Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com

Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com (http://www.camaro5.com/forums/index.php)
-   Camaro DIY & HOW-TO instructions & discussions (http://www.camaro5.com/forums/forumdisplay.php?f=67)
-   -   DIY: Retrofit 2012 camaro dash into a 2010 car. (http://www.camaro5.com/forums/showthread.php?t=235214)

camaro2lt 07-04-2012 10:37 PM

DIY: Retrofit 2012 camaro dash into a 2010 car.
 
5 Attachment(s)
hey guys soo last week i found a wrecked 2012 camaro with 6 miles on it......the car fell off a rail carrier....anyways i bought the dash out of it and the spedo cluster. I like how they made the 2012 interior with the leather on the dash......I want to add this dash into my car with a HUD (supplied by ofer)
My car is sitting at the dealer it has a bcm issuse because i wired something there (leason learned DO NOT WIRE ANYTHING TO BCM3 DASH PANEL)......here are some pics of the 2012 dash

2012 DASH PART # (Dash only) #92242674
HUD PART #92205982
HUD SWITCH#92224604
HUD TRIM#92227455
5 BOLTS FOR HUD#11609465
HARNESS FROM OFER http://www.gen5diy.com/index.php?rou...&product_id=52
SUEDE INSERT PASS SIDE#22880755
DRIVERS SIDE INSERT#22757136
Center outlet vent- #20965303
Passenger leather insert with orange stching- #22880758
Driver leather insert with orange stiching - #22838803

You can buy diffrent color inserts see dealer for that information

pouncer72 07-05-2012 12:41 AM

It's not that bad. Bunch of screws and such, but the dash literally just pops in and out of place after they're all out.

TJ91 07-05-2012 09:06 AM

if you dont mind me asking, how much was it was the dash?
And was the motor for sale?

justa25thTA 07-05-2012 10:12 AM

should have gotten the hud unit out of the donor as well

2SSRS@Gen5diy 07-05-2012 10:35 AM

He did get it with the dash, only the harness is coming from me.

camaro2lt 07-05-2012 10:37 AM

there is a small harness in there near the hud its about 4inch........i paid 250.00 enigne is totaled i think

The Stig 07-05-2012 10:55 AM

Nice Richie, can't wait to see finished pics

camaro2lt 07-05-2012 11:01 AM

Quote:

Originally Posted by stieger (Post 5239980)
Nice Richie, can't wait to see finished pics

well when i get my car back i will......dealer just called said there are 54 bad codes in the bcm.....and 4 in the ecm......all of them are lighting...not covered under warranty :( soo i dont even want to think about how much its going to cost me

The Stig 07-05-2012 11:02 AM

ouch. maybe it's just a fuse that blew. When I blew my reverse solenoid fuse it tripped like 7 codes.

MAXRS 07-05-2012 11:02 AM

great upgrade and that 2012 camaro does look awesome hopefully you can make a sticky out of this and ill go back to it later to upgrade my 2010 das to the 2012 :thumbup:

camaro2lt 07-05-2012 11:06 AM

Quote:

Originally Posted by stieger (Post 5240041)
ouch. maybe it's just a fuse that blew. When I blew my reverse solenoid fuse it tripped like 7 codes.

i checked all of the fuses they were fine......what happen was i had a switch powered to bcm3 for my strobes and it sparked...i replaced the fuse with a good one and still the car wasnt acting right. i just want my car back and the bill to be under 500 and then im taking all my lights off or wiring them to a place where it wont give me issues

2SSRS@Gen5diy 07-05-2012 11:31 AM

Quote:

Originally Posted by camaro2lt (Post 5239885)
there is a small harness in there near the hud its about 4inch........i paid 250.00 enigne is totaled i think

That will not work, you dont have the rest of the wires built in to the main dash harness.

camaro2lt 07-05-2012 09:01 PM

does anyone have a pic of where the airbag goes in?

MARINE1991 07-05-2012 09:08 PM

ritchie sorry to hear about your car.... hope its gets fixed soon for not too much.... :thumbup: I dont know what the BCM3 is or how you wired the car.. :iono: :popcorn:

camaro2lt 07-05-2012 09:17 PM

Quote:

Originally Posted by MARINE1991 (Post 5243193)
ritchie sorry to hear about your car.... hope its gets fixed soon for not too much.... :thumbup: I dont know what the BCM3 is or how you wired the car.. :iono: :popcorn:


DAVE welcome back!!!! well me and a friend that does strobes for living wired it........went to the dealer when they were closing and my fascia was on the concrete floor and has nice sctraches on it:facepalm::mad0260: Ill be there tommorow to bitch at them....and my interior is all apart I might not be moding for a long time after im done paying them off

MARINE1991 07-05-2012 09:23 PM

Quote:

Originally Posted by camaro2lt (Post 5243261)
DAVE welcome back!!!! well me and a friend that does strobes for living wired it........went to the dealer when they were closing and my fascia was on the concrete floor and has nice sctraches on it:facepalm::mad0260: Ill be there tommorow to bitch at them....and my interior is all apart I might not be moding for a long time after im done paying them off

That sucks sorry... :( :yikes: :facepalm:

alcal1084 07-06-2012 10:22 PM

I like to read but don't post much but I just got some papers in the mail that might help you I had my bcm replaced and out the door it was 263.15

camaro2lt 07-06-2012 10:28 PM

Quote:

Originally Posted by alcal1084 (Post 5249037)
I like to read but don't post much but I just got some papers in the mail that might help you I had my bcm replaced and out the door it was 263.15

pm sent!!!:chevy:

MARINE1991 07-06-2012 10:49 PM

Quote:

Originally Posted by camaro2lt (Post 5249062)
pm sent!!!:chevy:

Hope it works out for you.... :thumbup: :w00t: :thumbsup:

camaro2lt 07-06-2012 10:53 PM

i hope soo! went by today and the guy was like screaming at me because they said its soo ****ed up. they are going to call gm if they can not figure it out.

MARINE1991 07-06-2012 10:59 PM

Quote:

Originally Posted by camaro2lt (Post 5249204)
i hope soo! went by today and the guy was like screaming at me because they said its soo ****ed up. they are going to call gm if they can not figure it out.

Sorry to hear that.... :rolleyes: :(

jeepguy_1980 07-07-2012 05:55 PM

I've seen the BCMs on ebay for about $100 and the program is only $50. Install is about 5 minutes. You should be able to fix yours for under $200.

MARINE1991 07-07-2012 07:16 PM

Think it's more serious then that if the dearlership needs to call GM...:iono:

camaro4mybday 07-09-2012 08:13 AM

Quote:

Originally Posted by MARINE1991 (Post 5252203)
Think it's more serious then that if the dearlership needs to call GM...:iono:

my faith in dealerships have gone down hill badly they are parts changers and car breakers.. i had my pdim unit changed and the dealer broke the inner structure of the arm rest and just stuck it back together because they didn't know how to take out the clips... i had a recent issue with a camaro where the computers were going crazy.. i had the ecm/bcm reflashed but i still had a srs light on.. ended up the srs ecu locked up i had to send it out to have some type of reprograming done and its perfect now.. i think you have a module issue more than anything else

hawkfe 07-09-2012 09:20 PM

Would love to find a 2012 dash like that, would almost be worth pulling the dash back off again.


All times are GMT -5. The time now is 11:31 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.