Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
JDP Motorsports
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 162
Search took 0.03 seconds.
Search: Posts Made By: BC 2010
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-15-2014, 02:11 PM
Replies: 36
Views: 1,178
Posted By BC 2010
No and No

No and No
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 07-05-2014, 06:52 PM
Replies: 154
Views: 7,994
Posted By BC 2010
I did separate reservoir and IDEAL modified...

I did separate reservoir and IDEAL modified clutch master cylinder two years ago,
then now the clutch slave cylinder bleed screw is loose and leak fluid till I had no
clutch pedal.
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 07-05-2014, 06:31 PM
Replies: 154
Views: 7,994
Posted By BC 2010
Check your bleed screw on your clutch slave...

Check your bleed screw on your clutch slave cylinder it could have loosen up just
enough to lose fluid.
Forum: Tuning / Diagnostics -- engine and transmission 07-02-2014, 10:23 AM
Replies: 5
Views: 651
Posted By BC 2010
I have your problem, car is running rough. plugs...

I have your problem, car is running rough. plugs were change. Wires, coil packs check out good, did compression check on #3 175 lbs. Took to the
dealer yesterday and see what they came up with. I'm...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 06-21-2014, 08:12 PM
Replies: 118
Views: 5,954
Posted By BC 2010
Smile I did this two to three years ago. At that time...

I did this two to three years ago. At that time the only tow hook available
was the flat type which I did not want. I like your design and product. that
was my idea back then and I had it...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 06-21-2014, 06:51 PM
Replies: 118
Views: 5,954
Posted By BC 2010
This is my camaro using factory tow hooks, the...

This is my camaro using factory tow hooks, the mounts were welded on the impact bar. The front is the same as rear. The front screws in through the
one of the openings in the grille, had this done...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 06-19-2014, 10:03 AM
Replies: 33
Views: 1,366
Posted By BC 2010
Check out Street Slayer clutches by Hendrix, no...

Check out Street Slayer clutches by Hendrix, no complaint's.
Forum: USA - California 05-01-2014, 04:37 PM
Replies: 4
Views: 301
Posted By BC 2010
Welcome to the island, as you will find out. In...

Welcome to the island, as you will find out. In Ventura there's the Ventura County Camaro Club you can find on F.B. , Pm Me. There's a car show at Paradise Chevrolet
In Ventura May 10th.
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 04-29-2014, 09:07 PM
Replies: 31
Views: 1,216
Posted By BC 2010
I just had Mod Bargains install F14 10x19 on all...

I just had Mod Bargains install F14 10x19 on all four with 285/40 Michelin pilot super sport. Camaro looks great. Still on stock springs. Coil overs in the near future.Thanks Jurrian for great...
Forum: Camaro 1LE Forum 04-01-2014, 05:57 PM
Replies: 20
Views: 795
Posted By BC 2010
[QUOTE=Victoryred1le;7542892]I want to get a set...

[QUOTE=Victoryred1le;7542892]I want to get a set of 18's for hpde events. Just wondering what else is out there other than ccw?[/QUOTE

20x9s factory on all fours now.Will be running F14s 19x10s...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-25-2014, 10:22 AM
Replies: 6
Views: 466
Posted By BC 2010
My installer recommend the heat cycle vary speed...

My installer recommend the heat cycle vary speed and at least 200 miles Before going on the road course or hard driving.:nod:
Forum: Cosmetics and Lighting Modification Discussions 03-21-2014, 06:26 PM
Replies: 28
Views: 1,233
Posted By BC 2010
I would be on the phone if my had that much wave...

I would be on the phone if my had that much wave and requesting replacement now.:facepalm:
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-21-2014, 12:09 PM
Replies: 42
Views: 2,517
Posted By BC 2010
In your paper work with gears (1-2 pages) your...

In your paper work with gears (1-2 pages) your dealer calls Gm for calibration code and labor code.Pretty self explanatory.
Forum: USA - California 03-21-2014, 10:42 AM
Replies: 32,322
Views: 463,114
Posted By BC 2010
I'm planning to be at Chuckwalla April 5. Will...

I'm planning to be at Chuckwalla April 5. Will see you guys there.
Forum: Cosmetics and Lighting Modification Discussions 03-21-2014, 10:32 AM
Replies: 28
Views: 1,233
Posted By BC 2010
When I Install my anvil I use the 1/8 inch form...

When I Install my anvil I use the 1/8 inch form tape. tape was flexible to go around mount holes like washers,copy the factory tape install pattern too.
water proof, with drainage at center of...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-21-2014, 10:15 AM
Replies: 42
Views: 2,517
Posted By BC 2010
Everyone that receive kit #19301504 can take your...

Everyone that receive kit #19301504 can take your camaro to dealer after install,
(doesn't matter who did install) and get your speeddo recalibrate for free.Make sure
you take paper work to dealer...
Forum: Road Course/Track and Autocross 03-17-2014, 04:34 PM
Replies: 34
Views: 1,843
Posted By BC 2010
Virus, I like your roll bar. Is that RPM 4 point?

Virus, I like your roll bar. Is that RPM 4 point?
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-17-2014, 10:21 AM
Replies: 42
Views: 2,517
Posted By BC 2010
Yes:frown:

Yes:frown:
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-14-2014, 01:01 PM
Replies: 14
Views: 778
Posted By BC 2010
I had the Hurst with the bronze bushing it...

I had the Hurst with the bronze bushing it help,went to a MGW, overall I wish I bought
the MGW first .Out performs the Hurst by by 100%.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-14-2014, 10:28 AM
Replies: 42
Views: 2,517
Posted By BC 2010
Dealer will do recalibration next week.When your...

Dealer will do recalibration next week.When your gear set arrives there's
a spec sheet that will pretty much answer your questions. I'm not to much
about warranty, my expires in Aug. I have less...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-13-2014, 05:22 PM
Replies: 42
Views: 2,517
Posted By BC 2010
Cool I just had the complete kit #19301503 install by...

I just had the complete kit #19301503 install by differential co.Inside the
kit is a installation sheet that has the info for dealer to recalibrate the
speedo. Its say no cost to the purchaser of...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-07-2014, 12:42 PM
Replies: 98
Views: 6,660
Posted By BC 2010
Just pick up my full kit.

Just pick up my full kit.
Forum: Cosmetics and Lighting Modification Discussions 03-07-2014, 09:51 AM
Replies: 14
Views: 554
Posted By BC 2010
Got my yesterday, Thanks JDP

Got my yesterday, Thanks JDP
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-06-2014, 10:20 AM
Replies: 98
Views: 6,660
Posted By BC 2010
Just got a call from my cousin (auto mechanic)...

Just got a call from my cousin (auto mechanic) parts dept call said the complete
gear set is being shipped.:happyanim:
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-02-2014, 01:34 PM
Replies: 98
Views: 6,660
Posted By BC 2010
What I think Rick received was just the ring...

What I think Rick received was just the ring and pinion #22813040. I had the chance to pick that up from vendor a couple times, but decided to wait for the complete it kit from gm #19301504....
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-01-2014, 04:05 PM
Replies: 98
Views: 6,660
Posted By BC 2010
That's what I figure.

That's what I figure.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 02-28-2014, 08:34 PM
Replies: 98
Views: 6,660
Posted By BC 2010
YES, I order my 3 weeks ago. still no date on...

YES, I order my 3 weeks ago. still no date on delivery:noidea: I don't see
any vendors saying they have them to ship out :noidea: maybe next
week.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 02-28-2014, 05:21 PM
Replies: 98
Views: 6,660
Posted By BC 2010
Is this available to purchase from dealer NOW ?

Is this available to purchase from dealer NOW ?
Forum: California Meets and Events 02-17-2014, 09:29 PM
Replies: 197
Views: 5,503
Posted By BC 2010
Just sent you a pm on CaliPhotography track...

Just sent you a pm on CaliPhotography track pictures. I have yours.:facepalm:
Forum: California Meets and Events 02-12-2014, 06:09 PM
Replies: 197
Views: 5,503
Posted By BC 2010
Saturday only

Saturday only
Showing results 1 to 30 of 162

 
Forum Jump

All times are GMT -5. The time now is 05:52 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.