Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Cam Motion
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 234
Search took 0.05 seconds.
Search: Posts Made By: obe1
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 01-28-2015, 02:20 PM
Replies: 11
Views: 596
Posted By obe1
I too have used the Ctek 3300 for years. My 95...

I too have used the Ctek 3300 for years. My 95 Z28 is on a Ctek all the time as I only drive it on weekends; same battery for the past 9 years.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 01-28-2015, 02:17 PM
Replies: 5
Views: 446
Posted By obe1
Thank you for the reply. I believe an minimum...

Thank you for the reply. I believe an minimum coolant pressure is required to activate the system.I
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 01-26-2015, 10:12 PM
Replies: 5
Views: 446
Posted By obe1
Air conditioning blows cold on passenger side but not drivers side?

Center vent passenger side blows cold air but the center vent drivers side blows outside temp (80 degrees today)? Is there a "air routing control" for side to side action?
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 07-19-2014, 04:58 PM
Replies: 5
Views: 1,160
Posted By obe1
Reviving an old thread; my Helms manual for the...

Reviving an old thread; my Helms manual for the LS3 calls for .060" gap as the first post states - this has to be wrong! The 90K used plug gap is .040" and the new AC Delco 41-110 plugs come gapped...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2014, 04:47 PM
Replies: 48
Views: 8,226
Posted By obe1
Someone in another thread posted that the...

Someone in another thread posted that the fasteners can be found at Clipsandfasteners.com. P/N A21301 and A21302; $12 for 25 screws and $12 for $25 nuts. Shipping is about $6. Total $30 for a set...
Forum: USA - California 09-14-2013, 02:55 PM
Replies: 22
Views: 1,511
Posted By obe1
After I lower mine I had it aligned at Clarence...

After I lower mine I had it aligned at Clarence Brown. 60K miles later 2 sets of tires have worn very evenly and it handles great.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 10-14-2012, 02:22 PM
Replies: 6
Views: 577
Posted By obe1
I've been using the CTEK 3300 for over 6 years...

I've been using the CTEK 3300 for over 6 years and love it! http://www.amazon.com/Multi-12-Volt-Smart-Battery-Charger/dp/B000FQBWCY
My Z28 only gets driven occasionally so I leave it plugged into...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-02-2012, 08:51 PM
Replies: 51
Views: 3,848
Posted By obe1
First mod was adding 6 X 9 coaxial speakers, FM...

First mod was adding 6 X 9 coaxial speakers, FM and casette player in my 68 Camaro..got to have good tunes!
Forum: USA - California 07-15-2012, 02:25 PM
Replies: 2
Views: 498
Posted By obe1
What temperature was it? I run out on the big...

What temperature was it? I run out on the big track at Willow (the Streets of Willow is the small track) but not during the heat of the summer.
Forum: Suspension / Brakes / Chassis 07-15-2012, 01:55 PM
Replies: 6
Views: 1,896
Posted By obe1
The stock pads with the SS Brembo system have...

The stock pads with the SS Brembo system have good stopping power, the problem is that they generate a lot of brake dust and get your rims dirty quickly. I swithced to the Hawk Ceramic pads that...
Forum: Suspension / Brakes / Chassis 07-15-2012, 01:52 PM
Replies: 7
Views: 866
Posted By obe1
I've been running with the Hawk Ceramic pads on...

I've been running with the Hawk Ceramic pads on my 2SS for 38,000 miles. Greatly reduced bake dust, occasional squeal but not very often and equal stopping power to the original pads.
Forum: Vendor and Seller review / feedback / experiences 06-23-2012, 01:37 PM
Replies: 6
Views: 684
Posted By obe1
Thumbs up JDP Motorsports

:thumbsup::thumbsup: Great customer support! I ripped a connector gasket (my fault) during installation of their colored halo kit; they had a replaceent to me 2 days later. The colored halo kit is...
Forum: Camaro DIY & HOW-TO instructions & discussions 04-25-2012, 11:31 PM
Replies: 15
Views: 5,931
Posted By obe1
I have the Infinity setup and no whine :iono:

I have the Infinity setup and no whine :iono:
Forum: Suspension / Brakes / Chassis 02-26-2012, 06:32 PM
Replies: 33
Views: 2,344
Posted By obe1
I see you have a 2012; I believe your end links...

I see you have a 2012; I believe your end links are located in a different position from my 2010.
Forum: Suspension / Brakes / Chassis 02-23-2012, 10:08 AM
Replies: 33
Views: 2,344
Posted By obe1
The Spohn end links are rattle boxes. I bought...

The Spohn end links are rattle boxes. I bought them as they were one of the lower cost solutions but couldn't stand the noise.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-17-2012, 12:44 AM
Replies: 103
Views: 9,202
Posted By obe1
Mine only grinds when the fluid is cold. Using...

Mine only grinds when the fluid is cold. Using the MGW shifter. 34,000 miles. Plan to install RP fluid to see if that helps.
Forum: Cosmetics and Lighting Modification Discussions 02-03-2012, 11:39 PM
Replies: 8
Views: 993
Posted By obe1
http://i1197.photobucket.com/albums/aa439/Obe195z2...

http://i1197.photobucket.com/albums/aa439/Obe195z28/Roto-FabEnginecover.jpg
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 01-21-2012, 01:22 PM
Replies: 4
Views: 879
Posted By obe1
Both of my seat heaters failed simultaneously...

Both of my seat heaters failed simultaneously (not even a momentary light on the switch). Removed the 25A fuse and it was fine. Took it to the dealer (still under warranty) and they replaced the...
Forum: Camaro DIY & HOW-TO instructions & discussions 01-01-2012, 01:19 AM
Replies: 6
Views: 860
Posted By obe1
Check here:...

Check here: http://www.camaro5.com/forums/showthread.php?t=142406
Forum: Camaro Photos | Spyshots | Video | Media Gallery 10-31-2011, 08:07 PM
Replies: 33
Views: 4,275
Posted By obe1
Get looking billet valve covers made in the US...

Get looking billet valve covers made in the US here: http://store.billetcustomproducts.com/cshbivacols3.html
Forum: 5th Gen Camaro SS LS LT General Discussions 10-31-2011, 02:34 PM
Replies: 55
Views: 3,087
Posted By obe1
Another vote for the Hawk ceramic pads. I...

Another vote for the Hawk ceramic pads. I installed these at 2,000 miles as I was tired of the dirty rims. I've now got 30,000 miles on the car and have been very pleased with the minimal amount of...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-28-2011, 10:48 PM
Replies: 112
Views: 9,612
Posted By obe1
Service manual states to replace the TB gasket;...

Service manual states to replace the TB gasket; is this overkill? Are you guys reusing your TB gasket when swapping TB's?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-28-2011, 09:33 AM
Replies: 167
Views: 11,836
Posted By obe1
I spoke with the Parts Dept at Hendrick Chevrolet...

I spoke with the Parts Dept at Hendrick Chevrolet this morning and as I suspected that sent me the heater hose based on my VIN number, even though my order confirmation email stated the part number I...
Forum: Suspension / Brakes / Chassis 10-27-2011, 11:19 PM
Replies: 6
Views: 599
Posted By obe1
Search function is your friend! This post in...

Search function is your friend! This post in only ten down on the list from your post.

http://www.camaro5.com/forums/showthread.php?t=153188
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-27-2011, 11:15 PM
Replies: 167
Views: 11,836
Posted By obe1
I ordered P/N 19259242 from Hendrick Chevrolet...

I ordered P/N 19259242 from Hendrick Chevrolet about 2 weeks ago; box showed up today with the 2010 "over the intake" style heater hoses labeled P/N 2278647. Best I can figure is they used my VIN...
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 10-27-2011, 06:44 PM
Replies: 3
Views: 1,222
Posted By obe1
Thanks!

Thanks!
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 10-26-2011, 12:28 AM
Replies: 3
Views: 1,222
Posted By obe1
Ghost Armor cleaning

I've got ghost armor installed over my stock BA audio faceplate. What do you guys recommend to clean/revive it?
Forum: Cosmetics and Lighting Modification Discussions 10-26-2011, 12:13 AM
Replies: 9
Views: 1,906
Posted By obe1
Another vote for Lloyd's; very plush.

Another vote for Lloyd's; very plush.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 10-16-2011, 10:49 PM
Replies: 10
Views: 1,254
Posted By obe1
The Costco deal with the $10 of coupon is the...

The Costco deal with the $10 of coupon is the best I've found also. Around here in San Diego Costco sells a 6 pack for $37.95. Using the $10 off coupon gets you down to $4.66 a quart.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 10-16-2011, 10:45 PM
Replies: 3
Views: 524
Posted By obe1
Is your filter a dry or oiled filter? My Rotofab...

Is your filter a dry or oiled filter? My Rotofab CAI was available in both styles; I chose the oiled filter. These are cleanable; K&N has a cleaning kit that includes a cleaning spray and oil to...
Showing results 1 to 30 of 234

 
Forum Jump

All times are GMT -5. The time now is 09:07 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.