Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
TireRack
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 500
Search took 0.19 seconds.
Search: Posts Made By: Rob@WretchedMS
Forum: Suspension / Brakes / Chassis 09-18-2014, 02:21 PM
Replies: 28
Views: 2,113
Posted By Rob@WretchedMS
Thanks for keeping everyone updated, appreciate...

Thanks for keeping everyone updated, appreciate it.
Forum: Suspension / Brakes / Chassis 09-17-2014, 11:40 AM
Replies: 8
Views: 512
Posted By Rob@WretchedMS
Take a look at the tech section on our website,...

Take a look at the tech section on our website, it's loaded with info that is based on Pedders products, which i may not be able to get for you currently, but the info is good.
I can get you other...
Forum: Suspension / Brakes / Chassis 09-17-2014, 11:25 AM
Replies: 5
Views: 527
Posted By Rob@WretchedMS
Actually, i might consider trying to add more...

Actually, i might consider trying to add more compression to the rears to prevent the rear from squatting too much,

Wheels and Tires will play in to it a lot, as well as driver, alignment, trans,...
Forum: Suspension / Brakes / Chassis 09-17-2014, 11:16 AM
Replies: 5
Views: 445
Posted By Rob@WretchedMS
if you are 100% certain that the rotors are...

if you are 100% certain that the rotors are installed on to the hubs with no debris in between them, then i would start with loosening the wheels and retorquing them with a torque wrench in a star...
Forum: Suspension / Brakes / Chassis 09-17-2014, 10:59 AM
Replies: 8
Views: 512
Posted By Rob@WretchedMS
If you can install suspension, you can install...

If you can install suspension, you can install suspension, doesn't matter if it's going up or down.
The subframe bushings would be the first thing i'd look at, preferably the full bushings vs the...
Forum: Suspension / Brakes / Chassis 07-09-2014, 09:26 PM
Replies: 41
Views: 2,116
Posted By Rob@WretchedMS
then check the width of the delsphere ferrule vs...

then check the width of the delsphere ferrule vs the stock ferrule,

Maybe there is a part missing that is supposed to be in there.
Forum: Suspension / Brakes / Chassis 07-09-2014, 09:04 PM
Replies: 41
Views: 2,116
Posted By Rob@WretchedMS
if it's tight (the bolt) it should not really be...

if it's tight (the bolt) it should not really be an issue, if it is moving then the bolt isn't holding it tight enough, try snugging it up a bit more.
Forum: Suspension / Brakes / Chassis 07-09-2014, 11:28 AM
Replies: 41
Views: 2,116
Posted By Rob@WretchedMS
ya, i've run in to it a few times with those,...

ya, i've run in to it a few times with those, mgiht not be the issue, but it's where i'd start.
Check the end links too
Forum: Suspension / Brakes / Chassis 07-09-2014, 11:25 AM
Replies: 26
Views: 2,535
Posted By Rob@WretchedMS
+1, or go to a set of coilovers.

+1, or go to a set of coilovers.
Forum: Suspension / Brakes / Chassis 07-09-2014, 11:22 AM
Replies: 41
Views: 3,903
Posted By Rob@WretchedMS
an hour is fair for the timing of the bushings,...

an hour is fair for the timing of the bushings, 1.5 hours is high but not obscene.
More than that and they are either pricing themselves out of the job on purpose, or just don't understand what is...
Forum: Suspension / Brakes / Chassis 07-09-2014, 11:13 AM
Replies: 41
Views: 2,116
Posted By Rob@WretchedMS
Have you had a chance to go through all of the...

Have you had a chance to go through all of the bolts and check them for tightness?
I would also concentrate on the spohn arms, make sure the delsphere joints are tight, if they are loose they can...
Forum: Suspension / Brakes / Chassis 07-09-2014, 08:34 AM
Replies: 41
Views: 3,903
Posted By Rob@WretchedMS
:thumbup:

:thumbup:
Forum: Suspension / Brakes / Chassis 07-08-2014, 12:41 PM
Replies: 8
Views: 635
Posted By Rob@WretchedMS
+1 Get some seat time and figure out what the...

+1
Get some seat time and figure out what the car does that you don't like. Once you know what you don't like we can fix it.

If you have a good idea already of what you don't like let us know.
Forum: Suspension / Brakes / Chassis 07-08-2014, 12:39 PM
Replies: 5
Views: 633
Posted By Rob@WretchedMS
i don't have any input on those rotors, but the...

i don't have any input on those rotors, but the DBA's are only about $25 per rotor more.
Forum: Suspension / Brakes / Chassis 07-07-2014, 09:46 PM
Replies: 19
Views: 1,066
Posted By Rob@WretchedMS
+1, i think they may say that because they...

+1,
i think they may say that because they want the hoses to be short enough to not drag, or move around too much.
Forum: Suspension / Brakes / Chassis 07-07-2014, 04:50 PM
Replies: 20
Views: 1,241
Posted By Rob@WretchedMS
i don't have any first hand info on Carbotech...

i don't have any first hand info on Carbotech street pads either, i stopped selling them before i could find out.
Forum: Suspension / Brakes / Chassis 07-07-2014, 04:49 PM
Replies: 8
Views: 648
Posted By Rob@WretchedMS
Play in steering = sitting stopped, with the car...

Play in steering = sitting stopped, with the car off (no dash lights on) but the wheel unlocked, wiggle the wheel, if you don't feel any 'looseness' it's not loose steering.

it's a bit of a...
Forum: Suspension / Brakes / Chassis 07-07-2014, 04:39 PM
Replies: 20
Views: 1,241
Posted By Rob@WretchedMS
just be sure that the pads can move with the...

just be sure that the pads can move with the pistons retracted, i'd be very surprised if this was an issue, just wanted to give you all of the options.
Forum: Suspension / Brakes / Chassis 07-07-2014, 03:39 PM
Replies: 8
Views: 648
Posted By Rob@WretchedMS
if the toe is out in the front or the rear it can...

if the toe is out in the front or the rear it can effect how the steering feels not so much looseness, but unresponsiveness, when was the last alignment done?
Forum: Suspension / Brakes / Chassis 07-07-2014, 03:28 PM
Replies: 3
Views: 414
Posted By Rob@WretchedMS
ya, you don't want to wait to long, at the very...

ya, you don't want to wait to long, at the very least they can get it close using the string method
Forum: Suspension / Brakes / Chassis 07-07-2014, 01:20 PM
Replies: 12
Views: 956
Posted By Rob@WretchedMS
Check the rear upper strut mount/spring perch,...

Check the rear upper strut mount/spring perch, make sure they are both bolted up to the car in the same manner, you can have one side all the way in towards the center of the car, and the other all...
Forum: Suspension / Brakes / Chassis 07-07-2014, 01:13 PM
Replies: 41
Views: 2,116
Posted By Rob@WretchedMS
:headbang:

:headbang:
Forum: Suspension / Brakes / Chassis 07-07-2014, 12:50 PM
Replies: 14
Views: 814
Posted By Rob@WretchedMS
Try going with a set of Hawk HP+ Pads, i think...

Try going with a set of Hawk HP+ Pads, i think you will like them.
They stop a ton better than the stock pads do, they handle the heat a lot better too.

The down side is they squeak more, and...
Forum: Suspension / Brakes / Chassis 07-07-2014, 12:46 PM
Replies: 2
Views: 353
Posted By Rob@WretchedMS
I'm Baaack!!!

Had to take a bit of a break from the online thing for a while, get life back on track, but now I'm here to make everyone's life better again!
...
Forum: Suspension / Brakes / Chassis 07-07-2014, 12:41 PM
Replies: 20
Views: 1,241
Posted By Rob@WretchedMS
the HP+ pads grab a ton better than the stock...

the HP+ pads grab a ton better than the stock ones, so Norm may be right about the difference being from you getting used to the added stopping power.

however, i would bleed them just to be...
Forum: Suspension / Brakes / Chassis 06-28-2014, 09:59 PM
Replies: 26
Views: 2,856
Posted By Rob@WretchedMS
you will be fine, i've been running the 5000...

you will be fine, i've been running the 5000 series for years and they work perfectly daily driven.

if i can help you with them let me know.
Forum: Suspension / Brakes / Chassis 05-01-2014, 02:27 PM
Replies: 314
Views: 46,595
Posted By Rob@WretchedMS
I was looking at the chart where you mentioned...

I was looking at the chart where you mentioned the aggressive street, which is not what you had it aligned to, didn't look back farther.

The alignment you have is more geared to drag racing,
Forum: Suspension / Brakes / Chassis 05-01-2014, 01:47 PM
Replies: 314
Views: 46,595
Posted By Rob@WretchedMS
Why did you go so positive on the rear camber, or...

Why did you go so positive on the rear camber, or did they not adjust that?

It looks like the before measurements were made before the lift was set on the locks (level) and just the toe was...
Forum: USA - New England 04-28-2014, 10:52 PM
Replies: 13
Views: 1,085
Posted By Rob@WretchedMS
Great Pics! Bruce is a great guy, it sucked...

Great Pics!

Bruce is a great guy, it sucked that he couldn't make it to the show.

We may do another type of show/get together over the summer, we'll see how it goes.
Who knows, maybe we will...
Forum: USA - New England 04-28-2014, 08:22 AM
Replies: 13
Views: 1,085
Posted By Rob@WretchedMS
It was great to have you all stop by, it's truly...

It was great to have you all stop by, it's truly appreciated!

I tried to make it around to everyone to say hello, but if i missed anyone i apologize. It was out first car show, so even with the...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 03:29 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.