little help with whipple hose routing
 

Hey guys I got my whipple all installed except for the air bleed hose. The instructions were a little confusing with where it goes. I have it routed behind the ecm but I can't figure out what hose they want me to connect it to. Can somebody post a pic of how they have it connected.

Also does it matter how the IAT wires are mounted to the new connector. It didn't say which one goes where in the instructions.

Thanks for your help!

The IAT wiring doesn't matter. Take pins d and e from the factory harness and put them in the two pin connector supplied. The sensor will work with the wires in either position. The bleed line should go from the crossover tube at the front of the engine to the factory bleed line coming from the radiator filler neck. You connect the line with a brass barb and two clamps. Just keep the hose away from any moving parts.

If you look at my engine bay pics in my profile, you can see the hose coming out from behind the tensioner then following the reservoir tank line to the core support. I just tried to make it look as neat as possible. If you need a better pic let me know and I'll go take one.

I can't really see it to well in your pic, could you post a larger pic please. Thanks for the help I appreciate it