Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Anthony @ LG Motorsports
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 500
Search took 0.05 seconds.
Search: Posts Made By: MA2010SS
Forum: Tuning / Diagnostics -- engine and transmission Yesterday, 01:46 PM
Replies: 6
Views: 137
Posted By MA2010SS
Like Tampa said your ECW will need to be scaled...

Like Tampa said your ECW will need to be scaled with the correct data for the injectors
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-30-2015, 06:32 PM
Replies: 11
Views: 263
Posted By MA2010SS
RXT here, no problems whatsoever

RXT here, no problems whatsoever
Forum: Forced Induction - V8 06-30-2015, 06:49 AM
Replies: 34
Views: 929
Posted By MA2010SS
Take the car to the track and see what kind of...

Take the car to the track and see what kind of MPH you are getting in the quarter mile. That will tell the story of what kind of power you are putting down to the ground. I've ran with a car at the...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-26-2015, 09:36 AM
Replies: 10
Views: 304
Posted By MA2010SS
Yes remove exhaust remove toe rods...

Yes


remove exhaust
remove toe rods to spindles
remove lca's to spindles
remove wheel sensors
remove upper control arm to spindles
set spindles, brakes off to the side and secure to...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-21-2015, 09:17 PM
Replies: 5
Views: 391
Posted By MA2010SS
You will be good on an auto / foot brake combo...

You will be good on an auto / foot brake combo with the ZL1. There are a lot of guys running stock rears with auto trans with just upgraded axles and DS running in the 9's
Forum: Forced Induction - V8 06-16-2015, 10:32 AM
Replies: 2
Views: 210
Posted By MA2010SS
I just replaced my intercooler pump and all is...

I just replaced my intercooler pump and all is well again. I was getting my car ready to go to the track and do some test/tune. Check over everything and one thing that I noticed is that my IC...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-16-2015, 10:25 AM
Replies: 3
Views: 266
Posted By MA2010SS
I agree 100% no wheel hop now, ability to launch...

I agree 100% no wheel hop now, ability to launch at a higher RPM, capacity of almost 3 quarts of fluid vs 1 quart and much more strength is why I changed this out. For the price the kit can't be beat
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-16-2015, 06:53 AM
Replies: 23
Views: 16,643
Posted By MA2010SS
I had the 4.11's in my car which was a little too...

I had the 4.11's in my car which was a little too much IMO. 4th gear topped out at 129mph at 6250rpm. I switched to the ZL1 rear with 3.73 and that seems to be much better with 4th gear topping out...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-16-2015, 06:45 AM
Replies: 3
Views: 266
Posted By MA2010SS
If you lost 5-10 RWHP but added a lot more...

If you lost 5-10 RWHP but added a lot more strength to the mix I wouldn't worry. I personally felt no more wheel hop with the kit and the gearing feels perfect now with the 3.73
Forum: Tuning / Diagnostics -- engine and transmission 06-11-2015, 07:05 AM
Replies: 7
Views: 489
Posted By MA2010SS
hptuners.com and visit their forum is your best...

hptuners.com and visit their forum is your best bet. Do a lot of reading before attempting changes, always make a back up of the original file.
Forum: Tuning / Diagnostics -- engine and transmission 06-10-2015, 07:46 AM
Replies: 10
Views: 411
Posted By MA2010SS
Since it's been a year I would check to make sure...

Since it's been a year I would check to make sure the wires for the O2's didn't melt against the headers. That would be one of the first things to check
Forum: Tuning / Diagnostics -- engine and transmission 06-09-2015, 05:46 PM
Replies: 10
Views: 411
Posted By MA2010SS
when were the long tubes installed, was the car...

when were the long tubes installed, was the car tuned after the install
Forum: Tuning / Diagnostics -- engine and transmission 06-09-2015, 06:39 AM
Replies: 1
Views: 226
Posted By MA2010SS
What mods do you have if any and was there any...

What mods do you have if any and was there any changes done recently to the car?
Forum: Tuning / Diagnostics -- engine and transmission 06-03-2015, 10:37 AM
Replies: 5
Views: 372
Posted By MA2010SS
I don't have cat's on my car and ended up welding...

I don't have cat's on my car and ended up welding a bung in the driver's side off road pipe for my WB. You will be fine using the rear O2's for the WB. I would have Don turn off the rear O2's...
Forum: Forced Induction - V8 05-31-2015, 03:51 PM
Replies: 30
Views: 1,276
Posted By MA2010SS
Alky single nozzle kit here 100% meth...have mine...

Alky single nozzle kit here 100% meth...have mine set up for IAT cooling effect over trying to make more power. Two years no problems, install was easy and Julio helped out on one question I had...
Forum: Forced Induction - V8 05-21-2015, 03:13 PM
Replies: 2
Views: 273
Posted By MA2010SS
What model Bosch?

What model Bosch?
Forum: Forced Induction - V8 05-21-2015, 10:43 AM
Replies: 2
Views: 273
Posted By MA2010SS
Question Whipple IC

Looking to see who might have the best price for a replacement whipple intercooler pump. Mine has seen better days.

:thanks:
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-15-2015, 03:22 PM
Replies: 7
Views: 349
Posted By MA2010SS
I think that bit is T55...sears is where I got...

I think that bit is T55...sears is where I got mine
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-14-2015, 12:13 PM
Replies: 2
Views: 322
Posted By MA2010SS
quick answer is no...how to test your clutch is...

quick answer is no...how to test your clutch is put the car in high gear (6th) while stopped and very slowly release the clutch until it grabs slightly. Release the clutch a little more slowly and...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-06-2015, 07:50 PM
Replies: 8
Views: 777
Posted By MA2010SS
It's a bigger flange on both trans and zl1 diff...

It's a bigger flange on both trans and zl1 diff side using m14 bolts. It's easy to remove the flange off the trans with a 3 finger puller or an older style harmonic balancer puller
Forum: USA - New England 05-04-2015, 07:01 AM
Replies: 19
Views: 579
Posted By MA2010SS
Wednesday's are the track rentals, starting at...

Wednesday's are the track rentals, starting at 1PM through 5PM it's test and tune day with a Saturday type of track prep. It was $125/day which also included running into the night till 9PM when...
Forum: USA - New England 05-03-2015, 04:52 PM
Replies: 19
Views: 579
Posted By MA2010SS
I'm in for a rental also, sucks that I missed...

I'm in for a rental also, sucks that I missed this event
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-01-2015, 11:37 AM
Replies: 50
Views: 3,048
Posted By MA2010SS
They've upped the price slightly ...

They've upped the price slightly
http://www.superchevyperformance.com/22959394_ZL1_HD_Driveline_Kit_Automatic_p/22959394.htm
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-01-2015, 05:25 AM
Replies: 50
Views: 3,048
Posted By MA2010SS
$3700 for the complete kit is what I paid and...

$3700 for the complete kit is what I paid and this thing is very stout
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-24-2015, 08:12 AM
Replies: 2
Views: 299
Posted By MA2010SS
I had a similar issue...no time to be gentle with...

I had a similar issue...no time to be gentle with it...make sure the trans is supported and shake the hell out of it while pulling back it will come out. Make sure there are no harnesses snagging...
Forum: Tuning / Diagnostics -- engine and transmission 04-23-2015, 06:09 PM
Replies: 3
Views: 313
Posted By MA2010SS
Check to make sure that bank1 wires are not...

Check to make sure that bank1 wires are not touching the new headers or there is no crack in the wire for bank 1
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-14-2015, 03:04 PM
Replies: 6
Views: 403
Posted By MA2010SS
Kind of scary how quick that one quart can break...

Kind of scary how quick that one quart can break down if you track your car often
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-08-2015, 07:24 AM
Replies: 50
Views: 3,048
Posted By MA2010SS
Install went very easy with this driveline...

Install went very easy with this driveline kit...I still can't get over the sheer size difference with the 9.9" rear that looks like it came out of a mack truck. The driveline is smooth as butter,...
Forum: Forced Induction - V8 04-07-2015, 01:50 PM
Replies: 23
Views: 978
Posted By MA2010SS
:word:

:word:
Forum: Forced Induction - V8 04-06-2015, 07:11 PM
Replies: 16
Views: 646
Posted By MA2010SS
Check the belt path completely especially in the...

Check the belt path completely especially in the tensioner are being that's what moves when torque is applied
Take one half of the belt to an auto parts store and they can measure it for you they...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 10:08 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.