1 Attachment(s)
As promised, here is a shot of the full, 40" length driven by an LED on each end.
|
Quote:
|
:word:
|
Okay! :thumbup:
To clarify, due to the dimming seen in the middle of longer lengths, the solid stripe changes to a tuned pattern for better light distribution. I have asked for the length at which this change occurs. We may end up stocking a version that can be cut down into "short" pieces along with specific lengths for other applications. |
I don't see any dimming in this pic, that's why I want it. Is that the full 40" pictured?
|
Heh, yes, that is what I posted.
|
I know that since these have to be cut equally that they arent usable for the dash but would these need to also be cut down for the doors or are they ok as is?
|
Hmm. I'm not yet sure about the length that is required for the doors. I'll check on this and report back!
|
PM me with a cost on enough pipe to do the dash and doors? LEDs available?
Shipped to 93611 |
Quote:
Sent from my SPH-D710 using Tapatalk |
so the pipe actually isn't 100% the same all the way across?
|
Quote:
|
Quote:
|
Quote:
Hopefully we'll be able to buy it just the right size without any concerns. |
It's looking like the best thing is to have specific lengths made for each location and a separate version for modders that can be cut anywhere.
|
Quote:
Quote:
Quote:
We can supply actual GM LED harnesses, or, our own version. |
Quote:
|
Since the brightness fades along the length of the light pipe, is it possible to install it with the LED on the passenger side so that whole long strip across the dash can be pretty equally bright and then when it reaches the drivers side it fades off? To me the pass side should be brightest since more light will come from there.
|
Quote:
|
Quote:
We are currently looking at other LED/pipe coupling solutions as the common vinyl-tubing is very tight. |
Sounds great! :popcorn:
|
FYI, it looks like the stock setup for the doors would need 26.25" of flex pipe each. If you used two 40" pieces, you would have four pieces that were 6.5" left over for other things.
|
Before we send these back, is there anyone else that is interested in doing something with these besides the dash? Again, what we have are 40" rigid and flex pipes that are great for applications where about 27-40" can be used. Note that the stock 2LT/SS doors use about 26".
|
Ill wait for pipes that can be used as is and not have to worry about cutting it.
|
i would like to do something in the headliner i have some ideas pm me a price
|
All times are GMT -5. The time now is 05:14 PM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.