Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
dave@hennessey
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 10 of 10
Search took 0.01 seconds.
Search: Posts Made By: dcarroll95
Forum: 5th Gen Camaro SS LS LT General Discussions 08-23-2020, 04:32 PM
Replies: 5
Views: 2,792
Posted By dcarroll95
Auto to manual Conversion Clutch Pedal without swapping dash harness

I've done a couple of auto to manual conversions, and used to swap the dash harness, but just traced the wires today and figured out how to re-use the 6 wires for the auto brake pedal sensor to...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-21-2020, 01:38 PM
Replies: 19
Views: 9,342
Posted By dcarroll95
Auto vs Manual front piece picture

See the picture below which shows 3 auto driveshaft front pieces and one manual. The manual one is shorter and is second from the left.

The back half was the same length auto or manual.

For...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-20-2020, 05:44 PM
Replies: 19
Views: 9,342
Posted By dcarroll95
Thanks for the comparison picture

I have 4 ZL1s that I'm rebuilding and probably mixed up the driveshafts. Just spent over an hour trying to get the driveshaft in which I've done twice before relatively easily. For some reason...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-17-2020, 07:50 PM
Replies: 2
Views: 1,826
Posted By dcarroll95
Electronic Power Steering Connector / terminal info

Hi all, I dropped my engine cradle with engine/transmission out the bottom and when I separated the cradle from the engine I forgot to disconnect the 10 pin electronic power steering connector and...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 06-02-2020, 12:51 PM
Replies: 14
Views: 44,096
Posted By dcarroll95
LSA Pinout correction

Note that the LSA is pinned out completely differently and listed in the FSM. Also I found an error in the 2013 FSM. The clutch pedal position sensor is on K20 X3 pin 63 which is mislabeled in the...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-24-2020, 08:36 PM
Replies: 4
Views: 27,666
Posted By dcarroll95
This car ran over something big and popped the...

This car ran over something big and popped the condenser so all the Freon vented to atmosphere. I took the compressor off to drain all the PAG oil and about 1 to 1.5 ounces drained out so the rule of...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-24-2020, 08:34 PM
Replies: 4
Views: 27,666
Posted By dcarroll95
120cc PAG oil is what is on the sticker on my...

120cc PAG oil is what is on the sticker on my 2013 ZL1 compressor. That’s 4oz not 8.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-10-2020, 03:28 PM
Replies: 13
Views: 5,750
Posted By dcarroll95
White Automotive and Media seems to have a 5th...

White Automotive and Media seems to have a 5th Gen Camaro BCM programming but it's out of stock (maybe they supply the BCM and they are out). Sent them a request to see if they can rewrite a manual...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-10-2020, 03:24 PM
Replies: 13
Views: 5,750
Posted By dcarroll95
You'll definitely need the clutch pedal wiring...

You'll definitely need the clutch pedal wiring hooked up (seems like the BCM needs to detect clutch pushed to send the start signal to the PCM). It's the same connector as the brake pedal, also...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-10-2020, 11:56 AM
Replies: 13
Views: 5,750
Posted By dcarroll95
Auto to manual swap nearly done - but need BCM advice

Apologize for the long thread, but I wanted to give full info on what's been done and what hasn't worked so far. Did searching but most auto to manual swap threads are about people with a fully...
Showing results 1 to 10 of 10

 
Forum Jump

All times are GMT -5. The time now is 12:00 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.