Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Emblempros
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.06 seconds.
Search: Posts Made By: mrvenicess
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 04-05-2018, 02:44 PM
Replies: 5
Views: 822
Posted By mrvenicess
My trans went 50,000 miles before it went. Twice...

My trans went 50,000 miles before it went. Twice a week at the drag strip plus some 1/2 mile runs. When it went I was putting down 744 whp. Have since beefed it up with parts from PATC and it has...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 03-06-2018, 03:14 PM
Replies: 23
Views: 1,134
Posted By mrvenicess
Hope to be back at the track with you again soon!

Hope to be back at the track with you again soon!
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 03-06-2018, 06:48 AM
Replies: 23
Views: 1,134
Posted By mrvenicess
I'm running Fore triple pump system with ID1700s...

I'm running Fore triple pump system with ID1700s so plenty of fuel, just bottlenecked at the rails. I have a set of Fore billet rails to use when it goes back together unless I decide to make the...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 03-05-2018, 03:24 PM
Replies: 12
Views: 412
Posted By mrvenicess
647 on 93. I figure on 40 hp from the headers and...

647 on 93. I figure on 40 hp from the headers and the 2.35 over the 2.55 will make up the boost you lose from the headers.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 03-05-2018, 01:33 PM
Replies: 23
Views: 1,134
Posted By mrvenicess
It had been tuned but it looks like it ran out of...

It had been tuned but it looks like it ran out of fuel. Those stock fuel rails are tiny and have so many 90 degree bends it looks like the number 2 cylinder ran out of fuel.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 03-05-2018, 12:09 PM
Replies: 23
Views: 1,134
Posted By mrvenicess
It is on E85. It actually revs to 8,000! Factory...

It is on E85. It actually revs to 8,000! Factory blower, stock bottom end. The 810 was made before any real tuning on it but it melted a piston as we still ran the stock fuel rails. I'm in the...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 03-05-2018, 06:53 AM
Replies: 23
Views: 1,134
Posted By mrvenicess
My car put out 810 to the wheels on a Mustang...

My car put out 810 to the wheels on a Mustang dyno. A6.
Forum: USA - Florida 01-23-2018, 06:17 AM
Replies: 532
Views: 61,453
Posted By mrvenicess
It was a new build. 8,000 rpm redline, E85 etc....

It was a new build. 8,000 rpm redline, E85 etc. Stock rails are supposed to be good for 800+ hp. On FSPs Mustang dyno we made 810 whp and with the high rpms it looks like it ran lean. FSP was in the...
Forum: USA - Florida 01-19-2018, 06:47 AM
Replies: 532
Views: 61,453
Posted By mrvenicess
After we rebuilt it I managed to make 5 passes at...

After we rebuilt it I managed to make 5 passes at the track before it burnt a piston! Was running strong and was getting quicker but it looks like the stock fuel rails were not up to the task....
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-15-2018, 06:42 AM
Replies: 9
Views: 699
Posted By mrvenicess
I'm also going for a Dart next ls block. I run a...

I'm also going for a Dart next ls block. I run a solid lifter cam with Jesel rockers.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-12-2018, 06:34 AM
Replies: 9
Views: 699
Posted By mrvenicess
Id be interested too. I'm in the same situation...

Id be interested too. I'm in the same situation with an 8,000 rpm redline.
Forum: USA - Florida 01-03-2018, 06:32 AM
Replies: 532
Views: 61,453
Posted By mrvenicess
I hope to have my Z back on the road by the end...

I hope to have my Z back on the road by the end of Feb.
Forum: 5th Gen Camaro SS LS LT General Discussions 12-14-2017, 06:32 AM
Replies: 37
Views: 1,442
Posted By mrvenicess
Either the time I drove the Tail of The Dragon or...

Either the time I drove the Tail of The Dragon or the first time I ran a 9 second 1/4 mile.
Forum: 5th Gen Camaro SS LS LT General Discussions 12-14-2017, 06:30 AM
Replies: 21
Views: 1,384
Posted By mrvenicess
What gear are you in? You should be in 4th.

What gear are you in? You should be in 4th.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 11-29-2017, 06:47 AM
Replies: 8
Views: 699
Posted By mrvenicess
Ran Ocala a few years ago and went 160 fighting...

Ran Ocala a few years ago and went 160 fighting for traction the whole way. New high revving set up should be ready soon, hope to go 175.
Forum: USA - Florida 10-09-2017, 06:49 AM
Replies: 8
Views: 824
Posted By mrvenicess
Wish I had my car back together! Hopefully by...

Wish I had my car back together! Hopefully by year end.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 07-20-2017, 03:50 PM
Replies: 15
Views: 1,073
Posted By mrvenicess
I used to daily drive mine until I got to 800...

I used to daily drive mine until I got to 800 whp. Now I daily one of those 420 hp Silverados. I leased my truck so I'm not tempted to mess with it though it really needs a cai and a tune ! 97 mph...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-20-2017, 03:45 PM
Replies: 76
Views: 5,610
Posted By mrvenicess
If you have less than 500 whp you have to remove...

If you have less than 500 whp you have to remove them. The GM guys in the black suburbans will come and get you if you don't.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 07-03-2017, 06:36 AM
Replies: 17
Views: 2,305
Posted By mrvenicess
I ran high 9s with 744 whp but have 17" drs...

I ran high 9s with 744 whp but have 17" drs on.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-28-2017, 03:45 PM
Replies: 3
Views: 403
Posted By mrvenicess
I had a Borla S type on my old SS from day 1. A...

I had a Borla S type on my old SS from day 1. A while later I installed Kooks LTs and cats and it all went together no problem. If it drones too much you may consider adding the Solo J pipes.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 03-27-2017, 07:46 AM
Replies: 10
Views: 1,356
Posted By mrvenicess
On my latest build we went to solid lifters with...

On my latest build we went to solid lifters with Jesel rockers. I rev it to 8,000 rpm, it does scream! I'm told I will need to adjust valves about once a year.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 12-01-2016, 03:23 PM
Replies: 12
Views: 1,034
Posted By mrvenicess
It is a fun drive! Did it a couple of years ago...

It is a fun drive! Did it a couple of years ago on my way home from a drive to Toronto and back.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 11-22-2016, 01:34 PM
Replies: 43
Views: 4,830
Posted By mrvenicess
I had ID850s on my old build, around 700 whp, but...

I had ID850s on my old build, around 700 whp, but switched to ID1700s with my new setup which includes E85. I'm now over 800 whp on a soft tune.
Forum: Dragstrip and Launch Techniques Discussion 10-18-2016, 02:04 PM
Replies: 13
Views: 1,369
Posted By mrvenicess
Just switch to a ZL1 rear end. They are...

Just switch to a ZL1 rear end. They are bulletproof.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 10-18-2016, 10:50 AM
Replies: 43
Views: 4,830
Posted By mrvenicess
I'm having issues posting on here but there are...

I'm having issues posting on here but there are some on FB under Paul Hurlock, me, or on ZL1 Exclusive, and I believe Fountain Race Engines posted on FB a vid showing the tach. Our tachs only read to...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 10-17-2016, 06:56 AM
Replies: 43
Views: 4,830
Posted By mrvenicess
Cost wise it ran me $3600 for the Fore triple...

Cost wise it ran me $3600 for the Fore triple pump set up installed, plus I upgraded my injectors from ID850s to ID1700s which cost me an additional $1650.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 10-17-2016, 06:53 AM
Replies: 43
Views: 4,830
Posted By mrvenicess
Still on stock cubes with a fairly soft tune for...

Still on stock cubes with a fairly soft tune for now and only at 12-13 lbs of boost. Mustang dyno. High compression, big valve, solid lifter cam, 8,000 rpm!
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 10-15-2016, 10:36 AM
Replies: 43
Views: 4,830
Posted By mrvenicess
I went with a Fore triple pump set up when I did...

I went with a Fore triple pump set up when I did my latest round of mods so I could go E85. 104-107 octane. I'm at 810 to the wheels through a stalled auto on low boost. E85 is great if you have a...
Forum: Forced Induction - V8 09-28-2016, 07:38 AM
Replies: 26
Views: 3,390
Posted By mrvenicess
I went with forged pistons and Callies Ultra H...

I went with forged pistons and Callies Ultra H beam rods. 10.5 to 1 comp, lowered the boost from 16 lbs down to 12-13 as we are spinning to 8,000 rpm now.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 09-21-2016, 10:18 AM
Replies: 27
Views: 1,583
Posted By mrvenicess
I run Pfadt Tri Ys with 3" exhaust.

I run Pfadt Tri Ys with 3" exhaust.
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 05:07 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.