Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
ADM PERFORMANCE
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 66
Search took 0.02 seconds.
Search: Posts Made By: quinthawk
Forum: Forced Induction - V8 03-06-2013, 10:46 AM
Replies: 13
Views: 683
Posted By quinthawk
ID850s install tips on a maggie

About to install ID850s on my maggie. Does anybody have any tips to make the install easier?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-25-2013, 11:09 AM
Replies: 44
Views: 4,278
Posted By quinthawk
Alvin, If I could get by without taking the...

Alvin,
If I could get by without taking the heads off and replacing the lifters, I would consider the LS9 cam swap. Do you think the lifters can handle this cam?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-24-2013, 09:03 PM
Replies: 44
Views: 4,278
Posted By quinthawk
L99 cam specs: 0.500-inch intake/0.492-inch...

L99 cam specs: 0.500-inch intake/0.492-inch exhaust lift, 195-degrees of duration intake and 201-degrees of duration on the exhaust
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-24-2013, 08:11 PM
Replies: 44
Views: 4,278
Posted By quinthawk
If the L99 lifters could handle the additional...

If the L99 lifters could handle the additional lift, it looks like a good power increase.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-24-2013, 07:41 PM
Replies: 44
Views: 4,278
Posted By quinthawk
LS9 cam swap into L99 ?

The March issue of GM High Tech Performance has an article installing the LS9 cam in a 6.2 truck engine with DOD/VVT. The article says it can be installed in L99s. The valve springs were swapped for...
Forum: Wheels / Tires 01-23-2013, 07:23 PM
Replies: 192
Views: 45,618
Posted By quinthawk
Will the Tanaka 20x10.5 fit both the front and...

Will the Tanaka 20x10.5 fit both the front and back on an SS.
Forum: Forced Induction - V8 11-24-2012, 07:13 PM
Replies: 14
Views: 727
Posted By quinthawk
Anybody have this gauge on a Camaro, can you read...

Anybody have this gauge on a Camaro, can you read injector duty cycle?
Forum: Forced Induction - V8 11-23-2012, 02:53 PM
Replies: 14
Views: 727
Posted By quinthawk
Interceptor, just got it from Maryland Speed.

Interceptor, just got it from Maryland Speed.
Forum: Forced Induction - V8 11-22-2012, 04:57 PM
Replies: 14
Views: 727
Posted By quinthawk
Idc% is not an option in the list. Don't know why...

Idc% is not an option in the list. Don't know why it is not there.
Forum: Forced Induction - V8 11-22-2012, 01:41 PM
Replies: 14
Views: 727
Posted By quinthawk
What is the description in the list?

What is the description in the list?
Forum: Forced Induction - V8 11-22-2012, 09:36 AM
Replies: 14
Views: 727
Posted By quinthawk
Thanks for the help.

Thanks for the help.
Forum: Forced Induction - V8 11-22-2012, 09:19 AM
Replies: 14
Views: 727
Posted By quinthawk
Anybody with the Interceptor able to see injector...

Anybody with the Interceptor able to see injector duty cycle on the gauge?
Forum: Forced Induction - V8 11-21-2012, 10:08 PM
Replies: 14
Views: 727
Posted By quinthawk
I don't see it in the list. Anybody know how it...

I don't see it in the list. Anybody know how it is described?
Forum: Forced Induction - V8 11-21-2012, 08:59 PM
Replies: 14
Views: 727
Posted By quinthawk
Aeroforce gauge ?

Does the aeroforce display injector duty cycle?
Forum: Forced Induction - V8 10-25-2012, 03:40 PM
Replies: 8
Views: 585
Posted By quinthawk
Thanks

Thanks
Forum: Forced Induction - V8 10-25-2012, 02:30 PM
Replies: 8
Views: 585
Posted By quinthawk
Is a retune required with a ZL1 fuel pump?

Ordered a ZL1 fuel pump, will I have to retune after I install the pump?
Forum: Forced Induction - V8 10-24-2012, 08:45 PM
Replies: 17
Views: 1,510
Posted By quinthawk
How much boost should I have with 3.4 pulley

L99, maggie with 3.4, JRE supertensioner, headers, cai, msd fpvb. I usually get 8.5-8.7. I have a zr1 map sensor. Does this seem low?
Forum: Forced Induction - V8 09-11-2012, 08:16 AM
Replies: 3
Views: 382
Posted By quinthawk
Maggie rear belt torque spec?

I will be putting a new rear belt on my Maggie. Anybody know the torque spec for the set screw? I have the standard rib drive, not a cog drive.
Forum: Forced Induction - V8 08-24-2012, 10:20 PM
Replies: 9
Views: 811
Posted By quinthawk
Maggie rear belt slip ?

How much boost can the rear belt take until it starts to slip? I am running a little over 8 lbs of boost and have the supertensioner with a 3.5 pulley. I can hear what sounds like possible belt...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 02-03-2012, 11:23 AM
Replies: 9
Views: 864
Posted By quinthawk
I have these on my 2wd trailblazer ss. The...

I have these on my 2wd trailblazer ss. The traction in snow and rain has been very good. Even with 2wd, I don't have any problems in the snow. I think it is a good tire for the money.
Forum: Forced Induction - V8 11-15-2011, 11:19 AM
Replies: 75
Views: 8,003
Posted By quinthawk
Which cam has a smoother idle?

Which cam has a smoother idle?
Forum: Forced Induction - V8 07-18-2011, 03:09 PM
Replies: 4
Views: 478
Posted By quinthawk
thanks

thanks
Forum: Forced Induction - V8 07-18-2011, 02:04 PM
Replies: 4
Views: 478
Posted By quinthawk
Maggie install question

What is the best way to tighten the bolt that is covered by the rear pulley on the passenger side?
Forum: Forced Induction - V8 07-04-2011, 11:41 PM
Replies: 32
Views: 2,049
Posted By quinthawk
I have the same light seepage with grunge, I...

I have the same light seepage with grunge, I always wondered if this was normal.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-13-2011, 01:46 PM
Replies: 15
Views: 896
Posted By quinthawk
I would add a few washers to give a little more...

I would add a few washers to give a little more space, I think this would get rid of the noises.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-13-2011, 10:58 AM
Replies: 15
Views: 896
Posted By quinthawk
I added the same resonated x-pipe as you did on...

I added the same resonated x-pipe as you did on my l99. I had to add a few washers to the brace to space it down. This stopped the pipes from hitting the tunnel brace.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-11-2011, 10:45 AM
Replies: 15
Views: 1,074
Posted By quinthawk
My shifter rattles only when it is in...

My shifter rattles only when it is in manual/sport mode. It does not rattle in D. Pretty irritating.
Forum: Wheels / Tires 04-07-2011, 03:41 PM
Replies: 10
Views: 3,462
Posted By quinthawk
Are these available in 20" ? If so what is the...

Are these available in 20" ? If so what is the cost.
Forum: Wheels / Tires 03-09-2011, 09:39 PM
Replies: 66
Views: 11,958
Posted By quinthawk
Any chance the 10.5" wheel would fit up front...

Any chance the 10.5" wheel would fit up front with a 275 tire?
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 11-15-2010, 07:14 PM
Replies: 15
Views: 1,608
Posted By quinthawk
I have the same problem, the rattle only occurs...

I have the same problem, the rattle only occurs in M and not in D.
Showing results 1 to 30 of 66

 
Forum Jump

All times are GMT -5. The time now is 05:47 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.