Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Emblempros
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 126
Search took 0.02 seconds.
Search: Posts Made By: granatl
Forum: Tuning / Diagnostics -- engine and transmission 03-26-2015, 09:53 PM
Replies: 10
Views: 198
Posted By granatl
GM VE is a value calculated from numerous PIDs....

GM VE is a value calculated from numerous PIDs. etc. You can log GMVE in the HP Tuners VCM Scanner software, MAP kPa vs. RPM.
This way, you get VE numbers that are spot-on with what the car's...
Forum: Forced Induction - V8 03-26-2015, 09:31 PM
Replies: 1
Views: 96
Posted By granatl
I have a built LS2 iron block and turbo w/ the...

I have a built LS2 iron block and turbo w/ the Melling pump. My hot idle is around 30-35 PSI.

My turbo oil inlet has a restrictor, so I have my doubts whether you "need" anything special regarding...
Forum: Tuning / Diagnostics -- engine and transmission 03-25-2015, 08:02 PM
Replies: 3
Views: 116
Posted By granatl
I asked this same question on the HP Tuners...

I asked this same question on the HP Tuners board. Paraphrasing... The boost pressure offsets the fuel pressure, so there's no need to compensate for this.

I have the wrong OS loaded, so I tell...
Forum: Tuning / Diagnostics -- engine and transmission 02-25-2015, 10:30 PM
Replies: 5
Views: 297
Posted By granatl
With software like HP Tuners, a tuner can lock a...

With software like HP Tuners, a tuner can lock a tune so that you can't modify it. Otherwise, they are interchangeable. I think a locked tune can be overridden with EFI Live.
Forum: Tuning / Diagnostics -- engine and transmission 02-24-2015, 10:10 PM
Replies: 1
Views: 202
Posted By granatl
Consider changing the FPCM output voltages table...

Consider changing the FPCM output voltages table [HP Tuners = System -> General -> Fuel System (Minimum Voltage)]

You don't want to push the voltage so high, that the fuel pressure is...
Forum: Forced Induction - V8 02-14-2015, 08:39 AM
Replies: 3
Views: 236
Posted By granatl
If you want nice drive-ability, then your tuner...

If you want nice drive-ability, then your tuner would need to know the various flow rates of those injectors under the various conditions. W/o that info, it could cost you a fortune in trial and...
Forum: Forced Induction - V8 02-10-2015, 11:08 PM
Replies: 28
Views: 1,516
Posted By granatl
http://www.camaro5.com/forums/showthread.php?p=570...

http://www.camaro5.com/forums/showthread.php?p=5708189#post5708189
Forum: Forced Induction - V8 02-08-2015, 02:41 PM
Replies: 28
Views: 1,516
Posted By granatl
I switched over to this a few months ago. A buddy...

I switched over to this a few months ago. A buddy of mine did the install. My only complaint (so to speak), is that I have to pull the sender to bend the float since it reads consistently 1/4 tank...
Forum: Manuals, Literature, Workbooks, Brochures, Etc. 02-07-2015, 05:58 AM
Replies: 43
Views: 6,007
Posted By granatl
Payment sent for both.

Payment sent for both.
Forum: Tuning / Diagnostics -- engine and transmission 02-03-2015, 07:22 PM
Replies: 3
Views: 379
Posted By granatl
On the older e38 ECU's, there's a string of...

On the older e38 ECU's, there's a string of threads that people swear that they have to do the "overnight" fuse pull trick to get the car to flip back to the more aggressive timing map. Since it's...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 02-02-2015, 09:06 PM
Replies: 7
Views: 391
Posted By granatl
I have the stock 6l80e and converter out of my...

I have the stock 6l80e and converter out of my 2010 w/ 28k miles on them. The fluid was COMPLETELY changed about 4k miles ago. I switched to a higher stall converter and fully built 6l80e. I'd like...
Forum: Tuning / Diagnostics -- engine and transmission 01-30-2015, 07:39 PM
Replies: 1
Views: 330
Posted By granatl
This is hard to diagnose w/o seeing the HPT file....

This is hard to diagnose w/o seeing the HPT file.

It's because you specifically mention 4k RPM that makes me wonder if the car is transitioning into dynamic airflow mode and the MAP is way off. ...
Forum: Tuning / Diagnostics -- engine and transmission 01-23-2015, 03:18 PM
Replies: 2
Views: 321
Posted By granatl
I know in the older 5th Gen Camaros, this is...

I know in the older 5th Gen Camaros, this is possible. You could get a Flex Fuel simulator to fake the computer into believing it's running on e85, then build the timing & fuel tables as if you had...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-22-2015, 11:26 AM
Replies: 7
Views: 327
Posted By granatl
Sold!

Sold!
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-22-2015, 11:23 AM
Replies: 7
Views: 327
Posted By granatl
Their website shows 800 RWHP. IDK how...

Their website shows 800 RWHP.


IDK how much mine is putting down ATM. (1) I've exceeded the output of the turbo and have a bigger one coming. (2) I've never done dyno pulls to find out. (3) I'm...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-22-2015, 06:27 AM
Replies: 7
Views: 327
Posted By granatl
I'd say right around 10k miles (~2 years). I...

I'd say right around 10k miles (~2 years).
I did run them pretty much non-stop on e85. Since alcohol is less dense than gasoline, your power limit is probably more like ~650-700 HP.
I do have a...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-21-2015, 09:24 PM
Replies: 7
Views: 327
Posted By granatl
I also have a stock FPCM that I no longer need.

I also have a stock FPCM that I no longer need.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-21-2015, 09:09 PM
Replies: 7
Views: 327
Posted By granatl
Livernois Dual Fuel Pump

Dual fuel pump setup out of my 2010 Camaro.
http://www.livernoismotorsports.com/products/2010%252b-Camaro-SS-%7B47%7D-ZL1-Dual-Fuel-Pump-Assembly.html

$900 new, will sell for $400 ground shipped...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 01-18-2015, 10:54 PM
Replies: 0
Views: 231
Posted By granatl
Will these fit my 2010 SS RS?

I have to go with wider tires on the back of my 2010 2SS RS with Brembo brakes, etc. I have switched to the heavier duty rear axles, but otherwise the suspension is 100% stock.

Will these wheels...
Forum: Forced Induction - V8 01-18-2015, 07:44 PM
Replies: 7
Views: 379
Posted By granatl
I knew my wastegate was partially sticking, so I...

I knew my wastegate was partially sticking, so I lapped the valve stem, etc. until it could slide smoothly. I went for a ride and now I can clearly see the boost decay as RPM increases. So something...
Forum: Forced Induction - V8 01-18-2015, 05:20 PM
Replies: 7
Views: 379
Posted By granatl
LOL. This conversation is about to go in the...

LOL. This conversation is about to go in the gutter!


Yes, 3" downpipe.
Forum: Forced Induction - V8 01-18-2015, 03:49 PM
Replies: 7
Views: 379
Posted By granatl
I'm more like a 6.66 L -- just pure evil :) ...

I'm more like a 6.66 L -- just pure evil :)
Thank you for such a thorough answer! This isn't part of a kit (per se), but hopefully I can talk to them and change to the wheels that you're suggesting.
Forum: Forced Induction - V8 01-18-2015, 02:48 PM
Replies: 7
Views: 379
Posted By granatl
Is my turbo too small?

I have a single, underhood, GT-76 (Turbonetics, I think) turbo. For well over a year, I've been trying to figure out why the boost is so low. I have a setup that should support something >1000 HP...
Forum: Forced Induction - V8 01-04-2015, 03:40 PM
Replies: 5
Views: 428
Posted By granatl
It's a MAF screen to cut down the turbulence of...

It's a MAF screen to cut down the turbulence of the air as it passes over the MAF. Supposed to help even out some of the part throttle surging.
Forum: Forced Induction - V8 01-04-2015, 12:50 PM
Replies: 5
Views: 428
Posted By granatl
Car wouldn't run

https://lh3.googleusercontent.com/-i5UOxiYYvUU/VKmMc6R_B3I/AAAAAAAALn8/KWFdswBoESQ/w496-h661-no/20150104_095847.jpg

About 6 weeks ago, I was on my way home when I went to pass someone and I got...
Forum: Forced Induction - V8 11-11-2014, 06:46 PM
Replies: 24
Views: 1,185
Posted By granatl
After reading this thread, I decided to take out...

After reading this thread, I decided to take out my expensive iridium 41-110's. {I run e85, so I went a heat range hotter than normal}. I put in (most) of the BR7EF's. I immediately noticed that my...
Forum: Forced Induction - V8 10-24-2014, 09:22 PM
Replies: 6
Views: 520
Posted By granatl
My buddy tapped my feed line into the oil-water...

My buddy tapped my feed line into the oil-water cooler.
Forum: Tuning / Diagnostics -- engine and transmission 10-23-2014, 02:09 AM
Replies: 1
Views: 335
Posted By granatl
I had that warning before too. In my case, the...

I had that warning before too. In my case, the one connector fell off the temperature sensor. It's that sensor near the #1 spark plug (behind the power steering pump on the driver's side head).
Forum: Forced Induction - V8 10-03-2014, 06:47 PM
Replies: 16
Views: 1,101
Posted By granatl
I added a KB BAP to mine and really never noticed...

I added a KB BAP to mine and really never noticed much of a difference.
Changing the "Fuel System Minimum Voltage" parameters in the ECU seemed to have more of a positive effect.
Forum: Forced Induction - V8 09-16-2014, 08:18 PM
Replies: 29
Views: 1,841
Posted By granatl
I also like Amsoil and will add some ZDDP. It's...

I also like Amsoil and will add some ZDDP. It's important to know that zinc helps protect in higher HP engines, but also damages catalytic converters.
Showing results 1 to 30 of 126

 
Forum Jump

All times are GMT -5. The time now is 11:12 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.