Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Emblempros
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 500
Search took 0.12 seconds.
Search: Posts Made By: MikeOD
Forum: Forced Induction - V8 12-23-2014, 08:50 AM
Replies: 41
Views: 2,211
Posted By MikeOD
I don't really think that's a fair comparison. ...

I don't really think that's a fair comparison. Someone making 919 on a stock bottom end has IAT/EGT/combustion temps controlled really well...throwing everything a Maggie has at an engine could...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 12-23-2014, 08:44 AM
Replies: 12
Views: 571
Posted By MikeOD
If you have HPTuners, you could just program the...

If you have HPTuners, you could just program the fans to run on after ignition off until things are below a certain temperature...if you got really creative with wiring you could have the IC pump run...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-21-2014, 10:25 AM
Replies: 39
Views: 2,523
Posted By MikeOD
Sorry I didn't see your question. I have a...

Sorry I didn't see your question. I have a custom grind. It was ground by Comp.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-21-2014, 10:23 AM
Replies: 24
Views: 1,352
Posted By MikeOD
As soon as you guys send me a flowbench and a...

As soon as you guys send me a flowbench and a dyno, as well as the intakes you'd like to see compared, I'll do it and post the results.

Nothing is free.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-10-2014, 04:32 PM
Replies: 39
Views: 2,523
Posted By MikeOD
I think you'll see PLENTY of high mileage setups...

I think you'll see PLENTY of high mileage setups too...there's no reason they shouldn't last unless the lobes are ridiculous (not meant for the lifters you have...and you're not maintaining your...
Forum: Tuning / Diagnostics -- engine and transmission 10-24-2014, 09:00 PM
Replies: 34
Views: 1,533
Posted By MikeOD
Sounds like the shift points are all messed up...

Sounds like the shift points are all messed up too.
Forum: Tuning / Diagnostics -- engine and transmission 10-24-2014, 09:19 AM
Replies: 34
Views: 1,533
Posted By MikeOD
It's always been $49.99/credit...at least for the...

It's always been $49.99/credit...at least for the 6 or 7 years that I've had HPTuners.
Forum: Tuning / Diagnostics -- engine and transmission 10-24-2014, 08:33 AM
Replies: 34
Views: 1,533
Posted By MikeOD
If it's locked it's locked, and they have to...

If it's locked it's locked, and they have to unlock it. I'm just telling you that if they're saying someone can pay $125 to unlock it, then it may not actually be locked...if they locked it, it is...
Forum: Tuning / Diagnostics -- engine and transmission 10-24-2014, 08:28 AM
Replies: 34
Views: 1,533
Posted By MikeOD
2 credits...$49.99 each, $99.98. I wish it was...

2 credits...$49.99 each, $99.98. I wish it was only $80. Oh well.
Forum: Tuning / Diagnostics -- engine and transmission 10-23-2014, 04:31 PM
Replies: 2
Views: 358
Posted By MikeOD
It's in the 2.25 beta build, which is probably...

It's in the 2.25 beta build, which is probably not going to be a full release for a while, they're completely rethinking the software and scanner.

Anyone with HPTuners can get it, they just have...
Forum: Tuning / Diagnostics -- engine and transmission 10-23-2014, 03:34 PM
Replies: 34
Views: 1,533
Posted By MikeOD
It may not be locked...EFILive costs $125 to...

It may not be locked...EFILive costs $125 to license any car.

Unfortunately there's a "how to" thread on the EFILive forums where a couple guys tell everyone to drill holes in the TB's on these...
Forum: Tuning / Diagnostics -- engine and transmission 10-13-2014, 10:57 AM
Replies: 4
Views: 826
Posted By MikeOD
Since this sounds like a completely custom...

Since this sounds like a completely custom operating system, do you offer tuning software for it too where the end user can make any/all changes they want to, or strictly canned and remote tunes from...
Forum: 5th Gen Camaro SS LS LT General Discussions 10-01-2014, 04:20 PM
Replies: 32
Views: 2,038
Posted By MikeOD
I figured out the problem...seems every time you...

I figured out the problem...seems every time you re-load the linked pictures from alldata...you get something else lol...look at your post Caswell239 and just keep hitting refresh.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-01-2014, 04:06 PM
Replies: 18
Views: 2,111
Posted By MikeOD
The HUD installs aren't removing the dash frame,...

The HUD installs aren't removing the dash frame, only the dash pad. To get to the heater core, the dash frame has to come out after the dash pad, so yes, 100% necessary.



I only have some...
Forum: 5th Gen Camaro SS LS LT General Discussions 10-01-2014, 03:58 PM
Replies: 32
Views: 2,038
Posted By MikeOD
I'm not sure what this stuff is referring to, but...

I'm not sure what this stuff is referring to, but I didn't go anywhere near any parts like this to replace my heater core...I had everything apart just like the OP does.
Forum: 5th Gen Camaro SS LS LT General Discussions 10-01-2014, 03:57 PM
Replies: 32
Views: 2,038
Posted By MikeOD
Hey, did you get it apart. I just saw your PM...

Hey, did you get it apart. I just saw your PM sorry I didn't reply.

I found that when I got the HVAC box out of the car, even though the manual said to remove screws to open it up...I had to...
Forum: Camaro DIY & HOW-TO instructions & discussions 09-26-2014, 06:30 AM
Replies: 33
Views: 2,481
Posted By MikeOD
That's just an alignment pin. Stays with the dash...

That's just an alignment pin. Stays with the dash when you pull it out.

There were a bunch of bolts, plus the wiring harness had to be held out of the way, and the brake/clutch pedals were...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-22-2014, 11:09 AM
Replies: 30
Views: 1,791
Posted By MikeOD
You really don't need a cam...if you're worried...

You really don't need a cam...if you're worried about warranty, it's easier to undo headers than undo a cam.

My car dyno'd 425 rwhp with Kooks headers and cats (which I later removed), dynomax...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-22-2014, 11:05 AM
Replies: 32
Views: 2,758
Posted By MikeOD
Big cam, Kooks headers, no cats and then the...

Big cam, Kooks headers, no cats and then the Dynomax Bullet system...I had to get rid of it (changed to the full Kooks exhaust)...couldn't drive the car without getting a pounding headache.
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 09-22-2014, 10:52 AM
Replies: 29
Views: 3,220
Posted By MikeOD
Wow...there's a LOT of fuel in the stock tune...

Wow...there's a LOT of fuel in the stock tune huh? Seems you'd find more power NA by just not running it at 11.0:1.
Forum: Camaro DIY & HOW-TO instructions & discussions 09-17-2014, 09:25 PM
Replies: 33
Views: 2,481
Posted By MikeOD
If you don't know, you shouldn't make such a...

If you don't know, you shouldn't make such a factual statement.

If you change a heater core in a 5th gen in 3 hours, you're probably removing the dash with a sawzall...and putting the pieces back...
Forum: Tuning / Diagnostics -- engine and transmission 09-13-2014, 09:09 PM
Replies: 4
Views: 400
Posted By MikeOD
The coil harness on each side grounds to the back...

The coil harness on each side grounds to the back of the head...it was probably removed to take the valve cover off. Make sure the ground isn't loose.
Forum: 5th Gen Camaro SS LS LT General Discussions 09-07-2014, 08:10 PM
Replies: 34
Views: 1,736
Posted By MikeOD
The way the solenoid is setup, it's only able to...

The way the solenoid is setup, it's only able to lock out second...it just winds up pushing you into 4th even though all 5 other forward gears are still available.

Hitting clear does not cancel...
Forum: Tuning / Diagnostics -- engine and transmission 08-31-2014, 06:56 PM
Replies: 10
Views: 919
Posted By MikeOD
The coil packs ground on the back of the heads....

The coil packs ground on the back of the heads. Maybe he bumped one of those grounds and you're firing dead on 4 cylinders?
Forum: Autos For Sale / Wanted 08-25-2014, 04:07 PM
Replies: 5
Views: 906
Posted By MikeOD
Bump to the top...seems like there's no interest...

Bump to the top...seems like there's no interest though.
Forum: Transmission / Driveline 08-20-2014, 03:56 PM
Replies: 6
Views: 818
Posted By MikeOD
Sold!!!

Sold!!!
Forum: Transmission / Driveline 08-20-2014, 01:33 PM
Replies: 6
Views: 818
Posted By MikeOD
Hey, I wasn't able to get on the forum the past...

Hey, I wasn't able to get on the forum the past couple days...not sure what was up with that. I sent you a PM, they can leave today.
Forum: Autos For Sale / Wanted 08-17-2014, 10:38 PM
Replies: 5
Views: 906
Posted By MikeOD
If someone wants the car without them, for a good...

If someone wants the car without them, for a good amount of money, I'll let you know, but if I keep the car, I am also keeping the wheels.
Forum: Autos For Sale / Wanted 08-17-2014, 08:19 PM
Replies: 5
Views: 906
Posted By MikeOD
I forgot to mention, I have a set of Hotchkis...

I forgot to mention, I have a set of Hotchkis frame braces I never installed that will go with the car too. I bought them with the spacer kit for larger exhaust, though I don't know if it's...
Forum: Autos For Sale / Wanted 08-17-2014, 08:12 PM
Replies: 5
Views: 906
Posted By MikeOD
Thinking about selling my 500 rwhp SS.

I really do like my car...but I'm losing interest in it, and I want to build something else. I'll consider partial trades too (for maybe a black mid 90's Impala SS or a 2WD 2005-2006 RCSB...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 03:51 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.