Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
PFYC
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 384
Search took 0.05 seconds.
Search: Posts Made By: Aries240SS
Forum: Forced Induction 07-19-2015, 07:52 PM
Replies: 7
Views: 827
Posted By Aries240SS
That is a killer package price!

That is a killer package price!
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-18-2015, 10:07 PM
Replies: 9
Views: 484
Posted By Aries240SS
usually go through 1-2 bottles each week.

usually go through 1-2 bottles each week.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-18-2015, 02:06 PM
Replies: 16
Views: 828
Posted By Aries240SS
Tune, location (sea level), and dyno all play a...

Tune, location (sea level), and dyno all play a part. That's why you can't use gains from one dyno to compare to another. Gotta do before and after on the same dyno. Before made 418hp on mustang dyno...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-18-2015, 08:59 AM
Replies: 16
Views: 828
Posted By Aries240SS
M6 car.

M6 car.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-17-2015, 10:58 AM
Replies: 2
Views: 265
Posted By Aries240SS
You're right. XS rebadges the Manzo. Mine had XS...

You're right. XS rebadges the Manzo. Mine had XS on the box, but Manzo on the mufflers themselves.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-08-2015, 08:06 PM
Replies: 16
Views: 828
Posted By Aries240SS
Car made 501 with full boltons and stock heads.

Car made 501 with full boltons and stock heads.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-08-2015, 04:39 PM
Replies: 16
Views: 828
Posted By Aries240SS
I have the BTR Stage 3 in mine. Love it.

I have the BTR Stage 3 in mine. Love it.
Forum: USA - Texas 07-07-2015, 02:49 PM
Replies: 26
Views: 1,371
Posted By Aries240SS
I'm currently using HP Motorsports. Great...

I'm currently using HP Motorsports. Great support, and good staff there.
Forum: Dragstrip and Launch Techniques Discussion 07-05-2015, 01:28 PM
Replies: 7
Views: 488
Posted By Aries240SS
Thanks guys. Pricing parts from sponsors now.

Thanks guys. Pricing parts from sponsors now.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 07-05-2015, 12:12 PM
Replies: 7
Views: 662
Posted By Aries240SS
Mine stays in place without any issue. It's a...

Mine stays in place without any issue. It's a seriously tight fit for the box and it wont go anywhere without a serious impact.
Forum: Dragstrip and Launch Techniques Discussion 07-03-2015, 08:55 PM
Replies: 7
Views: 488
Posted By Aries240SS
Input/Opinion wanted on clutch problem

Hi guys, I've been beating on my car pretty regularly and it still has the factory clutch in it. Last night the clutch went to the floor on the 1-2 shift and didn't return until I kicked it a few...
Forum: Tuning / Diagnostics -- engine and transmission 07-03-2015, 08:21 PM
Replies: 4
Views: 312
Posted By Aries240SS
Most twin pump setups seem to be using the boost...

Most twin pump setups seem to be using the boost switch set at 2-4 psi to turn on the second pump. I've also seen a few nitrous cars that run similar setups, but keep the second pump triggered by the...
Forum: Forced Induction - V8 07-01-2015, 08:42 PM
Replies: 25
Views: 1,365
Posted By Aries240SS
Just under 40k on my daily driven nitrous 6speed...

Just under 40k on my daily driven nitrous 6speed car.
You can get there with your setup. Just need a good suspension to put the power down.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-28-2015, 02:08 PM
Replies: 5
Views: 361
Posted By Aries240SS
Yes, but you need either the tsp cats or test...

Yes, but you need either the tsp cats or test pipes with them.
Forum: Member Car Journals 06-20-2015, 09:18 PM
Replies: 15
Views: 1,657
Posted By Aries240SS
Also took advantage of Hursts deal they have...

Also took advantage of Hursts deal they have running from their outlet through Amazon and got a new shifter handle to replace the billet +2 shifter handle.
Forum: Member Car Journals 06-20-2015, 09:14 PM
Replies: 15
Views: 1,657
Posted By Aries240SS
Made a couple of minor changes recently. ...

Made a couple of minor changes recently.

After talking with prostockjohn, I ordered the right Vette wheels and lugs to get some traction without being on slicks.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-03-2015, 06:47 AM
Replies: 42
Views: 1,977
Posted By Aries240SS
Pull the tranny and stab the whole thing as one...

Pull the tranny and stab the whole thing as one piece. Lining up the clutch and input shaft is tough with the tranny already in the car if you don't have some practice.
Forum: Forced Induction - V8 06-01-2015, 08:51 PM
Replies: 9
Views: 624
Posted By Aries240SS
I daily drive with the BTR Stage 3. It's annoying...

I daily drive with the BTR Stage 3. It's annoying in traffic, but you get used to it. It does love power adders though.
Forum: Dragstrip and Launch Techniques Discussion 06-01-2015, 07:50 PM
Replies: 17
Views: 1,552
Posted By Aries240SS
At 4k a sidestep is likely to hurt the rear/axles...

At 4k a sidestep is likely to hurt the rear/axles if you are on a stock setup. You should be able to quickly let it out and feel a good grab and go sensation. I've found the factory launch control to...
Forum: Forced Induction - V8 05-29-2015, 07:23 PM
Replies: 13
Views: 714
Posted By Aries240SS
Everyone says "I only want 50-75hp." Until they...

Everyone says "I only want 50-75hp." Until they actually feel it and see the difference. Then it becomes, "how much will stock fuel support?"

I run 150 wet on a crammed motor with no fuel mods....
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2015, 08:07 PM
Replies: 36
Views: 3,983
Posted By Aries240SS
This is the important question!

This is the important question!
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-02-2015, 06:48 PM
Replies: 44
Views: 1,154
Posted By Aries240SS
The exhaust you linked is the OBX knockoff in...

The exhaust you linked is the OBX knockoff in stainless. I have the same one in black. Like others have said, there is no reason to do it if you already have an axle back. You just need someone to...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-02-2015, 06:38 PM
Replies: 64
Views: 7,368
Posted By Aries240SS
HP Motorsports in Katy, TX did all the work and...

HP Motorsports in Katy, TX did all the work and the tune. Josh is a wizard with the LS3 tuning and has it running like the car wants to eat small children.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-02-2015, 01:48 PM
Replies: 64
Views: 7,368
Posted By Aries240SS
The drone is real. Real bad lol. I've got to keep...

The drone is real. Real bad lol. I've got to keep the stereo turned up, or else I won't be able to think over the drone.
Forum: Dragstrip and Launch Techniques Discussion 05-02-2015, 09:21 AM
Replies: 19
Views: 1,141
Posted By Aries240SS
This is true. A set of drag radials will get you...

This is true. A set of drag radials will get you 1-2 tenths, but will also stress stock axles. If the car is lowered at all, I'd consider H-E's new diff bushings. At $150 it's a cheap way to avoid...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-02-2015, 09:18 AM
Replies: 10
Views: 1,234
Posted By Aries240SS
I used the redline ATF. smoothed out my 1-2 shift...

I used the redline ATF. smoothed out my 1-2 shift notchieness and overall smoothed out the trans as a whole. I changed from stock fluid at 25k and nod have 38k.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-30-2015, 01:12 PM
Replies: 26
Views: 834
Posted By Aries240SS
http://www.nitrousoutlet.com/efi-wet-nitrous-syste...

http://www.nitrousoutlet.com/efi-wet-nitrous-systems/gm-systems/gm-2010-camaro-90mm-plate-system.html

or
...
Forum: Forced Induction - V8 04-29-2015, 05:45 PM
Replies: 16
Views: 617
Posted By Aries240SS
Sounds like plugs fouling out to me. You floor it...

Sounds like plugs fouling out to me. You floor it and the plugs clean up for a while before the problem comes back. Check the tune and AFR at part throttle where it is happening. You'll probably find...
Forum: USA - Texas 04-29-2015, 05:41 PM
Replies: 8
Views: 916
Posted By Aries240SS
I did Huperoptik tint from EVS Motors....

I did Huperoptik tint from EVS Motors. 713-588-2308 is their number.
My tint has a very slight rainbowing with my prescription sunglasses, but it's nothing like sitting in a friend's car with cheap...
Forum: Dragstrip and Launch Techniques Discussion 04-29-2015, 04:01 PM
Replies: 144
Views: 12,924
Posted By Aries240SS
Advertising says they should be 29" Mickey...

Advertising says they should be 29"
Mickey Thompson ET Street Radial Tire
P305/45R18(29'' x 11.5'' - 18'')

It really works out to like 28.7"
Showing results 1 to 30 of 384

 
Forum Jump

All times are GMT -5. The time now is 05:52 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.