DMH Electric Cutouts Poor customer service...!!!!
Ok does anyone have these cut outs or hv had
The pleasure of dealing with the customer service Reguarding shipping new or warranty parts because Ive got a set of the E cutouts and they wk great but The set i have for some readon the motors were loose To the point where i could hear them while cruising on Te frwy (very annoying)!!! Any whooo so i called dmh And spoke to the guy there and he says yeah i got a Batch of motors i know about it and ill take care of it And send u some new ones you should get em in a wk THAT WAS 6 MONTHS AGO!! And counting so does anyone Know of another place that makes the low profile electric cutouts Tnks....:mad0260: |
|
I have the dmh Dual oval low profile cutouts and I sent him mine on July 9th still haven't received it!
|
I had them on my 01Z28 1st set died, the second set died after 6 months they sent me a replacement I then sold it I did not wanto deal with them anymore.
|
WOW......I have had them on my car for almost 2 years. The first set burned up rather quickly...about 2 months......I contacted the vendor I purchased them from and who installed them.
A replacement set was sent to me rather quickly and since they were replaced I have not had one single issue with them....:iono: |
Quote:
And make a lot of noise its annoying as hell..to drive around n listen to dat:mad0260: |
Quote:
|
I guess I got a good set cause mine work and don't rattle at all....You may can tighten the screws that hold the motor on to help your situation.
|
Quote:
A bad set of motors and he would take care of the situation Thats been months now so im gonna check out this other company That makes them now... |
Quote:
|
I think I have posted twice about them already, I have some of there cutouts and i was trying to get a hold of DMH for about 2 months now and no answer.
|
Quote:
Full half the time.... They prob dnt even reply to vm Anyways prob just delete em all....:paddle: whats wrong with The ones u have? |
Quote:
Ive had with them so they dnt hv to deal with all dat bs... |
Quote:
|
All times are GMT -5. The time now is 02:47 PM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.