Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Phastek Performance
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Showing results 1 to 22 of 22
Search took 0.01 seconds. Search: Posts Made By: izaks
Forum: Tuning / Diagnostics -- engine and transmission 11-06-2014, 01:28 PM
Replies: 1
Views: 1,167
Posted By izaks
Check map values when it shuts down. Your...

Check map values when it shuts down.
Your intake pipe may be collapsing
Forum: Forced Induction - V8 10-11-2014, 10:53 AM
Replies: 4
Views: 1,404
Posted By izaks
Been spraying for over 10 years. First on a...

Been spraying for over 10 years.
First on a LS1 with Whipple 2.3, then on 402 with Whipple 2.3 / 3.3 and FF2.9
Currently LS3 416 with FF2.9
Overstepped the mark recently with too much NOS and...
Forum: Forced Induction - V8 10-11-2014, 10:45 AM
Replies: 3
Views: 3,642
Posted By izaks
If you fitted a lower temp thermostat - P0116...

If you fitted a lower temp thermostat - P0116 will set (and disable your A/C)
Switch P0116 and P0128 off in the tune
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 04-29-2013, 02:30 PM
Replies: 2
Views: 787
Posted By izaks
One time puchase of 20

One time puchase of 20
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 04-29-2013, 02:03 AM
Replies: 2
Views: 787
Posted By izaks
WTB - LS3 Thermostats

Looking to buy 20 LS3 160/180' thermostats
Forum: Forced Induction - V8 06-18-2012, 03:39 PM
Replies: 12
Views: 11,264
Posted By izaks
There is a pressure sensor in the brake booster...

There is a pressure sensor in the brake booster and gets compared to the pressure in the manifold and sets the code if it sees a difference.
You have to switch the code off in the ECM
Forum: Forced Induction - V8 02-27-2012, 02:43 PM
Replies: 10
Views: 3,669
Posted By izaks
Correct. If your "key on" map is 100kpa at...

Correct.

If your "key on" map is 100kpa at sea level, and 85kpa at 6000ft (like we are) than you have "lost" .15kpa (2.175lb) in boost.
We have to run our Mp1900's (on the L76/L98) with the 2.8"...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-08-2012, 01:12 PM
Replies: 3
Views: 6,424
Posted By izaks
The Camaro water pump is further forward than the...

The Camaro water pump is further forward than the Corvette and is not interchangeable.
251-728 (19180610) runs closest to the engine (Corvette / G8)
251-734 (19207665) is +/- 50mm forward (Camaro)
Forum: Tuning / Diagnostics -- engine and transmission 01-08-2012, 12:44 PM
Replies: 10
Views: 6,318
Posted By izaks
When 420/430 is set, the car will run...

When 420/430 is set, the car will run considerably richer
Forum: Tuning / Diagnostics -- engine and transmission 01-04-2012, 12:57 PM
Replies: 6
Views: 2,689
Posted By izaks
Conditions for setting DTC DTC P0121 The TP...

Conditions for setting DTC
DTC P0121
The TP sensor 1 disagrees more than 9% from TP sensor 2 or TP sensor 1 disagrees more than 9% from the predicted value. Either condition exists for more than 4...
Forum: Tuning / Diagnostics -- engine and transmission 12-26-2011, 09:30 AM
Replies: 28
Views: 4,877
Posted By izaks
Post your tune and a log.

Post your tune and a log.
Forum: Tuning / Diagnostics -- engine and transmission 12-26-2011, 04:12 AM
Replies: 8
Views: 1,809
Posted By izaks
Log GM.APP and you will see 0 to 100%

Log GM.APP and you will see 0 to 100%
Forum: Tuning / Diagnostics -- engine and transmission 12-06-2011, 01:08 PM
Replies: 21
Views: 9,829
Posted By izaks
Depending on load and RPM there can be a...

Depending on load and RPM there can be a difference of 15' of timing between the high and low octane timing tables.
The worst thing you can do is copy high to low. Tune it properly !
It is not an...
Forum: Tuning / Diagnostics -- engine and transmission 10-30-2011, 08:31 AM
Replies: 4
Views: 4,798
Posted By izaks
Is the car supercharged ? If it is - get...

Is the car supercharged ?
If it is - get someone who has EFILive and increase the values of
C0807 and C0808
Forum: Forced Induction - V8 04-13-2011, 02:40 AM
Replies: 121
Views: 31,270
Posted By izaks
Apologies :bow: The distinction I was...

Apologies :bow:

The distinction I was trying to make was between the Roots crowd (Magna/Eforce) and a Twin Screw. (Whipple/KB/Lysholm)
The Roots are "merely" air pumps (no pressure/boost inside...
Forum: Forced Induction - V8 04-12-2011, 02:42 PM
Replies: 121
Views: 31,270
Posted By izaks
You need to do your homework before making a...

You need to do your homework before making a comment like that.
All Roots/Magna blowers are NOT Positive Displacement blowers.
Forum: Forced Induction - V8 04-09-2011, 04:23 PM
Replies: 121
Views: 31,270
Posted By izaks
" All the PD blowers are going to have close to...

"
All the PD blowers are going to have close to the same horsepower and torque granted they are running the same boost. "

Not even close.

The lower the intake charge temp, the denser it...
Forum: Forced Induction - V8 04-03-2011, 02:35 PM
Replies: 12
Views: 2,106
Posted By izaks
Check your fuel pressure at key on. If it drops...

Check your fuel pressure at key on.
If it drops off very quickly, then the non return valve in the fuel pump has gone awol, and the most likely cause of your starting problem.
Try key on, key off,...
Forum: Forced Induction 02-23-2011, 12:08 AM
Replies: 110
Views: 8,528
Posted By izaks
See post 21 please

See post 21 please
Forum: Forced Induction - V8 02-13-2011, 03:13 PM
Replies: 45
Views: 12,316
Posted By izaks
From the pictures I have seen, the "bucket" has...

From the pictures I have seen, the "bucket" has been removed.
This WILL result in fuel starvation when the level in the tank is low, due to the fact that the fuel will move away from the pump pick...
Forum: Forced Induction - V8 01-03-2011, 12:16 PM
Replies: 65
Views: 15,977
Posted By izaks
Quote"There is a way to plumb the IAT in the side...

Quote"There is a way to plumb the IAT in the side of the manifold, however you would need to speak to Jeff at Whipple regarding this."

There is already a pre-drilled and tapped hole on the...
Forum: Forced Induction 12-31-2010, 12:16 PM
Replies: 110
Views: 8,528
Posted By izaks
2 x Black full 1 x Black tuner Please

2 x Black full
1 x Black tuner
Please
Showing results 1 to 22 of 22

 
Forum Jump

All times are GMT -5. The time now is 11:27 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.