DIY: Retrofit 2012 camaro dash into a 2010 car.
 

hey guys soo last week i found a wrecked 2012 camaro with 6 miles on it......the car fell off a rail carrier....anyways i bought the dash out of it and the spedo cluster. I like how they made the 2012 interior with the leather on the dash......I want to add this dash into my car with a HUD (supplied by ofer)
My car is sitting at the dealer it has a bcm issuse because i wired something there (leason learned DO NOT WIRE ANYTHING TO BCM3 DASH PANEL)......here are some pics of the 2012 dash

2012 DASH PART # (Dash only) #92242674
HUD PART #92205982
HUD SWITCH#92224604
HUD TRIM#92227455
5 BOLTS FOR HUD#11609465
HARNESS FROM OFER http://www.gen5diy.com/index.php?rou...&product_id=52
SUEDE INSERT PASS SIDE#22880755
DRIVERS SIDE INSERT#22757136
Center outlet vent- #20965303
Passenger leather insert with orange stching- #22880758
Driver leather insert with orange stiching - #22838803

You can buy diffrent color inserts see dealer for that information

It's not that bad. Bunch of screws and such, but the dash literally just pops in and out of place after they're all out.

if you dont mind me asking, how much was it was the dash?
And was the motor for sale?

should have gotten the hud unit out of the donor as well

He did get it with the dash, only the harness is coming from me.

there is a small harness in there near the hud its about 4inch........i paid 250.00 enigne is totaled i think

Nice Richie, can't wait to see finished pics

well when i get my car back i will......dealer just called said there are 54 bad codes in the bcm.....and 4 in the ecm......all of them are lighting...not covered under warranty :( soo i dont even want to think about how much its going to cost me

ouch. maybe it's just a fuse that blew. When I blew my reverse solenoid fuse it tripped like 7 codes.

great upgrade and that 2012 camaro does look awesome hopefully you can make a sticky out of this and ill go back to it later to upgrade my 2010 das to the 2012 :thumbup:

i checked all of the fuses they were fine......what happen was i had a switch powered to bcm3 for my strobes and it sparked...i replaced the fuse with a good one and still the car wasnt acting right. i just want my car back and the bill to be under 500 and then im taking all my lights off or wiring them to a place where it wont give me issues

That will not work, you dont have the rest of the wires built in to the main dash harness.

does anyone have a pic of where the airbag goes in?

ritchie sorry to hear about your car.... hope its gets fixed soon for not too much.... :thumbup: I dont know what the BCM3 is or how you wired the car.. :iono: :popcorn: