Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
BeckyD@RodgersChevrolet
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 419
Search took 0.05 seconds.
Search: Posts Made By: 1MtnGoat
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-30-2015, 10:17 AM
Replies: 20
Views: 568
Posted By 1MtnGoat
I was probably the first one to put ceramic pads...

I was probably the first one to put ceramic pads on back in May of 2012. Currently just over 45,000 miles on the Hawk ceramic pads. Pads show hardly any wear, rotors look almost new. Dust is a...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-20-2015, 06:59 AM
Replies: 50
Views: 2,426
Posted By 1MtnGoat
Drive coupler is changed so supposedly it will...

Drive coupler is changed so supposedly it will not wear and cause bearing problems. Blower warranty is also extended.
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 08-17-2015, 09:07 PM
Replies: 13
Views: 611
Posted By 1MtnGoat
Yes to more air and camber!

Yes to more air and camber!
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-17-2015, 08:30 AM
Replies: 3
Views: 298
Posted By 1MtnGoat
It's totally normal. The simple version is - the...

It's totally normal. The simple version is - the voltage varies depending on the electrical needs and state of battery charge. Alternator actually turns off at times and all is run on the battery. ...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-14-2015, 10:28 PM
Replies: 5
Views: 327
Posted By 1MtnGoat
I've read that the front and rear wheel diameters...

I've read that the front and rear wheel diameters must be within 3% of each other or it will cause problems.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-14-2015, 10:16 PM
Replies: 2
Views: 214
Posted By 1MtnGoat
OEM coming out and into the SC is 5/8" ID. Into...

OEM coming out and into the SC is 5/8" ID. Into the pump is 3/4" ID
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-04-2015, 10:01 PM
Replies: 96
Views: 2,272
Posted By 1MtnGoat
'66 GTO '72 Vega GT '76 Camaro '85 Subaru...

'66 GTO
'72 Vega GT
'76 Camaro
'85 Subaru XT Turbo
'04 GTO
'12 ZL1

All but the Subaru were built in some form or another.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 07-06-2015, 08:45 PM
Replies: 8
Views: 481
Posted By 1MtnGoat
My point was that the alternator voltage varies...

My point was that the alternator voltage varies as needed per the ECU. I wasn't aware you wanted fine detail. Enjoy your new ride!
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 07-06-2015, 08:28 AM
Replies: 8
Views: 481
Posted By 1MtnGoat
The alternator "turns on and off" depending on...

The alternator "turns on and off" depending on the demands of the electrical system and battery voltage. My voltage runs from mid 12s to mid 14s.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-17-2015, 10:05 AM
Replies: 31
Views: 1,760
Posted By 1MtnGoat
3rd generation magnetic ride begin in the 2012...

3rd generation magnetic ride begin in the 2012 model. The ZL1 had 3rd before the vette.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-30-2015, 11:02 PM
Replies: 6
Views: 422
Posted By 1MtnGoat
Put a couple of these in then you can have...

Put a couple of these in then you can have anything you want! http://www.aeroforcetech.com/products_interceptor.html
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 02-02-2015, 07:37 PM
Replies: 8
Views: 1,200
Posted By 1MtnGoat
Warrenty still intact. Problem solved!

Warrenty still intact. Problem solved!
Forum: Cosmetics and Lighting Modification Discussions 02-01-2015, 08:02 AM
Replies: 6
Views: 484
Posted By 1MtnGoat
Rear diffuser is different between the last two...

Rear diffuser is different between the last two pictures.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-31-2015, 02:27 PM
Replies: 8
Views: 1,200
Posted By 1MtnGoat
Here's what the tech found when my S/C was...

Here's what the tech found when my S/C was replaced. I had noticed occasional puffs of white smoke on startup. There were no oil consumption issues. I had been adding a total of around 1/2 cup...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-31-2015, 10:06 AM
Replies: 25
Views: 2,487
Posted By 1MtnGoat
I had an occasional puff of white smoke on start...

I had an occasional puff of white smoke on start up. I also needed to add coolant to the intercooler system. About 1/2 cup a month. There never were any external leaks. I suspected an internal...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-13-2015, 08:39 PM
Replies: 18
Views: 1,363
Posted By 1MtnGoat
I would think the OD pulley would solve the...

I would think the OD pulley would solve the problem even at 5%. The flutter shows up at slow engine speed and is caused by the SC. If the SC is over driven a bit the engine can still run slow but...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 12-30-2014, 10:11 PM
Replies: 13
Views: 1,143
Posted By 1MtnGoat
The overall 1st gear ratio of an auto with stock...

The overall 1st gear ratio of an auto with stock rear gearing (3:23) is already lower than the MT with 3:73 gearing.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 12-23-2014, 08:10 AM
Replies: 5
Views: 1,569
Posted By 1MtnGoat
Here you go! ...

Here you go!

http://www.cultragfactoryparts.com/auto-parts/2012/chevrolet/camaro/zl1-trim/6-2l-v8-gas-engine/fuel-system-cat/supercharger-scat
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 11-17-2014, 10:58 PM
Replies: 33
Views: 2,024
Posted By 1MtnGoat
First car was a '66 GTO. Premium was around $.19...

First car was a '66 GTO. Premium was around $.19 gallon. Needed at least 96 octane or the 10.75 compression would rattle bad. If you got some bad gas you got out and twisted the distributor 'til...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 10-05-2014, 07:56 PM
Replies: 15
Views: 2,118
Posted By 1MtnGoat
Wiring plugs directly onto the OBDII port. No...

Wiring plugs directly onto the OBDII port. No special wiring needed. I've been running these for over well over two years now.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 09-26-2014, 12:45 AM
Replies: 30
Views: 2,488
Posted By 1MtnGoat
It's white. The A6 is no slouch. It'll run head...

It's white. The A6 is no slouch. It'll run head to head with the rest no problem. The paddles are great and the rev matching on downshifts is fantastic. Once you "learn" to drive it the A6 is...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 09-25-2014, 07:24 PM
Replies: 30
Views: 2,488
Posted By 1MtnGoat
There is a new '13 on the showroom floor at...

There is a new '13 on the showroom floor at Asheville Chevrolet in Asheville, NC. It's been there a long time. I drive by it several times a week. Call them and ask for Mark Henson he's the sales...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 09-14-2014, 10:47 AM
Replies: 23
Views: 2,340
Posted By 1MtnGoat
The OP was wondering wanting to know about octane...

The OP was wondering wanting to know about octane booster - octane rating effect.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 09-14-2014, 10:31 AM
Replies: 23
Views: 2,340
Posted By 1MtnGoat
My point was that there is not more "power" in...

My point was that there is not more "power" in premium. Yes, it's all about compression/pressure and the timing to go along with it. If you change the "compression" then the timing needs to be...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 09-14-2014, 09:46 AM
Replies: 23
Views: 2,340
Posted By 1MtnGoat
When I was in high school many years ago a...

When I was in high school many years ago a representative from an oil company came and spoke with our auto class. He demonstrated the difference between regular and premium gasoline. He had a clear...
Forum: Interior Parts & Accessories 09-07-2014, 06:48 PM
Replies: 2
Views: 718
Posted By 1MtnGoat
DashLogic for Sale

I have a new (used about 1 hour) DashLogic for sale. This is Model DL1020U for the 5th gen Camaro. I am selling because I guess I'm old fashioned. I was going to replace the gauges on my A-pillar...
Forum: Cosmetics and Lighting Modification Discussions 08-11-2014, 09:58 PM
Replies: 18
Views: 2,488
Posted By 1MtnGoat
More to do!

Change out the strut mount bolts. Also get some Polished AL pulleys like this http://www.camaro5.com/forums/showthread.php?t=294758&highlight=cleanup
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 07-14-2014, 11:07 PM
Replies: 3
Views: 680
Posted By 1MtnGoat
I doubt you can torque those to the required...

I doubt you can torque those to the required torque due to the small allen head socket. The description says they're for bodywork or plastic for "cosmetic appearance". I also think the shoulder...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 07-07-2014, 09:50 PM
Replies: 2
Views: 691
Posted By 1MtnGoat
Put a set of these in your pillar. ...

Put a set of these in your pillar. http://aeroforcetech.com/products_interceptor.html They plug into the OBDII port directly below the pillar under the lower left knee pad. Harness will run down...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 06-15-2014, 08:44 PM
Replies: 36
Views: 3,493
Posted By 1MtnGoat
I've had the Hawk Ceramics for over 31,000 miles....

I've had the Hawk Ceramics for over 31,000 miles. The pads are almost like new. They have never squeaked. When installing one needs to follow the proper bedding proceedure.
Showing results 1 to 30 of 419

 
Forum Jump

All times are GMT -5. The time now is 08:11 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.