Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Jason 98 TA
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 500
Search took 0.08 seconds.
Search: Posts Made By: christianchevell
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons Today, 07:55 AM
Replies: 5
Views: 190
Posted By christianchevell
summit racing for budget and performance GMPP...

summit racing for budget and performance GMPP stock ported heads $1200 no core with hollow intakes...read the reviews comparing stock ported to others
Forum: 5th Gen Camaro SS LS LT General Discussions Today, 07:49 AM
Replies: 14
Views: 382
Posted By christianchevell
try zerotosixtytimes.com

try zerotosixtytimes.com
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons Yesterday, 05:28 PM
Replies: 23
Views: 813
Posted By christianchevell
yes, I would change lifters with that many miles...

yes, I would change lifters with that many miles too, if not you could have used dowels or rods to hold the lifters up to change a Cam with out pulling the heads.

I am sure by now new lifters is...
Forum: 5th Gen Camaro SS LS LT General Discussions Yesterday, 05:19 PM
Replies: 3
Views: 211
Posted By christianchevell
they would not fit as the hoods are different.

they would not fit as the hoods are different.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-28-2015, 06:38 PM
Replies: 8
Views: 231
Posted By christianchevell
you will need the speedometer calibrated for the...

you will need the speedometer calibrated for the new gears. This is supposedly available from the dealer yet many have posted they could not get it, yet my tuner could do it no problem and has the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-28-2015, 06:33 PM
Replies: 23
Views: 813
Posted By christianchevell
With the smaller most likely base circle your cam...

With the smaller most likely base circle your cam has you may be required to use a different size than the pushrods you have selected which is 7.4 the stock size.

You should get a harmonic...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-28-2015, 06:26 PM
Replies: 13
Views: 441
Posted By christianchevell
And BTW if you mill the heads for more...

And BTW if you mill the heads for more compression then you limit the cam size as far as lift unless you have fly cut the pistons..... SO be sure you know what cam and how much gain you want or you...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-28-2015, 06:18 PM
Replies: 49
Views: 1,138
Posted By christianchevell
I think you would be pleasantly surprised at what...

I think you would be pleasantly surprised at what you get for your dollar, and you may just want to step into a used Camaro as the price for a used SS could be in your price range. I belong to a...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-28-2015, 07:46 AM
Replies: 50
Views: 2,713
Posted By christianchevell
I bought one.

I bought one.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-27-2015, 07:39 AM
Replies: 13
Views: 441
Posted By christianchevell
or go to summit and buy gmpp ported heads no core...

or go to summit and buy gmpp ported heads no core for 1200$
Forum: 5th Gen Camaro SS LS LT General Discussions 07-26-2015, 05:32 PM
Replies: 7
Views: 457
Posted By christianchevell
how about a self leveling cup holder in the...

how about a self leveling cup holder in the middle of the steering wheel........
Forum: Suspension / Brakes / Chassis 07-26-2015, 05:28 PM
Replies: 15
Views: 593
Posted By christianchevell
BMR

BMR
Forum: 5th Gen Camaro SS LS LT General Discussions 07-26-2015, 07:32 AM
Replies: 74
Views: 6,155
Posted By christianchevell
well actually it was pretty damn easy to do a 5...

well actually it was pretty damn easy to do a 5 to 1 a lot easier than the 5-3 it did not want to let me into and I know 5 to 5 wasn't working, so this use the force deal some like to claim...... is...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-25-2015, 06:57 PM
Replies: 74
Views: 6,155
Posted By christianchevell
It will get more than your attention..... it...

It will get more than your attention..... it will get you buying a new engine if its revved to high and you do not check for damage to things as I know ....... If I could have turned back...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-25-2015, 09:19 AM
Replies: 16
Views: 495
Posted By christianchevell
I would think the preload difference goes more to...

I would think the preload difference goes more to do with the difference in valve angle going from 15 degrees on a ls3 to 12 on a ls7 ? And any other things they deemed as its totally different...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-25-2015, 09:12 AM
Replies: 15
Views: 606
Posted By christianchevell
OUR halos are weak....I went and bought 13w LEDs...

OUR halos are weak....I went and bought 13w LEDs and cross wired to keep the DRL's going with the lights and say why not..... its unintended consequence is making the halos always on also by...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-25-2015, 08:59 AM
Replies: 3
Views: 241
Posted By christianchevell
Halos belong in the sealed headlight enclosure,...

Halos belong in the sealed headlight enclosure, to replace stock halos with aftermarket LED lights you need to heat the enclosure in the oven to make the sealant pliable and then un attach the two...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-24-2015, 05:28 PM
Replies: 17
Views: 416
Posted By christianchevell
BBK throttle bodies are not known on here for...

BBK throttle bodies are not known on here for being a friendly bolt on....
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-24-2015, 05:17 PM
Replies: 9
Views: 331
Posted By christianchevell
Be sure and let us know.... I had a spring break...

Be sure and let us know.... I had a spring break prc .675 but was no doubt most likely from a over rev many months before, and it started with a very slight tick like exhaust the when the second one...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-23-2015, 06:21 PM
Replies: 13
Views: 440
Posted By christianchevell
there is a lot in the drivability to the LSA of...

there is a lot in the drivability to the LSA of the cam, the tighter the more higher you need to take off in gear in RPMs and the higher the idle.... Anyway there a good article in the differences...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-23-2015, 06:10 PM
Replies: 16
Views: 438
Posted By christianchevell
well geeze, your low lift is like stock and the...

well geeze, your low lift is like stock and the duration not enough the lsa is much better than stock but geeze , I know that with those specs your cam should behave a lot like stock yet have enough...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-23-2015, 05:44 PM
Replies: 41
Views: 2,218
Posted By christianchevell
7.350 plus .060 is 7.410 but when you add .025 to...

7.350 plus .060 is 7.410 but when you add .025 to that its 7.435... found this: http://forum.grrrr8.net/showthread.php?t=34855, and of course Robert way the guy who did his DIY cam install video...
Forum: Tuning / Diagnostics -- engine and transmission 07-23-2015, 05:26 PM
Replies: 22
Views: 679
Posted By christianchevell
yes and you also should check the spark...

yes and you also should check the spark plugs....... one could be cracked or more..
Forum: 5th Gen Camaro SS LS LT General Discussions 07-23-2015, 05:22 PM
Replies: 72
Views: 1,992
Posted By christianchevell
buy some sunbrella water repellant online then...

buy some sunbrella water repellant online then keep the top wetted down occasionally and if you ever see the cat let it have it........
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-23-2015, 07:58 AM
Replies: 41
Views: 2,218
Posted By christianchevell
wow, that's good a 800 idle is a lot better than...

wow, that's good a 800 idle is a lot better than 900 + SO I think I can go with the cam motion I have for a new cam and get a much more street friendly drive with a much lower idle and save some...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-22-2015, 06:38 PM
Replies: 16
Views: 438
Posted By christianchevell
Your not stating the lift means it could be any...

Your not stating the lift means it could be any lift.... the duration is nice and tight though however the duration is fair, and depending on what kind of dyno and who corrects it... I would say...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-22-2015, 06:24 PM
Replies: 20
Views: 584
Posted By christianchevell
http://i1301.photobucket.com/albums/ag104/christia...

http://i1301.photobucket.com/albums/ag104/christianchevelle/IMG_0001.jpg (http://s1301.photobucket.com/user/christianchevelle/media/IMG_0001.jpg.html)

2013 Camaro ss CAI, TSP long tubes, and...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-22-2015, 06:10 PM
Replies: 41
Views: 2,218
Posted By christianchevell
Also all dynos were originally set for the...

Also all dynos were originally set for the atmosphere and altitude of Detroit, and yes mustang being a true load bearing dyno will usually read lower than dynojets and can be way low if they have it...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-22-2015, 05:47 PM
Replies: 41
Views: 2,218
Posted By christianchevell
Hey J the last cam is .639/.623 with 235/239 and...

Hey J the last cam is .639/.623 with 235/239 and a 112 lsa and required .675 springs. My new cam is like .613/.578 with 223/234 and 114+4 so considerably milder I had them add .010 to the Cam motion...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-21-2015, 05:53 PM
Replies: 32
Views: 1,221
Posted By christianchevell
new headers always smoke you should see painted...

new headers always smoke you should see painted ones....lol. Hopefully the tune takes into account delayed response from the front O2 sensors being further down stream as this code can pop up...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 09:33 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.