums/pictur...ictureid=60838

The picture above shows my car prior to installing my Pfadt say bars and lowering springs. The pic below is after the install.

http://www.camaro5.com/forums/pictur...ictureid=67251

Added an MPD1 spoiler. Looks great but I can't wait to extend my stripes.

http://www.camaro5.com/forums/pictur...ictureid=67242

Going on the Dyno

http://www.camaro5.com/forums/pictur...ictureid=67240

Here you can see my new Pfadt Sway bars and lowering springs

http://www.camaro5.com/forums/pictur...ictureid=67241

Turning 10,000 miles. :D

The silver stripes look sharp! I was torn between black and silver, but went the black route on my car. Looks like I couldn't have gone wrong either way!

Looks cool like the stripes with the gray

Hahaha, love the old school dice...

Any new updates to report?

ima get a pair of dice...that looks MAD BOSS! no lie! lmao

Awesome CGM!

None yet, all mods are on hold until I return from Afghanistan in September.

Although, I have put in my order with mike the powder-coater for my brake calipers. I think I'm going to add some red stainless braided brake lines in there as well. And perhaps some slotted rotors at some point.

Posted some new mods in post #3!!!!

New mods in post #4.

I love my car!