Wiring diagram for turning signal lights.
 

I was doing the led behind the mirror lights mod to be used as a turn signal and the driver side turned out good and its still working, but when i tapped into the passenger side front turn signal all my lights inside the car started flashing and then the car and lights wouldnt turn on for about 4 hours. Does anyone have a diagram or know what wire to tap into for the signal lights(hot wire and ground) cuz now i am scared of actually doing it without actually knowing for sure this wont happen again, pictures would be good if you have them. Thanks:mad0259:

Do you mean the front and do you have a RS car.

yes the front signal lights and no i have a LS model

See if this will help....

okay so when i tap into the right turning signal light i noticed that the lights was flashing faster than usual, this also happen before the car had that problem above. What does it mean if its flashing faster than usual/?

You need a resistor, the car is thinking you have a turn signal bulb out!

Take a look at this http://www.automotivelightstore.com/...er50w6ohm.aspx

@C_LOW29 you kind of gave me a idea and it worked lol i was testing the lights with the connector not plugged into the actual bulb so basically the car thought it was out. But after testing it a couple times with the LED on the mirror and the connector plugged in it work like a champ lol. Sometimes you miss the simple picture but thank everyone for the help. Will post pictures soon.

Check out this thread.

http://www.camaro5.com/forums/showthread.php?t=96213


Sent from my iPhone using Tapatalk