Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
River City Camaro Customs
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 262
Search took 0.03 seconds.
Search: Posts Made By: cdjnight
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-25-2015, 01:44 PM
Replies: 9
Views: 738
Posted By cdjnight
I'd be interested in the injectors and Lower...

I'd be interested in the injectors and Lower Pulley
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-20-2015, 11:02 PM
Replies: 4
Views: 427
Posted By cdjnight
I designed it with a 2.5" thick core, and the...

I designed it with a 2.5" thick core, and the triple pass to remove as much heat as possible. Getting even coolant flow through a single pass radiator is very difficult. And can easily be seen with...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-20-2015, 08:17 PM
Replies: 4
Views: 427
Posted By cdjnight
The tanks are oversized for more capacity without...

The tanks are oversized for more capacity without having to use an extra tank. It has 5.3L capacity.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-20-2015, 03:00 PM
Replies: 15
Views: 437
Posted By cdjnight
Possibly a bad relay

Possibly a bad relay
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-20-2015, 10:46 AM
Replies: 4
Views: 427
Posted By cdjnight
Tripple pass heat exchanger

Here's my latest invention...haven't tested yet. I also have to design my mounts yet.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-18-2015, 03:17 PM
Replies: 19
Views: 324
Posted By cdjnight
what kind of diode do I use? Never used one so I...

what kind of diode do I use? Never used one so I am clueless on that part

just to make sure I understand the drawing correctly
battery - goes to motor negative
battery + goes to terminal 2 ...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-18-2015, 02:22 PM
Replies: 19
Views: 324
Posted By cdjnight
ramping it in makes it easier to tune and doesn't...

ramping it in makes it easier to tune and doesn't flood the motor all at once with a large shot of water/meth.

Min on voltage is good because the gauge fires 12v output on/off/on/off etc...
...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-18-2015, 02:01 PM
Replies: 19
Views: 324
Posted By cdjnight
the set duty cycle will start at a certain "set"...

the set duty cycle will start at a certain "set" boost pressure then ramp up as boost increases till it reaches 100%. Basically I'm making it into a wide band slash water/meth controller slash boost...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-18-2015, 01:57 PM
Replies: 19
Views: 324
Posted By cdjnight
Here's cut sheet on the different relay, I have...

Here's cut sheet on the different relay, I have know idea what they mean in the wiring diagram near the bottom.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-18-2015, 01:46 PM
Replies: 19
Views: 324
Posted By cdjnight
A friend sent me this relay.

A friend sent me this relay.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-18-2015, 12:33 PM
Replies: 19
Views: 324
Posted By cdjnight
I'm controlling a 12 volt pump, IE...changing its...

I'm controlling a 12 volt pump, IE...changing its duty cycle, changes its output presure



The manual suggested relay is only to power the gauge not the output of Solenoid control.



Yes...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-17-2015, 07:58 PM
Replies: 19
Views: 324
Posted By cdjnight
http://www.innovatemotorsports.com/support/manual/...

http://www.innovatemotorsports.com/support/manual/SCG-1%20Manual.pdf
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-17-2015, 11:49 AM
Replies: 19
Views: 324
Posted By cdjnight
Thank you now I just need to find out if my...

Thank you now I just need to find out if my controller is switching both + and - if it is I'm golden. Just attach - to 86. If its not I will definitely need some help.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 08-17-2015, 10:04 AM
Replies: 19
Views: 324
Posted By cdjnight
Need Help with Solid State Relay wiring

I have a boost controller that has 12volt two wire leads that go to a 12volt air solenoid. The controller can only handle a 3amp load. I need to control a device that has a larger load, so I am...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-16-2015, 05:40 PM
Replies: 14
Views: 688
Posted By cdjnight
Thank you sir!

Thank you sir!
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-16-2015, 05:38 PM
Replies: 14
Views: 688
Posted By cdjnight
There is one of the three screws that holds the...

There is one of the three screws that holds the vent in the dash that is blind installation. You can't get your hand in there and you can't see it. So I taped the screw on to scocket and guided it in...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-16-2015, 03:42 PM
Replies: 14
Views: 688
Posted By cdjnight
And here is the final installation picture from...

And here is the final installation picture from drivers seat
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-16-2015, 11:39 AM
Replies: 14
Views: 688
Posted By cdjnight
Here's installation into dash, I had to tape last...

Here's installation into dash, I had to tape last screw to socket in order to get all the way back up into dash to install. Also you'll see I drilled a hole in duct in order to route wires out. I...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-16-2015, 09:48 AM
Replies: 14
Views: 688
Posted By cdjnight
I used a flap wheel sanding disc in a 4-1/2"...

I used a flap wheel sanding disc in a 4-1/2" grinder to sand off about a 1/16th of an inch off diameter. It fits into the silver trim as is but it stretches it and will end up braking it. The back...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-15-2015, 05:54 PM
Replies: 14
Views: 688
Posted By cdjnight
I was looking at those like yours and I didn't...

I was looking at those like yours and I didn't like how the color of plastic didn't match the factory stuff. I will have some more installation pics soon.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-15-2015, 08:18 AM
Replies: 46
Views: 2,513
Posted By cdjnight
I mixed 128oz of Torco with full tank...

I mixed 128oz of Torco with full tank approximately 19 gallons of 91 with E10 and ran Teds 100 octane tune for my 75 hp package with Zero knock retard last night. 7 passes at the track started in 95...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-14-2015, 01:10 PM
Replies: 14
Views: 688
Posted By cdjnight
Thanks man! I had seen a few posted on here that...

Thanks man! I had seen a few posted on here that blocked it off completely with a plate and I didn't like how they turned out at all. Plus I didn't want to loose 100% of my AC vent.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-14-2015, 12:43 PM
Replies: 14
Views: 688
Posted By cdjnight
Installing Gauge in air vent

So I wanted to install a gauge in my left side AC vent and still keep function of the vent. Having had a mustang before I knew they sold this adapter so I ordered one and modified it to work with...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-10-2015, 10:10 PM
Replies: 32
Views: 2,609
Posted By cdjnight
C7 with a hitch :bellyroll: then all you need is...

C7 with a hitch :bellyroll: then all you need is a trailer
Forum: ZL1 Parts 08-10-2015, 11:49 AM
Replies: 0
Views: 190
Posted By cdjnight
Wanted Lingenfelter tank L300152012

I'm looking for Lingenfelter ZL1 intercooler tank only is all I need, This would be the one that mounts closest to the Air filter. I tried to buy just the tank from Lingenfelter but they only sell it...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-09-2015, 02:45 PM
Replies: 2
Views: 250
Posted By cdjnight
Thank you HOTLAP!

Thank you HOTLAP!
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-09-2015, 01:07 PM
Replies: 2
Views: 250
Posted By cdjnight
Rotofab washer fluid tank

Can some one please measure the inside diameter of their Rotofab washer fluid tank fill spout? Please and Thank you in advance.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-08-2015, 08:58 PM
Replies: 12
Views: 1,126
Posted By cdjnight
what brand of dyno did you do this on?

what brand of dyno did you do this on?
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 08-08-2015, 12:46 AM
Replies: 92
Views: 5,064
Posted By cdjnight
Dont feed the trolls....so when can I order my...

Dont feed the trolls....so when can I order my system GenF-GTS???
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 08-06-2015, 10:15 PM
Replies: 92
Views: 5,064
Posted By cdjnight
Sign me up please...

Sign me up please...
Showing results 1 to 30 of 262

 
Forum Jump

All times are GMT -5. The time now is 05:10 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.