Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Roto-Fab
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 2 1 2
Showing results 1 to 30 of 54
Search took 0.01 seconds. Search: Posts Made By: ScarTissue48
Forum: Audio / Visual / Electronics/ Gauges / Nav 07-19-2018, 01:14 PM
Replies: 4
Views: 1,515
Posted By ScarTissue48
Bump, anybody got one available? I need one...

Bump, anybody got one available? I need one with the heated seat controls
Forum: Audio / Visual / Electronics/ Gauges / Nav 03-22-2018, 04:36 PM
Replies: 4
Views: 1,515
Posted By ScarTissue48
PM sent!

PM sent!
Forum: Audio / Visual / Electronics/ Gauges / Nav 03-18-2018, 12:42 PM
Replies: 4
Views: 1,515
Posted By ScarTissue48
WTB: 2010 Radio Faceplate

Looking for a stock faceplate like the one in the attached pic.

Thanks!
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 01-21-2018, 11:30 PM
Replies: 7
Views: 1,940
Posted By ScarTissue48
Was your issue the same as what I described there?

Was your issue the same as what I described there?
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 01-21-2018, 07:08 PM
Replies: 7
Views: 1,940
Posted By ScarTissue48
So I found someone close with a spare faceplate...

So I found someone close with a spare faceplate to plug in, and it did not light up/get any power either. Fuses are fine and the faceplate is fine. Whats the deal? Bad bcm? Was very close to...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 12-15-2017, 08:16 AM
Replies: 7
Views: 1,940
Posted By ScarTissue48
Radio display out

Hey guys, having an issue with my radio I'm hoping to get some help with. It still puts out sound and can be adjusted with the steering wheel controls, but the display and all the buttons are out,...
Forum: Tuning / Diagnostics -- engine and transmission 10-19-2017, 02:42 PM
Replies: 4
Views: 5,467
Posted By ScarTissue48
I decided to swap out the pcm, so went ahead and...

I decided to swap out the pcm, so went ahead and put the car back together. Went ahead and tried to start it and see how it did before ordering the pcm, and the dang thing ran fine, no check engine...
Forum: Tuning / Diagnostics -- engine and transmission 08-16-2017, 05:43 PM
Replies: 4
Views: 5,467
Posted By ScarTissue48
Ok so with all the sensors unplugged, the 5V...

Ok so with all the sensors unplugged, the 5V reference wires are reading 4.8 for the map and camshaft position sensor, but the rest I can only get a reading of 0.1 to 0.12 volts. Sound like a shot...
Forum: Tuning / Diagnostics -- engine and transmission 08-14-2017, 10:52 AM
Replies: 4
Views: 5,467
Posted By ScarTissue48
Looks like I may have posted this on the wrong...

Looks like I may have posted this on the wrong board... Can a mod move this over to the Issues/Problems board?
Forum: Tuning / Diagnostics -- engine and transmission 08-12-2017, 03:56 PM
Replies: 4
Views: 5,467
Posted By ScarTissue48
p0641

Ok, so I'm having trouble with a p0641 code that is also throwing codes for each sensor on that 5v reference circuit.

I did a cam swap about a year ago and haven't driven the car just a whole...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-08-2016, 08:19 PM
Replies: 6
Views: 1,368
Posted By ScarTissue48
Yea I've looked around and have seen several...

Yea I've looked around and have seen several crankshaft seals look just like the btr one I have. I'm with you, I didn't pull anything off the car that looks like that so I'm just going to get the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-08-2016, 05:32 PM
Replies: 6
Views: 1,368
Posted By ScarTissue48
825547 825548 825549

825547

825548

825549
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-08-2016, 05:28 PM
Replies: 6
Views: 1,368
Posted By ScarTissue48
BTR Timing Chain Damper Seal

Putting the car back together after a cam swap and am kinda at a loss looking at this part from BTR that is supposedly interchangeable with our front main seal. Link:
...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-03-2016, 07:39 PM
Replies: 21
Views: 4,023
Posted By ScarTissue48
Thanks for the heads up, I hadn't looked into the...

Thanks for the heads up, I hadn't looked into the torque sequence yet. That method for getting lifter on the base circle is appreciated too...gonna do that asap.

I've measured several times on...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-03-2016, 02:42 PM
Replies: 3
Views: 1,477
Posted By ScarTissue48
Yea the btr guy said .04 to .05 for the morels...

Yea the btr guy said .04 to .05 for the morels "he thinks."I've seen everything from .03-.06
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-03-2016, 11:54 AM
Replies: 21
Views: 4,023
Posted By ScarTissue48
Is there a more accurate way than putting the...

Is there a more accurate way than putting the cylinder at tdc?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-03-2016, 09:53 AM
Replies: 21
Views: 4,023
Posted By ScarTissue48
:smiling1: I was wondering why it would make...

:smiling1:

I was wondering why it would make any difference where the lifters were when torquing the heads haha

Yes, I'm putting the cylinder I'm measuring on top dead center so both valves...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-02-2016, 05:27 PM
Replies: 21
Views: 4,023
Posted By ScarTissue48
Yes new arps, first time they had been installed....

Yes new arps, first time they had been installed. I think I've got it narrowed down to either not clean enough bolt holes or just a defective Bolt. No I did not worry about the lifter orientation...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-02-2016, 05:25 PM
Replies: 21
Views: 4,023
Posted By ScarTissue48
Double post

Double post
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-02-2016, 04:10 PM
Replies: 21
Views: 4,023
Posted By ScarTissue48
Yea I used the arp lube and took them to 75 on...

Yea I used the arp lube and took them to 75 on first pass and the 4th bolt snapped off. So I said eff it and sent it to the shop for a bolt extraction and head install. Threw out the arps and had...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-02-2016, 03:35 PM
Replies: 3
Views: 1,477
Posted By ScarTissue48
Anybody got a BTR stage 4 w/morel 5315s?

Measuring pushrods and seem to be getting around 11-11.5 turns on the pushrod length checker to get to what I think is zero lash. So if I'm setting zero lash correctly my math looks like this: ...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-19-2016, 09:36 PM
Replies: 21
Views: 4,023
Posted By ScarTissue48
Here's the instructions and part number for them....

Here's the instructions and part number for them. Just noticing it says Gen III motors, and we're gen IV. Guess I way over torqued them. Pisses me off cuz I called and told them what car I had and...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-19-2016, 12:42 PM
Replies: 21
Views: 4,023
Posted By ScarTissue48
Thanks for the input guys...think I'm lined out. ...

Thanks for the input guys...think I'm lined out. Was planning on doing that this weekend but snapped off a head bolt while putting heads back on. Screw arp.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-17-2016, 01:42 PM
Replies: 21
Views: 4,023
Posted By ScarTissue48
I appreciate the info guys. So after...

I appreciate the info guys.

So after torquing the heads back on, what needs to be my next step? Install pushrods and go about setting preload for non adjustable rockers....or measuring pushrod...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-16-2016, 10:58 PM
Replies: 21
Views: 4,023
Posted By ScarTissue48
New lifter adjustment/pushrod measurement

Ok guys, needing some help. In the middle of a cam swap and ended up dropping a lifter into the oil pan. Was able to fish it out fairly easy, but had to pull the heads to drop lifter back in. And...
Forum: Wheels / Tires 02-21-2014, 04:08 PM
Replies: 13
Views: 3,224
Posted By ScarTissue48
Bump

Bump
Forum: Wheels / Tires 02-20-2014, 08:27 AM
Replies: 13
Views: 3,224
Posted By ScarTissue48
Bump

Bump
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-08-2013, 08:04 PM
Replies: 5
Views: 1,930
Posted By ScarTissue48
Definitely a pick up....I haven't had the chance...

Definitely a pick up....I haven't had the chance to dyno so I have no clue what my numbers are but it definitely jumped up in hp and started leaving a couple cars that I had ran against previously...
Forum: Wheels / Tires 09-08-2013, 07:56 PM
Replies: 24
Views: 3,224
Posted By ScarTissue48
bump...open to offers and trades

bump...open to offers and trades
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-08-2013, 07:43 PM
Replies: 5
Views: 1,930
Posted By ScarTissue48
Just installed LT headers...

Just installed some 1 7/8s long tube headers and I was just wanting to make sure the DTCs I'm getting are normal. It's throwing DTCs for both front O2 sensors and the Bank 2 Sensor 2, but not the...
Showing results 1 to 30 of 54
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 06:32 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.