Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 2 1 2
Showing results 1 to 30 of 56
Search took 0.02 seconds. Search: Posts Made By: ksspeed
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 05-15-2014, 03:19 PM
Replies: 14
Views: 3,559
Posted By ksspeed
Yeah, i didnt want an exhaust that claimed to...

Yeah, i didnt want an exhaust that claimed to sound like a v8, so i checked out pypes, i like it, at idle and part throttle it reminds me of a ricer a little, but at wot, it sounds freekin awsome.
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 05-15-2014, 10:13 AM
Replies: 14
Views: 3,559
Posted By ksspeed
I have the pypes exhaust on my car and ran into...

I have the pypes exhaust on my car and ran into the same problem, what i did was loosen the clamps a little, and pulled down on the exhaust enough to tweak it, then stuck a pry bar between the body...
Forum: Forced Induction - V6 04-11-2014, 08:24 AM
Replies: 15
Views: 3,035
Posted By ksspeed
I have mine gapped at .38 and seems perfectly...

I have mine gapped at .38 and seems perfectly fine for everyday driving, i hope to test with a 50 shot within the next few weeks. From what ive read most are gapping around .35-.40 due to different...
Forum: USA - Rockies / Midwest 03-26-2014, 08:15 PM
Replies: 361
Views: 48,347
Posted By ksspeed
I probably wont be able to make it in April, but...

I probably wont be able to make it in April, but I will check out the web site! I hope to start freeing up some time for these events, sounds like fun.
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 03-20-2014, 07:50 AM
Replies: 17
Views: 2,766
Posted By ksspeed
I have the sleeve style clamps on mine, they have...

I have the sleeve style clamps on mine, they have two bolts per sleeve, i love them, but in reality it probably cost the same per weld as opposed to using the two bolt stainless sleeve clamp. Its...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 03-20-2014, 07:40 AM
Replies: 27
Views: 3,873
Posted By ksspeed
It was about a month for mine, i ordered through...

It was about a month for mine, i ordered through apex, and Victoria with Apex stayed on top of the status to keep me informed. During my wait, i even contacted vmax because of my lack of patience,...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 03-16-2014, 12:56 PM
Replies: 23
Views: 8,983
Posted By ksspeed
For what little it is, i did not know that this...

For what little it is, i did not know that this kit existed. I do look forward to hearing about your install and how you like the system. Please keep us posted.
Forum: Forced Induction - V6 03-16-2014, 12:51 PM
Replies: 45
Views: 6,872
Posted By ksspeed
Hey there scrming thank you for the correction of...

Hey there scrming thank you for the correction of N2O. I bet no one on here knew that!!! BTW, isnt this a CAMARO forum??? ... And thanks again!
Forum: Forced Induction - V6 03-15-2014, 03:49 PM
Replies: 45
Views: 6,872
Posted By ksspeed
And actually, if you set up your nos correctly in...

And actually, if you set up your nos correctly in ways it is just as safe and less stress on your car because you arent constantly spooling and using the higher power durring all driving conditions....
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 03-12-2014, 09:51 AM
Replies: 36
Views: 4,656
Posted By ksspeed
That is a very good question, i belive there can...

That is a very good question, i belive there can be as much as 10hp gain, its minimal. I would be more interested in the harmonic balancer available along with the pullies gain. Does anyone have...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 03-08-2014, 11:12 AM
Replies: 5
Views: 2,811
Posted By ksspeed
Awsome find

Awsome find
Forum: Forced Induction - V6 03-08-2014, 11:04 AM
Replies: 15
Views: 3,035
Posted By ksspeed
I did buy them directly from their site, however...

I did buy them directly from their site, however i did not contact anyone from there. I am interested in seeing what results you have after testing, also, it would be nice if we could have a rep...
Forum: Forced Induction - V6 03-07-2014, 10:41 AM
Replies: 15
Views: 3,035
Posted By ksspeed
I have the brisk RR14S installed on my car set up...

I have the brisk RR14S installed on my car set up for a 100 shot right now, but have not sprayed yet. The plugs have been installed for around 5 months and maybe 500 or more miles on them without...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 03-01-2014, 08:34 PM
Replies: 14
Views: 6,822
Posted By ksspeed
Another thing you may want to check is your spark...

Another thing you may want to check is your spark plugs after use, i no longer use octane boost, ill go for the 104 octane unleaded at the track, due to the buildup ive had in the past using octane...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 02-26-2014, 09:00 PM
Replies: 11
Views: 1,909
Posted By ksspeed
Thats awsome news, they may have disconnected the...

Thats awsome news, they may have disconnected the positive under the hood. Cant imagine it would hurt anything if you followed up with it though.
Forum: Site Related Announcements / Suggestions / Feedback / Questions 02-25-2014, 03:55 PM
Replies: 14
Views: 3,671
Posted By ksspeed
Lol, yeah that pretty much sums it up. It kind...

Lol, yeah that pretty much sums it up. It kind of feels like we are the red headed step child of the bunch. Im at the point of accepting the challenge with mine though, going to try and make the...
Forum: Forced Induction - V6 02-12-2014, 07:05 PM
Replies: 1
Views: 1,290
Posted By ksspeed
Specifically 2LS people with NITROUS, Tuning???'s

I am setting up my ride with a 100 shot wet kit, and as many may know, the timing needs to be retarded 2 degrees per every 50 H.P. (or 4 deg. for 100 shot). What I need to know is what programming...
Forum: Forced Induction - V6 01-30-2014, 09:10 AM
Replies: 13
Views: 5,255
Posted By ksspeed
Im running an msd window switch, i used the...

Im running an msd window switch, i used the driver side first coil, if im not mistaken, and your box is looking at a "single cylinder" set up, it shouldnt matter which coil you tap on to, as long as...
Forum: Forced Induction - V6 01-18-2014, 11:02 AM
Replies: 2
Views: 1,077
Posted By ksspeed
Thanks man, i actually have done some reseach,...

Thanks man, i actually have done some reseach, not a whole lot, but i found a plug that is a cooler temp and another alternative, after speaking with a couple of our nitrous vendors.its a "Brisk...
Forum: Forced Induction - V6 01-18-2014, 08:34 AM
Replies: 2
Views: 1,077
Posted By ksspeed
Any 2LS's pushing FI on stock 2:92s?

I am wanting to see how many of you out there are taking you 2LS to the limit with what you have. I am one of those that bought the car not knowing the disadvantage of having the "weaker" rear end...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 01-02-2014, 07:27 PM
Replies: 18
Views: 2,017
Posted By ksspeed
Sorry to hear about your problems with the order,...

Sorry to hear about your problems with the order, sounds like next month when im ready to order mine, its going to be through apex! So, for what it is, thank you for the heads up.
Forum: Forced Induction - V6 12-19-2013, 07:31 PM
Replies: 34
Views: 12,167
Posted By ksspeed
Not to dog anyone by any means, but for the price...

Not to dog anyone by any means, but for the price of an extra solnoid, its well worth the insurance for the investment of the vehicle. Paranoid, maybe, ive seen enough nitrous falures in the past to...
Forum: Cosmetics and Lighting Modification Discussions 12-13-2013, 01:58 PM
Replies: 18
Views: 6,025
Posted By ksspeed
Fingers crossed, would love to see how this is...

Fingers crossed, would love to see how this is done. I used an msd box before, to control nos shut off, and wired an additional relay to fire red leds around the grill and underglows close to...
Forum: Cosmetics and Lighting Modification Discussions 12-13-2013, 09:50 AM
Replies: 2
Views: 617
Posted By ksspeed
There are a couple good ones in Lawrence,...

There are a couple good ones in Lawrence, unfortunatly they are about an hour 15-30 minute drive from you. Price at both are about $130.00 , had mine tinted at 35 percent, since the car seems to be...
Forum: Forced Induction - V6 12-13-2013, 09:35 AM
Replies: 34
Views: 12,167
Posted By ksspeed
Another thing to keep in mind is the wiring...

Another thing to keep in mind is the wiring circuit for the nos system should be well thought out and ran. Using the correct wire guage, fuse (protection), and relays for triggering will also help. ...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 12-02-2013, 01:00 PM
Replies: 29
Views: 7,250
Posted By ksspeed
Awsome news, i hope to do the same with my 2ls...

Awsome news, i hope to do the same with my 2ls down the road, was going to try the richmond gear swap until i heard it wouldnt work on our carrier. Thanks for the info
Forum: Forced Induction - V6 11-30-2013, 03:05 PM
Replies: 34
Views: 12,167
Posted By ksspeed
This is an awsome thread, and answers a lot of...

This is an awsome thread, and answers a lot of the right questions for the build. I too have been working on a similar set up for the past 6 months with the same goal. Have a buddy with an SS and...
Forum: Forced Induction - V6 11-26-2013, 09:17 AM
Replies: 34
Views: 12,167
Posted By ksspeed
Id say you guys hit it right on the head. The...

Id say you guys hit it right on the head. The plugs have been a tough argument on some of the post, the best advice i can give at this point is to contact the different nitrous companys and ask...
Forum: Cosmetics and Lighting Modification Discussions 10-29-2013, 11:54 AM
Replies: 6
Views: 873
Posted By ksspeed
Id take that, and the easy fix any day man. Good...

Id take that, and the easy fix any day man. Good to hear youre all fixed.
Forum: Cosmetics and Lighting Modification Discussions 10-28-2013, 12:23 PM
Replies: 6
Views: 873
Posted By ksspeed
I guess the first question would be where did you...

I guess the first question would be where did you tap power for your new lights at?
Showing results 1 to 30 of 56
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 01:10 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.