Hammerhead Housing
Anybody put one in their ZL1 yet?
|
now sure anybody had moded far enough to need it yet. stock zl1 diff is almost a 10" ring gear.
|
I was thinking the limited gear ratio availabilty for the 9.9" would justify the install.
|
Interesting question. Would it even fit? Also you would lose the diff cooler and the ZL1 chunk is iron Vs aluminum for the hammerhead. I wonder if it is weaker or stronger? I would assume it would be lighter but how much? I have yet to hear about someone breaking a ZL1 rear even with a ton more power and slicks. A better question would be is anyone developing additional gear sets for the ZL1 rear.
:pop2: |
Quote:
basically for the cost of this housing and gearing you can make the car have enough power not to need the swap ha ha. |
Quote:
|
All times are GMT -5. The time now is 07:51 AM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.