Black Ice port matching tool question
I saw on some instructions on the site that you can use a dremel or similar tool to port match the heads to the black ice-olator. Does anyone know the correct grit of sandpaper to use to do this? Thanks for the info!
Ben |
I used my dremel tool, using the little round sand paper discs that came with the kit. Only removing a small amount of aluminum. Not to hard to do.
|
Cool, I wasn't sure how hard that stuff was to sand down.
|
80-100 grit works nicely. :nod:
|
All times are GMT -5. The time now is 12:06 AM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.