Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Jason 98 TA
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 219
Search took 0.02 seconds.
Search: Posts Made By: fz4k98
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 09-09-2017, 09:23 PM
Replies: 282
Views: 93,001
Posted By fz4k98
Tire vibration

I am running into trouble with the tires developing excess run out after hard launches. I am running mickey Thompson et street as 285 x 20 on stock ss wheels. Car has 610 hp to the wheels. I picked...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-24-2017, 07:38 PM
Replies: 23
Views: 1,508
Posted By fz4k98
Having the power is one thing. Using it eats up...

Having the power is one thing. Using it eats up stock parts.

The clutch survived about 2 months of fun. The rear suspension already had driveshaft and axles when I put on the slicks. 3 runs later...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-23-2017, 08:20 PM
Replies: 23
Views: 1,508
Posted By fz4k98
If you plan on using the power be ready to chase...

If you plan on using the power be ready to chase the next weak spot in the drivetrain once you go above 600 at the motor. I am in the middle of that now. I put a 2.9l whipped on a basically stock...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-23-2017, 08:13 PM
Replies: 11
Views: 779
Posted By fz4k98
What offset did you use not the rear?

What offset did you use not the rear?
Forum: 5th Gen Camaro SS LS LT General Discussions 07-04-2017, 07:29 PM
Replies: 62
Views: 2,802
Posted By fz4k98
A question for the ages here. Why do those who...

A question for the ages here. Why do those who don't have not understand those who do. Cars, cycles, hosted, planes, houses... quite a pattern I don't have it so you should not need it.
Forum: 5th Gen Camaro SS LS LT General Discussions 07-03-2017, 09:06 PM
Replies: 6
Views: 571
Posted By fz4k98
I went with a McLeod twin disk. Be ready for...

I went with a McLeod twin disk. Be ready for increased gear vibration at 1500 to 2000 rpm. It is bad enough that it will change your driving habits. Clutch company says it is the trans. Trans company...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-03-2017, 08:58 PM
Replies: 62
Views: 2,802
Posted By fz4k98
Interesting thread. The stock camaro is computer...

Interesting thread. The stock camaro is computer limited at 155 mph but that is not too much power for the street? These cars break any speed law in 3rd gear but that is not too much speed.

The v6...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-03-2017, 09:44 PM
Replies: 1
Views: 252
Posted By fz4k98
Tom's and drag radials

I made it to the track today to test the et street drag radials and while trying to dial in the tire pressure the low tire warning had to be overridden at each startup. Has anyone come up with a...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-28-2017, 09:25 PM
Replies: 16
Views: 697
Posted By fz4k98
I just put some et streets on the back. I am...

I just put some et streets on the back. I am running the stock Pirelli up front. The negatives for the et streets I find are hydroplaning at highway speed in the rain and setting correct tire...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2017, 08:25 PM
Replies: 339
Views: 25,121
Posted By fz4k98
Gen 1 - 1967 Gen 3 - 1984 Gen 5 - 2013 ...

Gen 1 - 1967
Gen 3 - 1984
Gen 5 - 2013

See the odd number pattern? Hoping for an awesome gen 7
Forum: 5th Gen Camaro SS LS LT General Discussions 05-10-2017, 06:54 PM
Replies: 35
Views: 2,526
Posted By fz4k98
Smile I removed mine and picked up 200+ horsepower. Oh...

I removed mine and picked up 200+ horsepower. Oh wait, I removed mine because of the 2.9L whipple
Forum: 5th Gen Camaro SS LS LT General Discussions 03-15-2017, 08:12 PM
Replies: 8
Views: 703
Posted By fz4k98
I have had dirty throttle body and maf sensor...

I have had dirty throttle body and maf sensor cause the computer to cause it to run terrible like it was in limp mode or reduced power. In relation to the 1 piece driveshaft, I installed one and I...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 03-09-2017, 06:56 PM
Replies: 4
Views: 309
Posted By fz4k98
Thanks for the feedback and I really liked the...

Thanks for the feedback and I really liked the link. I am having enough stabilitrack issues and did not want to throw more.
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 03-08-2017, 05:57 PM
Replies: 4
Views: 309
Posted By fz4k98
Different diameter wheels?

I am working on getting some 18 inch wheels and ET drag radials for the rear. Can I run 20 inch front wheels and 18 inch rear wheels? I don't want to mess with the roller skate mod for the front.
Forum: Forced Induction - V8 01-25-2017, 08:31 PM
Replies: 21
Views: 2,387
Posted By fz4k98
I put a whipple on my Camaro and the drivability...

I put a whipple on my Camaro and the drivability was the same once they figured out the idle. Did not even know it was there until I got on it. I also have a malibu 2.0 factory turbo and love the...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-13-2016, 06:57 PM
Replies: 3
Views: 395
Posted By fz4k98
Gm products have issues with the throttle body...

Gm products have issues with the throttle body capturing build up sludge etc on the back side. It can cause the error. I have had this happen on a truck, malibu and my Camaro. Cleaned the throttle...
Forum: Off-topic Discussions 09-07-2016, 08:26 PM
Replies: 82
Views: 6,167
Posted By fz4k98
There is an interesting twist coming up here. Car...

There is an interesting twist coming up here. Car drivers don't understand why someone would ride a dangerous bike and some even want to ban them. Now comes driverless cars and people will want to...
Forum: Off-topic Discussions 09-06-2016, 08:08 PM
Replies: 82
Views: 6,167
Posted By fz4k98
You don't buy a Harley to claim king of the sped...

You don't buy a Harley to claim king of the sped hill. Been riding 40 years and last purchase was a bagger that I still ride.

Riding is not dangerous, people running into riders is.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-06-2016, 09:18 PM
Replies: 12
Views: 1,610
Posted By fz4k98
What offset are you running to put on 315s rears...

What offset are you running to put on 315s rears and 275 front?
Forum: 5th Gen Camaro SS LS LT General Discussions 07-26-2016, 07:55 PM
Replies: 9
Views: 598
Posted By fz4k98
I just added a whipple 2.9L to an ss. Started at...

I just added a whipple 2.9L to an ss. Started at about 410 rwhp with the headers, cats and cai. Ended up with 610rwhp with just the whipple and tune addition.
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 07-19-2016, 07:55 PM
Replies: 1
Views: 369
Posted By fz4k98
Mag wheel speed ratings

I am looking into buying some aftermarket wheels. I know tires are speed rated but was curious if wheels are speed rated? I was not sure if price etc. Was a consideration or there was a rating.
Forum: Forced Induction - V8 07-01-2016, 06:11 PM
Replies: 23
Views: 2,814
Posted By fz4k98
I have the 4 inch pulley installed with 1 7/8"...

I have the 4 inch pulley installed with 1 7/8" ARH long tube headers, high flow cats and a CAI. When I went in to talk about doing it they said they were having great luck with the whipple and I am...
Forum: Forced Induction - V8 06-30-2016, 08:50 PM
Replies: 23
Views: 2,814
Posted By fz4k98
thumbs up to supercharging

I just got my car back this week with an added whipple 2.9L. The LS3 just loves supercharging. Ended up pulling 610 rwhp.

Any advice on how to get it to hookup is appreciated.

If your looking...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-13-2016, 07:56 PM
Replies: 7
Views: 905
Posted By fz4k98
If it is what I think it is, once the...

If it is what I think it is, once the weatherstripping is on the vehicle you pull that piece out slowly working around the perimeter. It will pull the weatherstripping over the metal flange....
Forum: Forced Induction - V8 05-09-2016, 08:04 PM
Replies: 152
Views: 7,636
Posted By fz4k98
Make sure you get a company that responds since...

Make sure you get a company that responds since you are laying out a lot of money and may need support. I got as far as a quote from one company and no response from another before no acknowledgement...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-12-2016, 08:11 PM
Replies: 53
Views: 5,066
Posted By fz4k98
I read your original post and you mentioned...

I read your original post and you mentioned breaking while tightening and loosening. Here is something to consider. If you are finish seating the studs under medium to high torque it is a likely...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-20-2016, 07:35 PM
Replies: 18
Views: 1,733
Posted By fz4k98
I will be installing one in about a month. Any...

I will be installing one in about a month. Any words of wisdom or things to watch for on the install?
Forum: 5th Gen Camaro SS LS LT General Discussions 02-19-2016, 07:45 PM
Replies: 103
Views: 10,544
Posted By fz4k98
You mentioned sitting in the car is OK but...

You mentioned sitting in the car is OK but operating the pedals causes it. It sounds like you are holding your legs in position instead of adjusting the car so you can operate the pedals by just...
Forum: 5th Gen Camaro SS LS LT General Discussions 02-03-2016, 06:31 PM
Replies: 30
Views: 3,458
Posted By fz4k98
I put long tube and high flow cats on and kept...

I put long tube and high flow cats on and kept all sensors in play too. I guess it depends on the product.
Forum: 5th Gen Camaro SS LS LT General Discussions 10-27-2015, 06:55 PM
Replies: 83
Views: 9,475
Posted By fz4k98
The 6th gen is a good looking car but I am real...

The 6th gen is a good looking car but I am real glad I bought my 2013. Now that the new one is out my mind is made up to keep mine.

They went from updated classic 5th gen, to new sports car 6th...
Showing results 1 to 30 of 219

 
Forum Jump

All times are GMT -5. The time now is 07:11 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2017, vBulletin Solutions, Inc.