Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com

Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com (https://www.camaro5.com/forums/index.php)
-   Tuning / Diagnostics -- engine and transmission (https://www.camaro5.com/forums/forumdisplay.php?f=73)
-   -   off the cuff wideband testing by Tampa Tuning (https://www.camaro5.com/forums/showthread.php?t=251169)

Tampa Tuning 09-20-2012 06:40 AM

off the cuff wideband testing by Tampa Tuning
 
Recently, I needed to calibrate a shops wideband to determine if it was reading properly because the reading it was showing was leaner than I was showing on my widebands. No offical under the best conditional, but off the cuff test for my curiousity.

So to make a long story short, and although not the best application for testing, I had a little extra down time between tunes so it was time to play on my partners C6.

I plugged them all into one exhaust with seperate tail clamps while dyno my partners C6

My LM-1
My NGK
Partners FAST
Shops dynojet

The NGK provided the fastest reading in either directions with more stability. Great unit for $250 buck, but the sensor cost around $150s to replace.

The LM1 provided about the same AFR number, but slightly longer to reach the numbers that the NGK reached. good unit. $250 bucks and about $50 bucks per sensor which seem to last me about three months it best.

Friends FAST under read (richer) than the LM1 and NGK. Not mine so I dont know cost.

Shops dyno jet crapped out from a loose wire just by chance and a replacement sensor was ordered, but in the past had read leaner than my LM1which was pretty much inline with the NGK, but slightly slower to respond.

So my experience was NGK won hands down with better reaction time and stability through the runs.
The LM1 which uses the same 3737 sensor as the LC1, not a bad unit but lost to the NGK hand down.
I had a LM2 and hated it. Sold it and bought the NGK.

I always keep two widebands and two sensors with me if needed.

www.TampaTuning.com
Phil

JANNETTYRACING 09-21-2012 02:16 PM

You might try these 2 options for accuracy.

I use 2 of these Laboratory grade sensors for tuning, 1 for each bank, the replacement sensors are 450.00 each and are calibration able, I check them before each dyno session but they rarely need any adjustment.

http://www.ecm-co.com/product.asp?a1000

Another quality option is this

http://www.horiba.com/automotive-tes...ls/ld-700-863/

Tampa Tuning 09-21-2012 04:03 PM

Tampa Orlando Tuning Camaro Corvette CTS-v GTO GM Trucks performance tuning
 
kind of impractical because I doubt many guys have them installed in their cars, so what was tested during a little down time was the more popular widebands most guys buy that we had around that day.

www.TampaTuning.com
Phil

JANNETTYRACING 09-21-2012 04:15 PM

Quote:

Originally Posted by Tampa Tuning (Post 5604744)
kind of impractical because I doubt many guys have them installed in their cars, so what was tested during a little down time was the more popular widebands most guys buy that we had around that day.

www.TampaTuning.com
Phil

Ahh, Good write up.


All times are GMT -5. The time now is 11:45 PM.

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.