Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Apex Paul
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 48
Search took 0.01 seconds.
Search: Posts Made By: mnvaughn
Forum: 5th Gen Camaro SS LS LT General Discussions 07-19-2015, 05:32 PM
Replies: 95
Views: 2,990
Posted By mnvaughn
http://i.imgur.com/cPSMG5L.jpg A 2011...

http://i.imgur.com/cPSMG5L.jpg

A 2011 2SS/RS. I love my ZL1, but my SS always looked so good to me
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 06-20-2015, 08:58 PM
Replies: 12
Views: 1,482
Posted By mnvaughn
I just used these instructions to change my...

I just used these instructions to change my clutch and it made changing the clutch 1000x easier. I've never had a transmission drop performed so easily and these instructions really really helped.
Forum: ZL1 Parts 06-07-2015, 06:35 PM
Replies: 2
Views: 536
Posted By mnvaughn
is this still available?

is this still available?
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 05-29-2015, 12:26 AM
Replies: 7
Views: 796
Posted By mnvaughn
I just went with 68", it's not in the middle but...

I just went with 68", it's not in the middle but it's not as tensioned as the 67.5" was. I'm in the exact same setup as you are too. Did you end up replacing your AC belt with a new one when you put...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-27-2015, 09:01 PM
Replies: 276
Views: 93,445
Posted By mnvaughn
http://i.imgur.com/UYza9jB.jpg So hard to...

http://i.imgur.com/UYza9jB.jpg

So hard to keep clean, but when it is, it's damn sexy
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-25-2015, 11:42 AM
Replies: 17
Views: 960
Posted By mnvaughn
Thanks for the info. And yes, it is fairly low...

Thanks for the info. And yes, it is fairly low but I've been wanting to take it to the strip for such a long time and now finally have the time to do it. I've practiced numerous times on the streets...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-25-2015, 09:51 AM
Replies: 17
Views: 960
Posted By mnvaughn
So based off all this, I'm going to spin like a...

So based off all this, I'm going to spin like a mutha. Launching wise should I stick to ptm modes and use launch control? Or just launch at a comfortable RPM? Also is any of this too risky with stock...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-25-2015, 12:44 AM
Replies: 17
Views: 960
Posted By mnvaughn
First time dragging

Alright so next Saturday is going to be my first time drag racing my ZL1. It is not stock, and it put down 600RWHP on the dyno last week. My tires are Continental DWS's. I know that I'm probably...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 05-24-2015, 09:34 AM
Replies: 7
Views: 796
Posted By mnvaughn
Yeah, i'm exactly at the end point of the...

Yeah, i'm exactly at the end point of the markers, I'll go up a belt size. Still not certain though if this is the belt thats slipping or not. I hope it's not the AC belt because that was tough to...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 05-23-2015, 04:26 PM
Replies: 7
Views: 796
Posted By mnvaughn
I'll go get myself a 68" and see if that helps...

I'll go get myself a 68" and see if that helps out. Turning on and off the AC has made no difference on when the squeaking starts, so i'm not certain. I may take off the belt, run without AC for a...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 05-23-2015, 01:27 PM
Replies: 7
Views: 796
Posted By mnvaughn
Belt slipping a little after lower pulley install

I recently just put on a 9.17 crank pulley myself and got it tuned, but i noticed that now sometimes in lower rpms, i can hear a bit of belt squeal from one of the belts slipping. I'm using 67.5"...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 03-17-2015, 09:13 PM
Replies: 9
Views: 806
Posted By mnvaughn
Perfect! Thanks for the quick response!

Perfect! Thanks for the quick response!
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 03-17-2015, 09:05 PM
Replies: 9
Views: 806
Posted By mnvaughn
Crank Pulley Install Tools

In November I had an ATI lower pulley installed on my car and I had to take it off due to the supercharger recall. Install and removal cost 700 dollars each by my tuner. I now plan to reinstall my...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-27-2015, 10:29 PM
Replies: 68
Views: 4,911
Posted By mnvaughn
I'm not sure how much of it is the dealership or...

I'm not sure how much of it is the dealership or GM. When I had my supercharger replaced for the rattle I had long-tube headers, cold-air intake and a tune (put stock tune back before I took it in)....
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-19-2015, 11:22 AM
Replies: 20
Views: 1,092
Posted By mnvaughn
Based off all the posts, I've read this is what I...

Based off all the posts, I've read this is what I believe you need.

1. New Crank Assembly (ATI Super Damper)
2. New Serpentine Belt (You can find size on the chart)
3. New Crank Pulley (the...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-18-2015, 08:57 PM
Replies: 20
Views: 1,092
Posted By mnvaughn
I went ahead and ordered the LPE relocation...

I went ahead and ordered the LPE relocation bracket.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-18-2015, 06:09 PM
Replies: 20
Views: 1,092
Posted By mnvaughn
No clearance problems at all?

No clearance problems at all?
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-18-2015, 02:23 PM
Replies: 20
Views: 1,092
Posted By mnvaughn
I've probably asked you a million questions this...

I've probably asked you a million questions this week, but one more question. Would you recommend the Lingenfelter relocation bracket or the Metco brand?
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-18-2015, 12:49 PM
Replies: 20
Views: 1,092
Posted By mnvaughn
I'm getting confused though if either is...

I'm getting confused though if either is necessary. If I don't purchase the relocation bracket then I have to purchase the 50mm idler?
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-18-2015, 11:38 AM
Replies: 20
Views: 1,092
Posted By mnvaughn
Idler Relocation Bracket Needed???

Do 9.17" lower pulleys need the idler relocation bracket? I recently had the supercharger replaced and had a 8.86" pulley prior to replacement. Now with my new supercharger I'm going to add injectors...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-18-2015, 01:10 AM
Replies: 299
Views: 38,675
Posted By mnvaughn
Sorry I edited to add another sentence and make...

Sorry I edited to add another sentence and make my statement correct. But yes the dealers service department did not seem competent about the situation. But in my opinion all the ZL1's from 2012-2013...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-18-2015, 01:05 AM
Replies: 299
Views: 38,675
Posted By mnvaughn
I just got mine replaced this last week. Not too...

I just got mine replaced this last week. Not too fun of a situation. For one, the service advisor had never heard about the problem (mine was bad, the rattle went immediatley to the squeal within a...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-14-2015, 08:53 PM
Replies: 46
Views: 3,500
Posted By mnvaughn
When you guys speak about FIC do you mean Fuel...

When you guys speak about FIC do you mean Fuel Injection Clinic or Fuel Injection Connection? My tuner recommended Fuel Injection Clinic's injectors and has used them several times on some CTS-V's.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-02-2015, 11:15 PM
Replies: 14
Views: 1,144
Posted By mnvaughn
Just found this in the forum, it's the...

Just found this in the forum, it's the supercharger....

http://www.camaro5.com/forums/showthread.php?t=298912
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-02-2015, 10:56 PM
Replies: 14
Views: 1,144
Posted By mnvaughn
I'm just not sure what it is, I'm kinda in...

I'm just not sure what it is, I'm kinda in over-reaction mode because the car is my most favorite thing. So after watching videos, I don't believe the supercharger is rattling because i did not hear...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-02-2015, 06:18 PM
Replies: 14
Views: 1,144
Posted By mnvaughn
Took off my supercharger belt and sound went...

Took off my supercharger belt and sound went away, did this multiple times to verify. The supercharger is making the rattle and now with the whine this verifies that my supercharger is failing. I'm...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-02-2015, 01:57 PM
Replies: 1
Views: 448
Posted By mnvaughn
Anyone have a ZL1 Belt diagram?

Need a ZL1 belt diagram, thanks in advance!
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 12-29-2014, 12:10 PM
Replies: 14
Views: 1,144
Posted By mnvaughn
Started the car this morning, and no sound. The...

Started the car this morning, and no sound. The plan today is to remove the belt and hand spin the pulleys and also check the belt.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 12-28-2014, 11:52 PM
Replies: 14
Views: 1,144
Posted By mnvaughn
I'll give this a try tomorrow and see if it...

I'll give this a try tomorrow and see if it happens again. When you say that you heard this on yours, was it consistent or did it vary in time and length of it happening?
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 12-28-2014, 11:13 PM
Replies: 14
Views: 1,144
Posted By mnvaughn
The problem is that it's not consistent. It...

The problem is that it's not consistent. It doesn't happen every morning, and it's happened even in the mid-afternoon. So I'm not sure how to diagnose this at all. And it only lasts a few seconds to...
Showing results 1 to 30 of 48

 
Forum Jump

All times are GMT -5. The time now is 11:07 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.