Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Cam Motion
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 247
Search took 0.05 seconds.
Search: Posts Made By: SomeGeoffGuy
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-17-2015, 02:49 PM
Replies: 16
Views: 477
Posted By SomeGeoffGuy
I use those and fill up the joint with copper RTV...

I use those and fill up the joint with copper RTV too. Hard to get off, but they don't leak!

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-21-2015, 04:46 PM
Replies: 11
Views: 587
Posted By SomeGeoffGuy
I think Chevrolet performance sells the windage...

I think Chevrolet performance sells the windage trays for different strokes. Pan should be fine.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-19-2015, 06:57 AM
Replies: 20
Views: 885
Posted By SomeGeoffGuy
Great write-up! I think I would wire this in with...

Great write-up! I think I would wire this in with a 3 position switch - valve open (off), valve closed (on1), and window switch (on2). That would cover just about every way you would want it.
...
Forum: 2016 Camaro: 6th Gen Camaro general forum 06-04-2015, 03:59 PM
Replies: 69
Views: 6,964
Posted By SomeGeoffGuy
Pics or I'm calling BS.

Pics or I'm calling BS.
Forum: 2016 Camaro: 6th Gen Camaro general forum 05-14-2015, 08:38 PM
Replies: 406
Views: 52,517
Posted By SomeGeoffGuy
I was suggesting an alternative to the suggested...

I was suggesting an alternative to the suggested route with a nice ride along the lake. If you take the recommended route you will get a good shot of some serious Detroit ruin porn and get there...
Forum: 2016 Camaro: 6th Gen Camaro general forum 05-14-2015, 05:40 PM
Replies: 406
Views: 52,517
Posted By SomeGeoffGuy
Alternate Route: I know they suggest you to...

Alternate Route:

I know they suggest you to go Gratiot then Grand and then wiggle to Jefferson and hit the island from the opposite direction. I am going to recommend a longer much nicer drive.
-...
Forum: 2016 Camaro: 6th Gen Camaro general forum 05-11-2015, 07:43 PM
Replies: 406
Views: 52,517
Posted By SomeGeoffGuy
The plan is to get wet! I am bringing a couple...

The plan is to get wet! I am bringing a couple beach umbrellas.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 05-09-2015, 11:11 AM
Replies: 30
Views: 1,929
Posted By SomeGeoffGuy
If you look at the Chevy performance catalog,...

If you look at the Chevy performance catalog, there is a list of parts you can buy to get your car closer to a Z28. The big ones are the suspension, and the helical diff. Those two things will...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-07-2015, 04:12 PM
Replies: 16
Views: 656
Posted By SomeGeoffGuy
I ran those rods in a 403 stroker I used to have...

I ran those rods in a 403 stroker I used to have in my 99 Camaro. The car made dozens of 11 second passes on street tires and slicks plus about 20,000 miles of daily driving with no issues. Never...
Forum: 2016 Camaro: 6th Gen Camaro general forum 05-02-2015, 03:16 PM
Replies: 19
Views: 1,704
Posted By SomeGeoffGuy
From the email they sent earlier this week, it...

From the email they sent earlier this week, it sounds like people are getting specific credientials to people who were registered. I would be sure they are transferable before paying up on an ebay...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-23-2015, 03:41 PM
Replies: 13
Views: 1,232
Posted By SomeGeoffGuy
The clutch smell comes through occasionally...

The clutch smell comes through occasionally because the drain in the HVAC is right above the vent area on the trans.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-23-2015, 03:25 PM
Replies: 11
Views: 637
Posted By SomeGeoffGuy
The Z28 has 2.75" pipes and the other two have...

The Z28 has 2.75" pipes and the other two have 2.5" pipes. The ZL1 hangs a little lower around the rear diff to clear the pumpkin than the 1LE.

Getting it shipped is going to be tough because it...
Forum: 2016 Camaro: 6th Gen Camaro general forum 04-01-2015, 04:55 PM
Replies: 32
ZL2
Views: 2,828
Posted By SomeGeoffGuy
I am holding out for the ZL3. -Geoff

I am holding out for the ZL3.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-04-2015, 08:57 AM
Replies: 6
Views: 440
Posted By SomeGeoffGuy
I had a 403 in my fourth gen but it was 4.0...

I had a 403 in my fourth gen but it was 4.0 stroke by 4.005 bore. That is a pretty common iron block performance recipe. It is pretty easy to tell if you have an iron block too.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 01-23-2015, 04:15 PM
Replies: 19
Views: 1,582
Posted By SomeGeoffGuy
A lot of times they put stuff like that in to get...

A lot of times they put stuff like that in to get rid of flow noise. Not sure about that particular one though. If you have ever sat in a car with bad flow noise, you will welcome small dents like...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-19-2014, 03:57 AM
Replies: 10
Views: 1,012
Posted By SomeGeoffGuy
The NPP tips are in the same spot between 13 and...

The NPP tips are in the same spot between 13 and 15, the regular tips moved.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-13-2014, 04:08 PM
Replies: 46
Views: 4,644
Posted By SomeGeoffGuy
Anyone have a dealer labor book? Cam swap should...

Anyone have a dealer labor book? Cam swap should be in there, and it should cost the same performance or not. Plus some dealers will give you a deal on parts if you have them do the install. Doing...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-10-2014, 07:56 PM
Replies: 17
Views: 1,143
Posted By SomeGeoffGuy
The good aftermarket cold air intakes actually...

The good aftermarket cold air intakes actually get calibrated on a flow bench so they won't set codes. That is why you don't go buy the super cheap one off ebay where they just stick some piping and...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 11-10-2014, 07:39 PM
Replies: 45
Views: 4,395
Posted By SomeGeoffGuy
And it was 9 seconds faster than a stock SS! ...

And it was 9 seconds faster than a stock SS!

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 11-09-2014, 05:32 PM
Replies: 45
Views: 4,395
Posted By SomeGeoffGuy
If you really look at it, most of the parts that...

If you really look at it, most of the parts that can make your car perform like a z28 are available, but the parts to make it look like a z28 are not. That is the split Guys A and B used.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-03-2014, 08:24 PM
Replies: 1
Views: 357
Posted By SomeGeoffGuy
60 psi at idle. If you had 2000 psi your fuel...

60 psi at idle. If you had 2000 psi your fuel lines would explode and your car would burn to the ground.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-03-2014, 08:22 PM
Replies: 14
Views: 1,038
Posted By SomeGeoffGuy
I would find another dealer. The GM dealer can...

I would find another dealer. The GM dealer can handle the calibration too. That price doesn't add up.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 11-01-2014, 05:14 PM
Replies: 46
Views: 2,449
Posted By SomeGeoffGuy
New wheels from the dealer. I wouldn't accept...

New wheels from the dealer. I wouldn't accept anything less. And get your $20 back from the tech.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-28-2014, 03:00 PM
Replies: 79
Views: 4,365
Posted By SomeGeoffGuy
So you cut the NPP mufflers off? I was going to...

So you cut the NPP mufflers off? I was going to say, if you get a mild to wild switch you can set it to be closed at startup. The stock calibration is to open the valves at startup. I would put them...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-26-2014, 02:44 PM
Replies: 4
Views: 776
Posted By SomeGeoffGuy
Looks like a cold weld - didn't get enough...

Looks like a cold weld - didn't get enough penetration on one side. It happens. Welding in the v-notch is tough, especially with a mig.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-26-2014, 02:41 PM
Replies: 59
Views: 1,930
Posted By SomeGeoffGuy
Livernois is one of the best shops in Michigan....

Livernois is one of the best shops in Michigan. You get what you pay for.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-12-2014, 07:44 PM
Replies: 26
Views: 2,075
Posted By SomeGeoffGuy
Buy them and let us know if they fit. -Geoff

Buy them and let us know if they fit.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 10-12-2014, 07:36 PM
Replies: 17
Views: 1,920
Posted By SomeGeoffGuy
I would bet that every bushing in every one of...

I would bet that every bushing in every one of those parts is different and tuned just for that suspension. That kit came up for $3200ish on one of the gm parts on-line sites, too.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-05-2014, 07:36 AM
Replies: 68
Views: 4,655
Posted By SomeGeoffGuy
Just run Turbo Blue 110 octane leaded. The stuff...

Just run Turbo Blue 110 octane leaded. The stuff smells AWESOME!

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-28-2014, 10:08 PM
Replies: 11
Views: 919
Posted By SomeGeoffGuy
I would worry it would cause you to start...

I would worry it would cause you to start throwing codes. Most of the aftermarket companies actually do a lot of work to get the MAF sensor to read exactly the same as a stock one. It is not as...
Showing results 1 to 30 of 247

 
Forum Jump

All times are GMT -5. The time now is 09:49 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.