Kooks Custom Headers Cruise-in and Dyno Shootout
 

Had a blast at the Kooks Facility event in Statesville, NC today. Alot of nice cars and a whole lot of horsepower! Good to see CamaroFreak and Blade again. Dyno numbers looked good considering it was 90 degrees with 44% humidity.... My L99 with Airaid CAI, Kooks LT Headers, Magnaflow Competition Catback and Diablo(*******) Custom Tune yielded
356 RWHP and 373 Torque.
The Dyno crew forgot to turn off traction and stability control before the pulls(threw service stabiltrack and ABS codes after requiring a quick reflash in the parking lot to reset) but i dont think it would have changed the numbers very much. My initial pull yielded 367 rwhp but the sensor for torque malfunctioned and didnt give a number.
Thanks to Kooks and ProDyno for hosting the event.
Video of my pulls:
http://www.youtube.com/watch?v=eCnz6Aho5RI

Video of Blades pull:
http://www.youtube.com/watch?v=Q4EBIBQmgAI

Pics:
http://s781.photobucket.com/albums/yy93/ukalumni93/Kooks%20Custom%20Headers%201st%20Annual%20Dyno%20S hootout/

Enjoy.

Noice! Thanks for taking the video. I think that heat and humidity affected the numbers a lot today. I wanna see what I get during like the fall.

BTW...........my Stabilitrak alerts come on after each dyno too. But they go away after I drive a couple miles.

ditto. I was told that this is the norm

Maybe we can setup another meet and greet in the Fall and get a group rate to Dyno. I will have my SLP UDP installed by next weekend(when I can find the time). It looks good sitting on the counter but will look even better under the hood. I intended to have it on for todays event but was under the weather and didn't really feel like fooling with it. HP increase from it not enough to be immensely noticeable but every little bit helps.

:thumbup:

Any ideas on the difference in HP and Torque. ST and TC- on vs off? Negligible?

Enjoyed it today man. Yours and Blade's cars did very good. I think I am going to check into getting a tune for mine. Then we can get together again for a Dyno Day this fall, when its not a 100 degrees outside. LOL We need to all start getting together regularly. Talk at cha soon.

Here's a nice read for you. http://www.kennebell.net/techinfo/ge...tVariables.pdf

Hope that helps.