Pfadt Race Engineering Strut Tower Braces At Apex Motorsports!!!!
Take your Camaro's handling to the next level with a Pfadt Strut Tower Brace from Apex Motorsports, Camaro5s number one Pfadt retailer.
The Pfadt Camaro Strut Tower Brace is the perfect way to increase the rigidity of the 2010 Camaro chassis. The strut towers see a tremendous load even during street use and can easily deflect 3mm when pulling out of your driveway. During track use this deflection is even more drastic and can lead to handling issues that are hard to predict and resolve.
The Pfadt Camaro Strut Tower Brace is designed to bridge the gap between the two strut towers, bracing them together and increasing chassis rigidity. This increase in rigidity can be felt in the increase in steering feel and response. Pfadt's twin braced tube design allows our strut tower brace to not only keep the strut tower braces pulling in and out but also keep them from twisting. This is a substantial improvement from two point braces. Pfadt's strut tower brace is also designed to take a direct path over the engine between the strut towers to further increase the braces effectiveness.
You have the option to order the strut tower brace in a durable black powder coat that matches the engine cover or have the brace shipped bare if you would like to have it custom painted to match your car. Made in the USA, we include all of the hardware and a rivnut install tool for a complete system.
This brace is designed for normally aspirated cars and a version that will accommodate Magnuson and Edelbrock superchargers is in the works.
Get your order in before 4PM EST Friday and beat the weekend shipping lull!
Apex Motorsports
08-20-2010 12:13 PM
There is still a little bit of time to get your order out before the weekend.
Apex Motorsports
08-22-2010 07:25 PM
Thanks for the weekend orders Camaro5!
CamaroDreams07
08-26-2010 10:38 AM
Hey- question. Do these fit on the V6 cars without any modifications? I swear I asked Pfadt and they said it didn't, but then I just saw a picture of one, so I'm confused.
Can you shoot me a PM about this?
Thanks.
Apex Motorsports
08-26-2010 11:48 AM
Quote:
Originally Posted by CamaroDreams07
(Post 2263504)
Hey- question. Do these fit on the V6 cars without any modifications? I swear I asked Pfadt and they said it didn't, but then I just saw a picture of one, so I'm confused.
Can you shoot me a PM about this?
Thanks.
The strut tower brace does work on the V6. I just verified this with Pfadt.
SS Mike
08-30-2010 05:58 PM
I've got a question, does this strut tower brace work with Vortech superchargers? I remember talking with hotchkiss about theirs, we even test fitted it and it didn't work. I don't think any of the 4 points do. Just figured I'd check though. Thanks!
-Mike
Apex Motorsports
08-30-2010 06:15 PM
Quote:
Originally Posted by SS Mike
(Post 2278670)
I've got a question, does this strut tower brace work with Vortech superchargers? I remember talking with hotchkiss about theirs, we even test fitted it and it didn't work. I don't think any of the 4 points do. Just figured I'd check though. Thanks!
-Mike
It wasn't designed to work with any of the supercharger systems, however, if you use a couple of washers as spacers it will work with a Maggie. I think the intake tube on the Vortech system is going to limit you to a two point like this one from BMR.