Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
HRE Wheels
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 282
Search took 0.02 seconds.
Search: Posts Made By: kpwalls06
Forum: Forced Induction - V8 07-28-2015, 04:57 AM
Replies: 38
Views: 2,347
Posted By kpwalls06
Sorry for the delay, I'm working overseas, and...

Sorry for the delay, I'm working overseas, and have been traveling for a few days. I'll answer what I can, but I'm afraid I'm at a standstill on troubleshooting until I get home.



There is no...
Forum: Forced Induction - V8 07-25-2015, 10:27 AM
Replies: 38
Views: 2,347
Posted By kpwalls06
I can't say runs fine. I've noticed the RPM will...

I can't say runs fine. I've noticed the RPM will jump around quite a bit during low RPM slow movement, and it dies easier during low RPM movement, i.e. backing out of a parking spot slowly. But...
Forum: Forced Induction - V8 07-24-2015, 06:57 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
I'll take it off the stands tomorrow and take it...

I'll take it off the stands tomorrow and take it out for a drive to see if it makes boost now. I've ruled out leaks, the TruBoost is reading correctly, the FAST intake isn't leaking, and the turbos...
Forum: Forced Induction - V8 07-24-2015, 06:13 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
For the leak test, I blocked off the system and...

For the leak test, I blocked off the system and used compressed air to pressurize the system, and same for testing the TruBoost.

During the running tests, the car is parked and idling. This is...
Forum: Forced Induction - V8 07-24-2015, 01:41 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
Yeah, I tried it again. With the car idling, I'm...

Yeah, I tried it again. With the car idling, I'm reading -11 on the TruBoost.

Also, I did a pressure check of the charge air side vs. the intake manifold, and when the car is idling, I'm...
Forum: Forced Induction - V8 07-24-2015, 12:21 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
Update so far.... I leaked tested the...

Update so far....

I leaked tested the system, and found nothing blatant, just a small leak on one coupler. Fixed that, and found the BOV had a small leak where it connected to the charge air...
Forum: Forced Induction - V8 07-23-2015, 11:34 AM
Replies: 38
Views: 2,347
Posted By kpwalls06
I only checked the compressor side yesterday, I...

I only checked the compressor side yesterday, I don't think the turbine blades are damaged, since I can hear the turbo spooling. If all else fails, then I'll give that a look.
Forum: Forced Induction - V8 07-22-2015, 08:57 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
I checked all the couplers today, and though I...

I checked all the couplers today, and though I found two clamps that weren't quite tight, one that was loose, but I don't think that would be enough to blow out all the boost, and/or let the engine...
Forum: Forced Induction - V8 07-21-2015, 06:01 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
I'll leak check it as soon as I can in the...

I'll leak check it as soon as I can in the morning, and hopefully get it figured out then.
Forum: Forced Induction - V8 07-21-2015, 05:37 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
BOV is hooked up, and I made sure the spring was...

BOV is hooked up, and I made sure the spring was in before I installed it, same with the wasgtegates. Also, with the car running at idle, the wastegates don't have any exhaust coming out of the dump...
Forum: Forced Induction - V8 07-21-2015, 05:26 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
Thanks for all the suggestions guys, I really...

Thanks for all the suggestions guys, I really appreciate it!

Unreal, how would I check that the tune was adjusted for the ZR1 sensor? Matt from FSP set me up with the base tune, since I ordered...
Forum: Forced Induction - V8 07-21-2015, 03:35 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
I've checked all the intake piping, and I can't...

I've checked all the intake piping, and I can't find any boots that have moved, or any clamps that have moved either.
Forum: Forced Induction - V8 07-21-2015, 03:17 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
I'm running the ZR1 MAP sensor, I have 8lb...

I'm running the ZR1 MAP sensor, I have 8lb springs in the wastegate's. I'm thinking air leak, because I can hear the turbos spooling, but I've checked the charge-air system three times since...
Forum: Forced Induction - V8 07-21-2015, 03:05 PM
Replies: 38
Views: 2,347
Posted By kpwalls06
Turbos Not Making Boost...Ideas?

Here's the background.
-418ci LS3, 9.6:1 CR, FAST 102 Intake Manifold
-AGP TT Kit, w/ Precision 58/62 Turbos
-Fore Precision Twin Pump Fuel System w/ ID1000's

I bought an AGP TT kit...
Forum: Tuning / Diagnostics -- engine and transmission 09-17-2014, 11:22 PM
Replies: 25
Views: 2,275
Posted By kpwalls06
Glad I found this thread, I'm having similar...

Glad I found this thread, I'm having similar problems. I put on the AGP TT kit, with a new fuel system, and installed the AEM TruBoost and UEGO at the same time. Wideband shows stoichiometric-ish...
Forum: Forced Induction - V8 09-17-2014, 12:35 AM
Replies: 9
Views: 1,098
Posted By kpwalls06
I have the Fore setup, twin pumps. I'm happy...

I have the Fore setup, twin pumps. I'm happy with it, no complaints with components or service. Was always able to get hold of Justin w/ Fore, and Matt @ FSP for any questions. I
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 05-09-2014, 02:15 PM
Replies: 4
Views: 621
Posted By kpwalls06
You're talking about the two power outlet...

You're talking about the two power outlet circuits, right? Thanks, and I found those, but with a dual fuse tap I can only use one. I'm going to use one of those, and tap a different source for my...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 05-09-2014, 11:37 AM
Replies: 4
Views: 621
Posted By kpwalls06
If you use a constantly on +12V source, you will...

If you use a constantly on +12V source, you will need a ground kill, a ground source that gets cut when the ignition is off. I'm wiring in the same stuff right now, and I haven't found a switched...
Forum: Forced Induction - V8 05-07-2014, 06:31 PM
Replies: 7
Views: 661
Posted By kpwalls06
I can't answer for every single fuel system out...

I can't answer for every single fuel system out there, but more than likely yes, changing anything with the fuel system will mess with the car if it's not tuned for it. Again, that's a generic...
Forum: Forced Induction - V8 03-31-2014, 07:59 AM
Replies: 11
Views: 1,312
Posted By kpwalls06
You have two options with the AGP kit. You can...

You have two options with the AGP kit. You can leave the stock exhaust manifolds on, since the kit was designed to bolt up to these; or you can put on a set of shorty headers and bolt to that. I...
Forum: General Automotive + Other Cars Discussion 03-19-2014, 09:28 PM
Replies: 28
Views: 23,942
Posted By kpwalls06
Build it, paint it Charcoal Gray Metallic, bench...

Build it, paint it Charcoal Gray Metallic, bench seat as an option, and I'll take it! I miss my '79 El Camino, second coolest car I've ever owned.
Forum: Forced Induction - V8 03-18-2014, 09:42 PM
Replies: 9
Views: 974
Posted By kpwalls06
Agree with what Levis said. I'm in the middle of...

Agree with what Levis said. I'm in the middle of installing this kit on my car, and it's really not hard at all, just time consuming.

Again like Levis said, post if you have questions, plenty of...
Forum: Exterior Parts & Accessories 03-17-2014, 08:58 PM
Replies: 136
Views: 11,005
Posted By kpwalls06
+1 Haven't heard anything on my AMS hood in a...

+1 Haven't heard anything on my AMS hood in a bit, could use an update.
Forum: Forced Induction - V8 03-16-2014, 12:49 PM
Replies: 14
Views: 2,532
Posted By kpwalls06
Impressive numbers! I'm in the middle of putting...

Impressive numbers! I'm in the middle of putting the same kit on my 418ci LS3, using the Precision 5862's, hoping for results like this when it's finished.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-10-2014, 09:29 PM
Replies: 2
Views: 484
Posted By kpwalls06
If you can access the inside of the manifold you...

If you can access the inside of the manifold you might be able to use a threaded fitting through the hole with an o-ring or gasket on either side, and a nut on the inside of the manifold to hold it...
Forum: Vendor and Seller review / feedback / experiences 03-10-2014, 08:33 PM
Replies: 39
Views: 2,491
Posted By kpwalls06
It says right there at Fast Automotive.

It says right there at Fast Automotive.
Forum: Forced Induction - V8 03-01-2014, 06:51 PM
Replies: 936
Views: 104,276
Posted By kpwalls06
Whew, glad I didn't misread that part of the AEM...

Whew, glad I didn't misread that part of the AEM install instructions!!

And I would've text you, but I'm offshore again. Three weeks of thinking about all the work I get to do on the car when I...
Forum: Forced Induction - V8 03-01-2014, 06:31 PM
Replies: 936
Views: 104,276
Posted By kpwalls06
My AGP kit came with four O2 bungs in the turbine...

My AGP kit came with four O2 bungs in the turbine discharge pipe, and since I'm only running two O2 sensors, I'm using one of those bungs for my AEM Wideband Sensor, and just going to plug the other...
Forum: Forced Induction - V8 02-25-2014, 10:52 AM
Replies: 69
Views: 4,661
Posted By kpwalls06
Thanks for the offer, I may take you up on it! ...

Thanks for the offer, I may take you up on it! I'm also installing a Fore Innovations fuel system at the same time, so it's gonna take me a bit to get it all finished.
Forum: Forced Induction - V8 02-22-2014, 07:23 PM
Replies: 69
Views: 4,661
Posted By kpwalls06
Gents, let me chime in for a second. I'm in the...

Gents, let me chime in for a second. I'm in the midst of installing an AGP TT kit in my garage, with the car on jackstands, and I've done everything (I mean absolutely everything) so far by myself. ...
Showing results 1 to 30 of 282

 
Forum Jump

All times are GMT -5. The time now is 12:52 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2016, vBulletin Solutions, Inc.