Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Phastek Performance
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 6 1 2345 Last »
Showing results 1 to 30 of 169
Search took 0.02 seconds. Search: Posts Made By: skittleoncrack
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-27-2011, 12:54 PM
Replies: 15
Views: 3,754
Posted By skittleoncrack
The Cam Kit I'm getting is the Texas Speed kit...

The Cam Kit I'm getting is the Texas Speed kit and includes double spring valve springs and hardened chromoly pushrods.

I won't put a fast intake on. I've heard too many people tell me never mix a...
Forum: 5th Gen Camaro SS LS LT General Discussions 12-25-2011, 09:58 AM
Replies: 18
Views: 4,051
Posted By skittleoncrack
I have only broke 1 set so far n that was...

I have only broke 1 set so far n that was spraying a 150 shot off the line with NT05Rs @ 17psi. Power didnt break, wheel hop did. BMR Bushings Toe Rods and Trailing arms will virtually eliminate all...
Forum: USA - Texas 12-25-2011, 09:26 AM
Replies: 18
Views: 4,684
Posted By skittleoncrack
TX2K12

TX2K12 has been announced! http://www.tx2k.com/ I'll be there. Hope to see some other Camaro5 ppl there.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-25-2011, 09:21 AM
Replies: 15
Views: 3,754
Posted By skittleoncrack
What plugs did you go with? I was looking at just...

What plugs did you go with? I was looking at just a good set of NGK Iridiums. I probably need plugs anyways. 50k miles n over a 100lbs of spray.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-25-2011, 09:19 AM
Replies: 15
Views: 3,754
Posted By skittleoncrack
What are the boost a pumps i keep hearing about?...

What are the boost a pumps i keep hearing about? Only rear end mods are BMR bushings and trailing arms tow rods to stop wheel hop. I used to launch the car on nitrous (550rwhp 420motor only) and...
Forum: Tuning / Diagnostics -- engine and transmission 12-25-2011, 09:07 AM
Replies: 9
Views: 1,911
Posted By skittleoncrack
I have another thread asking about supporting...

I have another thread asking about supporting mods but Im under the impression that stock injectors should be fine. I run my nitrous wet so I'd imagine that I might need a boost a pump at most but...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-25-2011, 03:04 AM
Replies: 15
Views: 3,754
Posted By skittleoncrack
Supporting Mods for Cam?

I'm getting a TSP 231/236 Cam in 111lsa and was just wondering If I'll be needing any supporting mods. Currently I have K&N intake (1 7/8 LTs being installed same time as cam) cat delete, resonator...
Forum: Tuning / Diagnostics -- engine and transmission 12-25-2011, 02:52 AM
Replies: 9
Views: 1,911
Posted By skittleoncrack
Ok. Will I be ok to drive the car on a TSP...

Ok. Will I be ok to drive the car on a TSP .641/.615 231/236 111lsa without major tuning? If so I'll wait till feb to start installs so I'll have money for diff wideband (I have AEM and a friend...
Forum: Tuning / Diagnostics -- engine and transmission 12-25-2011, 01:40 AM
Replies: 9
Views: 1,911
Posted By skittleoncrack
Cam and LT Tuning.

So I've decided that my Christmas gift to myself this year is going to be a set of LTs and a good cam, but I've been trying to do all my tuning by myself. So I was wondering if anybody knew any good...
Forum: Forced Induction - V8 12-05-2011, 11:36 PM
Replies: 5
Views: 3,533
Posted By skittleoncrack
I'm running a NX setup on my LS3. Its a wet shot...

I'm running a NX setup on my LS3. Its a wet shot plate kit behind the throttle body. The NX kit comes with a Fly by Wire Full Throttle Switch. It uses the output voltage from the Throttle Body...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 12-04-2011, 10:06 PM
Replies: 15
Views: 3,612
Posted By skittleoncrack
so then what is causing the very loud slapping...

so then what is causing the very loud slapping under my car? only thing I can come up with is that the carrier is damaged or the bolts holding the carrier up are damaged.. and inch of vertical travel...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 12-04-2011, 02:35 PM
Replies: 15
Views: 3,612
Posted By skittleoncrack
what I have is a very rapidly repeating thud...

what I have is a very rapidly repeating thud sound coming from under the car. It was enough to break the bolts out of the rubber plate by the Tranny.

Only thing left I can think of is that the DS...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 12-04-2011, 05:32 AM
Replies: 15
Views: 3,612
Posted By skittleoncrack
Driveshaft Slapping..

So this is pretty much an update from a previous thread. I replaced the bolts in the plate between the DS and Tranny. Didn't stop the problem. I got to looking around under the car and noticed I...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 11-29-2011, 06:20 AM
Replies: 15
Views: 6,783
Posted By skittleoncrack
oh and Nmbr1gmfan.. I like the Terminators in...

oh and Nmbr1gmfan.. I like the Terminators in your video there.. Several of my friends own them. Most are just ported Eatons or Whippled.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 11-29-2011, 06:09 AM
Replies: 15
Views: 6,783
Posted By skittleoncrack
Ya I'm trying to find the torque specs. (though...

Ya I'm trying to find the torque specs. (though if anyone already has them feel free to share lol)

And I was just repeating what the dealership told me. I do actually know quite a bit about...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 11-28-2011, 07:02 PM
Replies: 15
Views: 6,783
Posted By skittleoncrack
Dealership doesn't think that the carrier is...

Dealership doesn't think that the carrier is damaged and they said that GM does not classify those bolts as one time use. They gave me the plate and 3 bolts so I can swap it over.. Gonna check my...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 11-28-2011, 04:09 AM
Replies: 15
Views: 6,783
Posted By skittleoncrack
Major Problem. Where TR6060 and DS bolt up.

So the Transmission and the Drive shaft are connected through a rubber plate that has 6 bolts in it. (3 go to TR6060, 3 go to DS)

I started to hear a knocking sound under the center console while...
Forum: Forced Induction - V8 10-25-2011, 02:25 PM
Replies: 4
Views: 1,428
Posted By skittleoncrack
I'm spraying a 150 shot with a NX plate kit. Been...

I'm spraying a 150 shot with a NX plate kit. Been through almost 5 bottles now and havent had any issues. I have K&N intake, catless exhaust (still on stock manifolds.. till next week), diablo...
Forum: USA - Southcentral 10-12-2011, 12:54 AM
Replies: 42
Views: 4,843
Posted By skittleoncrack
Dunno if your still at school but I work right...

Dunno if your still at school but I work right down the hill from PEC at the Maintenance Shop (across the street)
Forum: USA - Southcentral 10-12-2011, 12:49 AM
Replies: 42
Views: 4,843
Posted By skittleoncrack
No.. lol I've broken an axle every trip to the...

No.. lol I've broken an axle every trip to the track I've made.
13inch wide NT05Rs dead hooking with 600ft/lbs

http://i187.photobucket.com/albums/x71/Rebelwolves/photo-10.jpg
Forum: USA - Southcentral 10-12-2011, 12:46 AM
Replies: 42
Views: 4,843
Posted By skittleoncrack
I don't think there's really any meets in the...

I don't think there's really any meets in the Central Arkansas area.. not any I know of anyways. But I got the white SS on Camp JTR.
Forum: USA - Southcentral 10-12-2011, 12:40 AM
Replies: 2
Views: 1,561
Posted By skittleoncrack
Looking for Dyno in Central Arkansas area.

I dyno'd on a Mustang Dyno at ASU-Searcy and got some good numbers for a MD. Just wanna see how close my predictions are on a dynojet.

Anyone know where I can find one that isn't going to charge...
Forum: Forced Induction - V8 10-12-2011, 12:37 AM
Replies: 3
Views: 1,564
Posted By skittleoncrack
hmm The mustang dyno's ask for HP@50mph.. It has...

hmm The mustang dyno's ask for HP@50mph.. It has a list of some cars but the camaro isn't there.. know that Corvette is like 11 and a Monte carlo at 3870lbs is 14.1 so we just threw the 14.1 in there...
Forum: USA - Southcentral 10-11-2011, 04:54 PM
Replies: 11
Views: 3,521
Posted By skittleoncrack
I got a video of my car on dyno. I live in Searcy...

I got a video of my car on dyno. I live in Searcy though.. We meet in Little Rock every friday night and centerville 1k track (by russellville) most every saturday.

It's got a custom exhaust but I...
Forum: Tuning / Diagnostics -- engine and transmission 10-11-2011, 12:55 PM
Replies: 12
Views: 2,396
Posted By skittleoncrack
I had this back in January February.. It was...

I had this back in January February.. It was something to do with the cold temps outside. I only saw it when it was cold outside like 45 and below. I just let engine run up to operating temp. shut it...
Forum: Forced Induction - V8 10-11-2011, 12:50 PM
Replies: 3
Views: 1,564
Posted By skittleoncrack
HP @ 50mph?

Does anyone know the HP @ 50mph for an LS3 car? I was on a Mustang Dyno yesterday and we didn't know so they set it at 14.1 as a guess. Had a few minor tuning issues but plan to go back today now...
Forum: Tuning / Diagnostics -- engine and transmission 10-07-2011, 10:23 AM
Replies: 2
Views: 3,077
Posted By skittleoncrack
Depends qhat you're wanting to do. If your...

Depends qhat you're wanting to do. If your staying mostly stock I'd go with a Diablo or SCT. If you're doing much for mods I highly recommend HP Tuners.
Forum: Transmission / Driveline 08-12-2011, 01:02 PM
Replies: 4
Views: 1,118
Posted By skittleoncrack
pm sent

pm sent
Forum: Transmission / Driveline 08-12-2011, 11:41 AM
Replies: 4
Views: 1,118
Posted By skittleoncrack
Need stock clutch

My cluch threw a chunck out yesterday and is now causing ALOT of vibration.

Also does anyone know which LS clutches will work in LS3 (i know LS9 will)
Forum: Tuning / Diagnostics -- engine and transmission 07-11-2011, 11:30 AM
Replies: 1
Views: 1,084
Posted By skittleoncrack
Need Trinity Tuning Help

I have a Diablo Trinity I bought to tune me SRT-4 Neon a few years ago, but traded the car in on my 2010 LS3/SS. I currently have K&N intake, Custom Catless Exhaust, NX 150-shot plate/wet. I'm tuned...
Showing results 1 to 30 of 169
Page 1 of 6 1 2345 Last »

 
Forum Jump

All times are GMT -5. The time now is 12:56 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.