Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Dyno Max
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 454
Search took 0.08 seconds.
Search: Posts Made By: Batmanntexas
Forum: Forced Induction - V8 02-19-2015, 10:20 PM
Replies: 19
Views: 874
Posted By Batmanntexas
Like everybody else has said, NO ISSUES with the...

Like everybody else has said, NO ISSUES with the Whipple. I have about 20K miles on my build, and am also still running the stock clutch, driveshaft, and rear end, also with out any issues.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-13-2015, 10:14 PM
Replies: 62
Views: 1,652
Posted By Batmanntexas
Does your driving consist of light-to-light...

Does your driving consist of light-to-light (city) driving only? If that is strictly in town mileage, I could almost believe it, but it still seems a tad low. I get about 15-17 city, 22-25 hwy. ...
Forum: Tuning / Diagnostics -- engine and transmission 01-24-2015, 07:58 PM
Replies: 7
Views: 638
Posted By Batmanntexas
Thanks for all of the replies. The data logging...

Thanks for all of the replies. The data logging session confirmed that the computer was adding 20-25% more fuel trying to compensate. The O2 sensors were functioning correctly. The tune was...
Forum: Tuning / Diagnostics -- engine and transmission 01-03-2015, 10:51 PM
Replies: 7
Views: 638
Posted By Batmanntexas
P0171 & P0174 and LTFT's question(s)

Hello All! Okay, I just moved from Albuquerque, NM (5500ft) to Sanford, NC (350ft). I keep getting P0171 and P0174 codes. They show up about every third/fourth day of running the engine, and they...
Forum: Forced Induction - V8 01-02-2015, 08:59 AM
Replies: 19
Views: 993
Posted By Batmanntexas
As noted above, Methanol is used to raise octane....

As noted above, Methanol is used to raise octane. It will provide additional power, if your tune is calibrated to take advantage of it. Though it is not as simple as bolting it on, wiring it in,...
Forum: Forced Induction - V8 12-26-2014, 01:42 PM
Replies: 7
Views: 525
Posted By Batmanntexas
What did you find out??

What did you find out??
Forum: Forced Induction - V8 12-26-2014, 01:25 PM
Replies: 16
Views: 873
Posted By Batmanntexas
Do you have a BAP (boost-a-pump) installed by...

Do you have a BAP (boost-a-pump) installed by chance? If not, then I seriously doubt the stock pump is going to keep pace with the additional fuel demands. I highly recommend ordering the ZL1 pump...
Forum: Forced Induction - V8 12-23-2014, 12:32 PM
Replies: 7
Views: 525
Posted By Batmanntexas
Take a look in the hub on your 4.00" pulley and...

Take a look in the hub on your 4.00" pulley and see if there is a spacer stuck in there. I also swapped to a smaller pulley, but did not have any issues at all. You could also remove the smaller...
Forum: Forced Induction - V8 12-20-2014, 07:17 PM
Replies: 5
Views: 694
Posted By Batmanntexas
Nice, sounds good, too! Can you give some...

Nice, sounds good, too! Can you give some details on the cam that was installed? Also, what kind of fuel upgrades are you planning? What does the current fuel system consist of?

Thanks,
...
Forum: Forced Induction - V8 11-30-2014, 12:43 AM
Replies: 4
Views: 613
Posted By Batmanntexas
Do you still have the installation instructions...

Do you still have the installation instructions for your Whipple? If not, you can download them from Whipple. In either case, it details how to adjust the linkage for he bypass valve if it is...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-30-2014, 12:33 AM
Replies: 18
Views: 940
Posted By Batmanntexas
This is a little late, but better late than...

This is a little late, but better late than never, right??

TO REMOVE AIR BUBBLES FROM COOLING SYSTEM (on 5th Gen Camaro):
1. Get a shop-vac/vacuum and hose/attachment that fits just over the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-16-2014, 01:14 PM
Replies: 38
Views: 2,130
Posted By Batmanntexas
@partymn-- Thanks!

@partymn-- Thanks!
Forum: Forced Induction - V8 11-16-2014, 12:57 PM
Replies: 27
Views: 1,325
Posted By Batmanntexas
As Ted@JRE mentioned earlier, might want to check...

As Ted@JRE mentioned earlier, might want to check the grounds, in particular, the grounds for the coil packs, which are located on the back side of each cylinder head. They are secured by a 12mm...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-16-2014, 12:40 PM
Replies: 38
Views: 2,130
Posted By Batmanntexas
Is this a "bolt-on" mod, or is tuning required? ...

Is this a "bolt-on" mod, or is tuning required?

Thanks,
Scott
Forum: Forced Induction - V8 11-14-2014, 06:32 PM
Replies: 5
Views: 294
Posted By Batmanntexas
I'm definitely not an expert, but I'd say that...

I'm definitely not an expert, but I'd say that anytime you get a lean indication on your w/b, when you are on the gas or constant throttle, is an issue. I'd say it is perfectly normal to see a lean...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-13-2014, 10:20 PM
Replies: 166
Views: 6,112
Posted By Batmanntexas
+127 22 years and still going... USN...

+127
22 years and still going...
USN 1992-1998
USA 1998-Present
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-10-2014, 08:59 PM
Replies: 42
Views: 3,347
Posted By Batmanntexas
Camshaft: GM LS9,211/230 duration, .562/.558 lift...

Camshaft: GM LS9,211/230 duration, .562/.558 lift at 122.5LSA
GMPP HV oil pump, stock LS3 chain/tensioner, 3-bolt cam gear
OBX 1-7/8" LT's, full 3" exhaust, gutted cats, 2.9L Whipple @ 7psi
Alky...
Forum: Forced Induction - V6 11-10-2014, 02:07 AM
Replies: 60
Views: 2,732
Posted By Batmanntexas
Gear Calculator

I have attached a gear/speedometer/tire calculator that I put together. When I crunched your numbers (3rd gear@1.55/3.27 axle/7300RPM), I got 123MPH at 0% slip, 119MPH@3% slip, and 117MPH@5% slip. ...
Forum: Forced Induction - V8 11-09-2014, 11:41 PM
Replies: 16
Views: 973
Posted By Batmanntexas
AGP Turbo rocks! Awesome of you to help this...

AGP Turbo rocks! Awesome of you to help this person out with such a detailed plan. Awesome.
Forum: Forced Induction - V8 11-03-2014, 03:54 PM
Replies: 56
Views: 3,568
Posted By Batmanntexas
Just my $.02, but if you are looking for 500WHP,...

Just my $.02, but if you are looking for 500WHP, get a Whipple and be done with it. It costs a little over $7K, about $7300, but you will be in the 525-550WHP range, and their kit is complete with...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 10-31-2014, 10:27 PM
Replies: 23
Views: 1,329
Posted By Batmanntexas
+1....been running mine this way for months. ...

+1....been running mine this way for months. ZERO issues. Alky Control is an awesome setup. I have an AIS trunk tank, but it is a little different than the one pictured above. Mine holds about...
Forum: Member Car Journals 10-26-2014, 10:46 PM
Replies: 87
Views: 10,320
Posted By Batmanntexas
Car looks absolutely fantastic!! Does the meth...

Car looks absolutely fantastic!! Does the meth come on only under boost condition, or is it based off airflow/speed from the MAF? Waiting to see the burnt copper alloy and black...it should look...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 10-18-2014, 11:58 AM
Replies: 0
Views: 141
Posted By Batmanntexas
WTB: HPTuners Pro tuning software and cables

Like the title says, I'm looking to buy the HPTuners Pro tuning software and cables. I know that I can get this direct form HPTuners website for $649 and it comes with 8 credits. Just checking on...
Forum: USA - Southeast 10-15-2014, 10:30 PM
Replies: 68
Views: 4,916
Posted By Batmanntexas
Sign me up as well, please. Moving back to NC in...

Sign me up as well, please. Moving back to NC in December. Already got the hotel room booked! Looking forward to it!!
Forum: Forced Induction - V8 10-14-2014, 09:57 PM
Replies: 15
Views: 626
Posted By Batmanntexas
I have the Whipple, and I agree with the above...

I have the Whipple, and I agree with the above statements regarding the Maggie w/cogs. My buddy has one, overdriven cogs, and it whines like a FIEND!!! sounds awesome.

I second the advice...
Forum: Forced Induction - V8 10-09-2014, 11:21 PM
Replies: 3
Views: 356
Posted By Batmanntexas
Update: I drove the car to work this morning, as...

Update: I drove the car to work this morning, as usual, however, I disconnected the ultra gauge and ran my Actron scan tool in it's place. I set it to monitor coolant temp (PID mode). Code P0116...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-09-2014, 11:18 PM
Replies: 2
Views: 360
Posted By Batmanntexas
BUMP......wtf????

BUMP......wtf????
Forum: Forced Induction - V8 10-09-2014, 11:17 PM
Replies: 3
Views: 356
Posted By Batmanntexas
HELP!!! Intermittent DTC P0116

Hello all. I am getting an intermittent P0116 on my 2012 SS, LS3. It usually happens once every drive cycle, about 10-15 minutes into the drive. I have an "ultra-gauge" as well, that monitors coolant...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-08-2014, 10:59 PM
Replies: 2
Views: 360
Posted By Batmanntexas
Update: I drove the car to work this morning, as...

Update: I drove the car to work this morning, as usual, however, I disconnected the ultra gauge and ran my Actron scan tool in it's place. I set it to monitor coolant temp (PID mode). Code P0116...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-07-2014, 10:37 PM
Replies: 2
Views: 360
Posted By Batmanntexas
Intermittent P0116 Code

Hello all. I am getting an intermittent P0116 on my 2012 SS, LS3. It usually happens once every drive cycle, about 10-15 minutes into the drive. I have an "ultra-gauge" as well, that monitors...
Showing results 1 to 30 of 454

 
Forum Jump

All times are GMT -5. The time now is 03:53 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.