Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
River City Camaro Customs
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 500
Search took 0.12 seconds.
Search: Posts Made By: MagnumForceGB
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 05-25-2015, 07:55 PM
Replies: 822
Views: 52,295
Posted By MagnumForceGB
Seriously, get an HP Tuner or get the tuner...

Seriously, get an HP Tuner or get the tuner yourself and tune it. Trifecta kinda screws up how the Bosch ECU is supposed to work.
Forum: Forced Induction - V6 05-25-2015, 01:03 PM
Replies: 930
Views: 71,661
Posted By MagnumForceGB
Got the IAT sensor in the intake manifold now,...

Got the IAT sensor in the intake manifold now, should see the cold meth temps now. With the new methanol position I had the IAT was before the nozzle, so it wasn't seeing the cold temps. Can tune...
Forum: Forced Induction - V6 05-25-2015, 09:39 AM
Replies: 7
Views: 277
Posted By MagnumForceGB
Just duct tape the head unit to the intake, it...

Just duct tape the head unit to the intake, it will work.
Forum: Chevy Camaro vs... 05-24-2015, 08:39 PM
Replies: 560
Views: 54,485
Posted By MagnumForceGB
The bullshit just got extremely deep in this...

The bullshit just got extremely deep in this thread. So glad I actually go to the track and truely race instead of bench racing.
Forum: Chevy Camaro vs... 05-24-2015, 12:18 PM
Replies: 560
Views: 54,485
Posted By MagnumForceGB
DOHC also allows a lot broader power curve than...

DOHC also allows a lot broader power curve than pushrod. The LS3 peak torque is at 4600 RPM with its peak HP at 5900 RPM, peak-to-peak of 1300 RPM's. The Coyote peak torque is at 4250 RPM and peak...
Forum: Forced Induction - V6 05-24-2015, 09:34 AM
Replies: 930
Views: 71,661
Posted By MagnumForceGB
Well, we normally only get 4 inches of rain in...

Well, we normally only get 4 inches of rain in May, so far we have had 17 inches and more is on the way. Thunder Valley is flooded out now.
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 05-23-2015, 12:47 PM
Replies: 6
Views: 536
Posted By MagnumForceGB
It can increase your octane rating so you can add...

It can increase your octane rating so you can add more timing, but if you spray too much you will need to remove fuel so you don't run too rich. You would also need to put an IAT sensor after the...
Forum: General Automotive + Other Cars Discussion 05-22-2015, 11:13 PM
Replies: 62
Views: 2,570
Posted By MagnumForceGB
Better than leaving a pile of dead bodies because...

Better than leaving a pile of dead bodies because you don't want to spend an extra $2 to fix something simple.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-21-2015, 02:44 PM
Replies: 13
Views: 597
Posted By MagnumForceGB
On the V6, no, they are deep in the head due to...

On the V6, no, they are deep in the head due to DOHC. They are also coil-on-plug type.
Forum: General Automotive + Other Cars Discussion 05-21-2015, 01:05 PM
Replies: 62
Views: 2,570
Posted By MagnumForceGB
Congrats on the 2015 Mustang, was looking at...

Congrats on the 2015 Mustang, was looking at getting one myself but preferred the 2014 looks. The Coyote is definitely a fun engine.
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 05-21-2015, 09:15 AM
Replies: 9
Views: 513
Posted By MagnumForceGB
If tuned right and you have the tires, huge gain....

If tuned right and you have the tires, huge gain. I've only picked up 0.1 seconds so far with the same tires but I'm still working on the tune. I have 3.91 gears in my auto.
Forum: Dragstrip and Launch Techniques Discussion 05-20-2015, 10:29 AM
Replies: 19
Views: 787
Posted By MagnumForceGB
Practice, practice, practice. I can rip a 1.918...

Practice, practice, practice. I can rip a 1.918 60' time on BF Goodrich Sport Comp 2's (340 treadwear) in 275, stock tire pressure, and a V6. Avoid the water box, spin the tires to clean them off...
Forum: Forced Induction - V6 05-20-2015, 10:10 AM
Replies: 12
Views: 296
Posted By MagnumForceGB
Also, the tables in HP Tuners could also be...

Also, the tables in HP Tuners could also be degrees when the valves come unseated, so 21 degrees could be the point of contact with the 15 degrees being the unseat degrees. For exhaust side, 21...
Forum: Forced Induction - V6 05-20-2015, 09:17 AM
Replies: 12
Views: 296
Posted By MagnumForceGB
Thank you, can visualize what I'm doing with the...

Thank you, can visualize what I'm doing with the camshafts easier now. The tables say 7 degrees for intake, 15 for exhaust in park, but really don't say if it is opening or closing startstop.
...
Forum: Forced Induction - V6 05-19-2015, 12:02 PM
Replies: 12
Views: 296
Posted By MagnumForceGB
I can also lower my shift RPM, I'm revving to...

I can also lower my shift RPM, I'm revving to 7200 right now, adding an extra psi. I just need more boost at 5000 RPM's, at 6 right now after a shift.

Do you know where I can find the stock cam...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 05-19-2015, 10:00 AM
Replies: 822
Views: 52,295
Posted By MagnumForceGB
Get a HP tune, wish I could give you my 3.91...

Get a HP tune, wish I could give you my 3.91 trans tune, it will wheel hop on the 1-2 shift.
Forum: Forced Induction - V6 05-19-2015, 08:40 AM
Replies: 12
Views: 296
Posted By MagnumForceGB
Still stock internals. Thanks for the info...

Still stock internals.

Thanks for the info Gretchen, looks like I run 21 right now, 15 psi would put me at 22. Now that I have my methanol spraying the correct way I'm running around 25 degrees...
Forum: Forced Induction - V6 05-18-2015, 09:17 PM
Replies: 12
Views: 296
Posted By MagnumForceGB
LLT Max Boost

What do you think the most boost the LLT can handle before it does an oil change in the middle of the road? I'm at 13 PSI on a cool day, thinking of going to 15 PSI now with Methanol as a secondary...
Forum: Forced Induction - V6 05-18-2015, 01:10 PM
Replies: 930
Views: 71,661
Posted By MagnumForceGB
Finally hit 50,000 miles on my Camaro, was at...

Finally hit 50,000 miles on my Camaro, was at 48,500 in November when I did the rear end swap. Now I can change the rear end fluid along with the oil.

With this new setup I'm going to have to...
Forum: 6th gen Camaro vs... 05-18-2015, 10:24 AM
Replies: 150
Views: 3,871
Posted By MagnumForceGB
The turbo 4 makes almost 40 ft-lbs more torque...

The turbo 4 makes almost 40 ft-lbs more torque than the V6 option, important since most users won't take their car over 5000 RPM's.
Forum: Off-topic Discussions 05-18-2015, 09:07 AM
Replies: 32
Views: 833
Posted By MagnumForceGB
Depends on the weight and final gear ratio. The...

Depends on the weight and final gear ratio. The autos could have a 2.73 rear and very soft shifting settings to preserve the transmission with more moving parts.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-17-2015, 11:16 AM
Replies: 81
Views: 10,265
Posted By MagnumForceGB
40 MPH going downhill with a 80 MPH tail-wind.

40 MPH going downhill with a 80 MPH tail-wind.
Forum: Dragstrip and Launch Techniques Discussion 05-15-2015, 05:54 PM
Replies: 2,336
Views: 176,012
Posted By MagnumForceGB
Too slow to even crack our top 10 V6 list.

Too slow to even crack our top 10 V6 list.
Forum: Forced Induction - V6 05-14-2015, 01:04 PM
Replies: 930
Views: 71,661
Posted By MagnumForceGB
Going to have a lot of time to tune my Camaro...

Going to have a lot of time to tune my Camaro now, started installing the kooks headers and I need to drop the K-member to finish. So far though, I'm really liking this relocation, throttle response...
Forum: Chevy Camaro vs... 05-14-2015, 09:07 AM
Replies: 78
Views: 7,784
Posted By MagnumForceGB
I'm thinking he is a troll. Every Camaro V8...

I'm thinking he is a troll. Every Camaro V8 owner that I know at Thunder Valley (the drag strip for Oklahoma City) says nothing but good things about the Mustang 5.0 exhaust and power.
Forum: Forced Induction - V6 05-13-2015, 08:35 AM
Replies: 930
Views: 71,661
Posted By MagnumForceGB
Drove the Camaro this morning after the MAF...

Drove the Camaro this morning after the MAF relocation, I took 15% off my frequency table and I was way off. Fuel trims were pegged at -25%, so I have a lot of tuning to do now. Throttle lag is...
Forum: Forced Induction - V6 05-11-2015, 09:22 AM
Replies: 930
Views: 71,661
Posted By MagnumForceGB
I couldn't believe it, took the part number and...

I couldn't believe it, took the part number and kept searching for it to make sure it was the real deal. Only 1-5/8" primaries though so I'm limited to 425 rwhp. Don't plan on more anyways since I...
Forum: General Automotive + Other Cars Discussion 05-11-2015, 08:13 AM
Replies: 286
Views: 72,476
Posted By MagnumForceGB
Or he will have every lawyer within 50 miles...

Or he will have every lawyer within 50 miles offering their services for free. Wrongful arrest suit will probably follow if true.
Forum: Forced Induction - V6 05-10-2015, 10:06 PM
Replies: 930
Views: 71,661
Posted By MagnumForceGB
Definitely wouldn't do it with the stock catch...

Definitely wouldn't do it with the stock catch can system with how much oil blow-by it had.
Forum: Forced Induction - V6 05-10-2015, 06:44 PM
Replies: 930
Views: 71,661
Posted By MagnumForceGB
Weather has been crap but I finally got to work...

Weather has been crap but I finally got to work on my Camaro today. Moved the MAF from a draw-thru to a blow-thru setup. Will be working on tuning it now, shouldn't be too much difference and the RPM...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 03:58 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.