Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.04 seconds. Search: Posts Made By: Cam 427
Forum: Local Marketplace 09-06-2020, 02:00 PM
Replies: 0
Views: 918
Posted By Cam 427
SS Polished Wheels and Tires

Tires and wheels removed from a 2010 SS. The fronts have about 700 miles on them and the rears have about 2200 miles. In good condition with some light scratches. TPMS sensors in all wheels. $500 or...
Forum: Local Marketplace 02-12-2020, 10:44 PM
Replies: 0
Views: 808
Posted By Cam 427
Front SS wheels and tires

Front wheels and tires removed from a 2010 Camaro SS at about 700 miles. 20X8 polished wheels in very good condition. Some light scratches. Pirelli 245 45 zr20 tires. $200 or best offer.
Sumner,...
Forum: Forced Induction - V8 04-26-2018, 07:50 PM
Replies: 131
Views: 28,827
Posted By Cam 427
Thanks for the info. I'll give it a shot.

Thanks for the info. I'll give it a shot.
Forum: Forced Induction - V8 04-24-2018, 04:01 PM
Replies: 131
Views: 28,827
Posted By Cam 427
I don't have a regulator but measured the amount...

I don't have a regulator but measured the amount of oil that drains in the return lines to the pan and it came to about half of what was considered excessive. I think it was 4.5-5 ounces in 30...
Forum: Forced Induction - V8 04-19-2018, 01:26 PM
Replies: 131
Views: 28,827
Posted By Cam 427
Thanks. I have blue exhaust smoke shortly after...

Thanks. I have blue exhaust smoke shortly after start up that goes away after warm up. Precision Turbo recommends better crankcase venting. It's worth a try, I guess...

Sorry about your...
Forum: Forced Induction - V8 04-17-2018, 08:21 PM
Replies: 131
Views: 28,827
Posted By Cam 427
Hell of a build! Lots of ingenuity applied. ...

Hell of a build! Lots of ingenuity applied.
What are you using for the engine breather/vent system? Is that something you came up with?
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 09-18-2017, 04:40 PM
Replies: 58
Views: 9,038
Posted By Cam 427
Very OCD here. Not a daily driver, so the under...

Very OCD here. Not a daily driver, so the under side is almost as clean as the top.
Forum: 5th Gen Camaro SS LS LT General Discussions 07-05-2017, 07:32 AM
Replies: 22
Views: 4,277
Posted By Cam 427
Valvoline 10w30 synthetic. No problems.

Valvoline 10w30 synthetic. No problems.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-20-2017, 10:07 PM
Replies: 24
Views: 20,186
Posted By Cam 427
That's an aluminum fitting. I took this fitting...

That's an aluminum fitting. I took this fitting out, prior to selling the engine, and the threads galled on both in the block and the fitting. Luckily there was enough thread in the block to allow...
Forum: Forced Induction - V8 07-10-2016, 04:11 PM
Replies: 15
Views: 4,931
Posted By Cam 427
According to my 2010 service manual: red for...

According to my 2010 service manual: red for early production and gray for late production. Black for ground,early production, and pink for late. The red should be twisted together with the black and...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-09-2016, 08:00 PM
Replies: 13
LS7
Views: 2,619
Posted By Cam 427
LS7 block, Callies standard LS four inch crank...

LS7 block, Callies standard LS four inch crank and rods , Mahle, pistons, PRC CNC'd heads, LS3 pan, ran me about 8 grand. If you didn't know what to look for, you wouldn't know it was a 427. I had a...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-24-2016, 03:57 PM
Replies: 11
Views: 1,654
Posted By Cam 427
About what mine is with the Melling 10296 pump.

About what mine is with the Melling 10296 pump.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-05-2016, 12:15 AM
Replies: 85
Views: 19,734
Posted By Cam 427
Corsa quad tip, no drone. Had Stainless Works and...

Corsa quad tip, no drone. Had Stainless Works and liked the sound but the drone was annoying.
Forum: Suspension / Brakes / Chassis 03-30-2016, 09:54 PM
Replies: 18
Views: 8,242
Posted By Cam 427
Any chance of getting these with clear anodize?

Any chance of getting these with clear anodize?
Forum: Camaro DIY & HOW-TO instructions & discussions 03-15-2016, 09:34 PM
Replies: 38
Views: 11,736
Posted By Cam 427
I removed and replaced my engine with a hoist....

I removed and replaced my engine with a hoist. Engine was mostly complete with the exception of the intake manifold being off for a lift plate mounted to the valley cover and the hoist chain was as...
Forum: USA - Northwest / Pacific Northwest 01-17-2016, 03:58 PM
Replies: 8
Views: 1,508
Posted By Cam 427
I like it. May look into getting one in a year or...

I like it. May look into getting one in a year or so.
Forum: Wheels / Tires 01-05-2016, 04:23 PM
Replies: 11
Views: 1,829
Posted By Cam 427
Have a pair of tires with about 600 miles on...

Have a pair of tires with about 600 miles on them. They are mounted on polished 2010 SS wheels. Would like to sell wheels and tires together. PM me if interested.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-30-2015, 08:11 PM
Replies: 20
Views: 7,690
Posted By Cam 427
I have Corsa's quad tip exhaust and had to cut...

I have Corsa's quad tip exhaust and had to cut the welds and reposition the tips closer to the mufflers to look right with the same 1LE diffuser.
Forum: 5th Gen Camaro SS LS LT General Discussions 12-17-2015, 07:53 PM
Replies: 91
Views: 19,781
Posted By Cam 427
If you swapped the relay with another (same part...

If you swapped the relay with another (same part number) and it still vibrates in the same position then the circuit which sends that relay the signal ( voltage or ground) to actuate should be...
Forum: 5th Gen Camaro SS LS LT General Discussions 12-16-2015, 03:34 PM
Replies: 126
Views: 15,736
Posted By Cam 427
Just on nice days. I have a couple of other...

Just on nice days. I have a couple of other vehicles for daily driving duties.
Forum: 5th Gen Camaro SS LS LT General Discussions 12-16-2015, 03:27 PM
Replies: 91
Views: 19,781
Posted By Cam 427
I'd start checking the battery connections at the...

I'd start checking the battery connections at the battery, battery post in the engine compartment, and at the starter. Check all the grounds, battery to body and engine to body.
Forum: Forced Induction - V8 12-12-2015, 04:51 PM
Replies: 20
Views: 5,058
Posted By Cam 427
It wouldn't be a bad idea to use it on an engine...

It wouldn't be a bad idea to use it on an engine with some miles on it too.
Forum: Forced Induction - V8 12-11-2015, 05:23 PM
Replies: 20
Views: 5,058
Posted By Cam 427
Running the 10296 with the high pressure spring....

Running the 10296 with the high pressure spring. Built my engine with the bearing clearances a little on the loose side of the specs. Just wanted to make sure there was adequate flow and pressure.
Forum: Forced Induction - V8 12-08-2015, 05:43 PM
Replies: 15
Views: 4,227
Posted By Cam 427
Wow, that took some guts! Contemplating cutting...

Wow, that took some guts! Contemplating cutting an access hole in my car instead of taking everything apart. Your picture gives me an idea of what to do. Thanks!

Too bad GM didn't put an access...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-07-2015, 03:18 PM
Replies: 25
Views: 2,946
Posted By Cam 427
The exhaust system will extend some as the...

The exhaust system will extend some as the temperature of the exhaust climbs. Check your piping for adequate clearance around the transmission cross brace, tunnel, and rear end suspension cradle...
Forum: Tuning / Diagnostics -- engine and transmission 10-30-2015, 03:21 PM
Replies: 12
Views: 5,164
Posted By Cam 427
Thanks! Pretty cool gages and their dual gage pod...

Thanks! Pretty cool gages and their dual gage pod is what I was looking for.
Forum: Tuning / Diagnostics -- engine and transmission 10-29-2015, 11:12 PM
Replies: 12
Views: 5,164
Posted By Cam 427
Thanks- of the two, I like Innovate ...

Thanks- of the two, I like Innovate


Thanks


Thanks for the link.
Forum: Tuning / Diagnostics -- engine and transmission 10-28-2015, 10:59 PM
Replies: 12
Views: 5,164
Posted By Cam 427
Thanks very much. I was leaning towards Innovate...

Thanks very much. I was leaning towards Innovate but was wondering what experiences others had with other brands.
Forum: Tuning / Diagnostics -- engine and transmission 10-28-2015, 10:50 PM
Replies: 12
Views: 5,164
Posted By Cam 427
Have an extra bung in each down pipe and other...

Have an extra bung in each down pipe and other than the extra cost of the dual setup, might as well go for the duals.
Forum: Tuning / Diagnostics -- engine and transmission 10-26-2015, 04:04 PM
Replies: 12
Views: 5,164
Posted By Cam 427
Wideband Recommendations

Looking to install dual wideband oxygen sensors. Considering Fast, Innovate, or Daytona Sensors kits. Any inputs would be greatly appreciated.
Thanks
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 07:55 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.