Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Gen5DIY
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 500
Search took 0.10 seconds.
Search: Posts Made By: ZO6 Bryan
Forum: Camaro ZL1 Forum - ZL1 Specific Topics Yesterday, 09:25 PM
Replies: 46
Views: 1,964
Posted By ZO6 Bryan
All this fuss over a car that just needs a diff...

All this fuss over a car that just needs a diff fluid change and some limited slip additive is ridiculous. Spend $40 and change the fluid yourself. This is just run of the mill maintenance, not a...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics Yesterday, 09:09 PM
Replies: 24
Views: 577
Posted By ZO6 Bryan
There you go. Fuel trims were off because of the...

There you go. Fuel trims were off because of the intake.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics Yesterday, 06:04 PM
Replies: 24
Views: 577
Posted By ZO6 Bryan
A cold air intake will throw off your fuel trims...

A cold air intake will throw off your fuel trims way more than a set of headers will. What else had you done to the car?
Forum: Camaro ZL1 Forum - ZL1 Specific Topics Yesterday, 03:24 PM
Replies: 24
Views: 577
Posted By ZO6 Bryan
Then something else was wrong with your car.

Then something else was wrong with your car.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics Yesterday, 03:02 PM
Replies: 24
Views: 577
Posted By ZO6 Bryan
Untrue! The fuel trims will always bring you...

Untrue! The fuel trims will always bring you back to 14.7AFR. You may be a little off at WOT. Actually when I did my headers the fuel trims didn't change significantly at all.

Put the headers on...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics Yesterday, 10:45 AM
Replies: 24
Views: 577
Posted By ZO6 Bryan
Actually the codes you will get first are p015B...

Actually the codes you will get first are p015B and P015D. Which are for slow response of the FRONT O2s. So the mini cats aren't going to help.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-25-2015, 09:56 PM
Replies: 28
Views: 853
Posted By ZO6 Bryan
No way will you get 50-85 hp. Skip the headers...

No way will you get 50-85 hp. Skip the headers unless you up the boost first. Minimal gains for the stock engine.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-25-2015, 11:05 AM
Replies: 36
Views: 1,210
Posted By ZO6 Bryan
Yes, the bump acts as as Venturi speeding airflow...

Yes, the bump acts as as Venturi speeding airflow past the blade at low throttle position. It is there by design.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-24-2015, 01:45 PM
Replies: 25
Views: 920
Posted By ZO6 Bryan
I've driven mine in 3 winters now in Tennessee. ...

I've driven mine in 3 winters now in Tennessee. We get some snow here but only rarely. We dipped down in the single digits a couple weeks ago and I didn't take it out in that weather. I wouldn't...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-22-2015, 12:57 PM
Replies: 50
Views: 1,769
Posted By ZO6 Bryan
I have a Valentine V1 and mount it just to the...

I have a Valentine V1 and mount it just to the left of the rear view mirror. Using this wire
www.Invisicord.com

Also check out
www.blendmount.com
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-22-2015, 08:55 AM
Replies: 36
Views: 1,210
Posted By ZO6 Bryan
The higher rwhp run looks about right. If you...

The higher rwhp run looks about right. If you corrected to SAE like I said it would be around 530. That's about what should be expected. But the first run looks like something was wrong with the...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-22-2015, 01:02 AM
Replies: 19
Views: 1,033
Posted By ZO6 Bryan
One is a drag radial and the other is a road race...

One is a drag radial and the other is a road race tire.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-21-2015, 07:22 PM
Replies: 36
Views: 1,210
Posted By ZO6 Bryan
Go back and look at that post. They used STD...

Go back and look at that post. They used STD correction. Instant boost in the graph of about 15 rwhp and rwtq. So really made more like 530 rwhp SAE. Stock M6 cars will make 515 SAE rwhp on a...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-20-2015, 09:02 AM
Replies: 10
Views: 512
Posted By ZO6 Bryan
And you'll need a Boost-a-pump or you will lose...

And you'll need a Boost-a-pump or you will lose fuel pressure. I also think that is too much pulley if you are still on the stock cam. Cylinder pressure will go so high you will have to pull all...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-19-2015, 07:51 PM
Replies: 34
Views: 2,321
Posted By ZO6 Bryan
Really not that similar except it has about the...

Really not that similar except it has about the same overlap. That's where the similarity ends. The important valve events (intake valve closing, exhaust valve opening) are not at all the same.
...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-19-2015, 06:02 PM
Replies: 17
Views: 530
Posted By ZO6 Bryan
Add to that list a boost-a-pump.

Add to that list a boost-a-pump.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-19-2015, 01:35 PM
Replies: 34
Views: 2,120
Posted By ZO6 Bryan
Not even just old school. I don't think even the...

Not even just old school. I don't think even the current SS with M6 would have them.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-18-2015, 10:11 AM
Replies: 34
Views: 2,120
Posted By ZO6 Bryan
They are the lines for the tranny cooler and rear...

They are the lines for the tranny cooler and rear diff cooler. So, yes the manuals have them too.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-17-2015, 07:07 PM
Replies: 34
Views: 2,799
Posted By ZO6 Bryan
Actually his cams aren't using the really...

Actually his cams aren't using the really aggressive lobes and should last just fine.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-17-2015, 11:22 AM
Replies: 34
Views: 2,799
Posted By ZO6 Bryan
No, this one. ...

No, this one.
http://www.hotrod.com/how-to/engine/1409-lsx-blower-cams-tested/

Notice the LS9 cam actually loses torque until you get past 4400 rpm.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-16-2015, 09:01 AM
Replies: 200
Views: 7,962
Posted By ZO6 Bryan
http://www.youtube.com/watch?v=Q7URSM_ShQQ

http://www.youtube.com/watch?v=Q7URSM_ShQQ
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-16-2015, 08:55 AM
Replies: 13
Views: 1,389
Posted By ZO6 Bryan
Are they SFI certified?

Are they SFI certified?
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-13-2015, 11:20 PM
Replies: 19
Views: 1,374
Posted By ZO6 Bryan
670 is doable. I make 695 SAE rwhp with pulley...

670 is doable. I make 695 SAE rwhp with pulley cam and headers.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-12-2015, 11:34 PM
Replies: 40
Views: 2,048
Posted By ZO6 Bryan
Exact same injector. They just run them at...

Exact same injector. They just run them at higher rail pressure in the LS9.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-12-2015, 11:01 PM
Replies: 6
Views: 789
Posted By ZO6 Bryan
The tip of the lobe can only be so big and still...

The tip of the lobe can only be so big and still slide in thru the journals.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-11-2015, 02:33 PM
Replies: 9
Views: 599
Posted By ZO6 Bryan
I use this in all my cars that see track time for...

I use this in all my cars that see track time for both the clutch and brakes.

http://www.wilwood.com/Images/BrakeFluid/BrakeFluid_Photos-Large/EXP600%20PLUS-lg.jpg...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-07-2015, 02:38 PM
Replies: 5
Views: 485
Posted By ZO6 Bryan
No. Not needed anymore since it can be controlled...

No. Not needed anymore since it can be controlled in the PCM tuning.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-06-2015, 10:08 PM
Replies: 16
Views: 1,178
Posted By ZO6 Bryan
You mean spark table, not fuel table. And you...

You mean spark table, not fuel table. And you can do that if you can monitor "knock learn factor" on your Dashlogic.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-06-2015, 12:10 AM
Replies: 5
Views: 485
Posted By ZO6 Bryan
You bypass the boost control valve at the P-valve...

You bypass the boost control valve at the P-valve so that that you don't dump boost above 12 psi.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-04-2015, 08:29 PM
Replies: 39
Views: 2,093
Posted By ZO6 Bryan
Here is the new bulletin. The one you posted was...

Here is the new bulletin. The one you posted was from before even the first ZL1 was delivered.


#13-03-10-001: Information on Goodyear F1 Supercar G2 Tire Cold Weather Cracking - (Feb 6, 2013) ...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 07:35 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.