Halo Super Cars Strut Tower Brace
 

http://farm8.staticflickr.com/7126/7...c38feb11_b.jpg
We are pleased to introduce our new Halo Super Cars strut tower brace. This dual 11ga. heavy wall tube brace is fully TIG welded to CNC cut brackets and includes CNC machined tower caps. They come powdercoated gloss black or are available in raw steel if you want to have them painted to match.
http://farm8.staticflickr.com/7192/6...ed7c5489_b.jpg

3 bolts on top and 1 in each tower side is all it takes to mount this brace in, while still giving you the ability to remove the brace without having to remove your struts.
http://farm8.staticflickr.com/7138/7...7eb19f8d_b.jpg

Unlike most braces, this will fit ALL model years 2010+ and both V6 & V8!
http://farm9.staticflickr.com/8157/7...b1ab8938_b.jpg

Place your order HERE for the Camaro5 intro price of $259+ shipping($239 for raw steel) for the month of August! Just enter "Camaro5 intro price" in the order notes and your price will be adjusted when processed.

Only a couple weeks left for the intro pricing

Straight across design looks rigid... bump

damn looks awesome, may have to get one

How much clearance is there between the brace and the v6 engine? I ask because I have a 1inch manifold insulator as well as a 10mm plenum spacer.

Thanks guys, we tried to design something that was extremly strong and looked great at the same time.

I don't have an exact measurement on the V6 off hand, but will try and get one, but I'm pretty sure there's around 1.5 inches.

I would appreciate that, those 2 pieces take up 1.38 inches. Also, I would not have engine cover on. Could you measure without the engine cover. Thanks.

Ah, you're definitely safe then, it's about 1.5" to the cover, and it's mainly on the outer edges where it gets closest to the bar. I'll still see if we can't get a V6 to measure.

I have a 2011. the factory holes should match up perfectly with this right?
btw i love this design..i've been looking around for a strut tower brace but i've never found one that i liked until now

No it does not match the factory holes. It just requires 3 holes to be drilled on top and 1 in the side of each tower, not hard to install at all.

Could you take a picture of the installed brace head on from the front of the engine bay. I just want to visually see the clearance since it will be a tight fit. Thanks.

pm info please, looks great!

Still trying to get a V6 back in here to check it on. Will let you know as soon as we do.

PM Sent

Also, just finished our Trans Tunnel Brace that will also allow you to run a 3" exhaust with plenty of room and still plenty of ground clearance.
http://farm9.staticflickr.com/8456/7...95a0d246_b.jpg

Tested on our car with air ride suspension to ensure even the lowest of cars won't have an issue.
http://farm9.staticflickr.com/8461/7...d16ea0b4_b.jpg


Normal price is $89+ shipping but for a limited time, we'll be offering a Camaro5 intro price of $75 shipped.

Place your order here.

Just put "Camaro5 intro price $75" in the order notes, and we'll make the adjustment when processing your order.