Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Cam Motion
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 237
Search took 0.05 seconds.
Search: Posts Made By: SomeGeoffGuy
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-23-2015, 03:41 PM
Replies: 12
Views: 776
Posted By SomeGeoffGuy
The clutch smell comes through occasionally...

The clutch smell comes through occasionally because the drain in the HVAC is right above the vent area on the trans.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-23-2015, 03:25 PM
Replies: 10
Views: 380
Posted By SomeGeoffGuy
The Z28 has 2.75" pipes and the other two have...

The Z28 has 2.75" pipes and the other two have 2.5" pipes. The ZL1 hangs a little lower around the rear diff to clear the pumpkin than the 1LE.

Getting it shipped is going to be tough because it...
Forum: 2016 Camaro: 6th Gen Camaro forum, news, rumors, discussions 04-01-2015, 04:55 PM
Replies: 32
ZL2
Views: 2,202
Posted By SomeGeoffGuy
I am holding out for the ZL3. -Geoff

I am holding out for the ZL3.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-04-2015, 08:57 AM
Replies: 6
Views: 353
Posted By SomeGeoffGuy
I had a 403 in my fourth gen but it was 4.0...

I had a 403 in my fourth gen but it was 4.0 stroke by 4.005 bore. That is a pretty common iron block performance recipe. It is pretty easy to tell if you have an iron block too.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 01-23-2015, 04:15 PM
Replies: 19
Views: 1,316
Posted By SomeGeoffGuy
A lot of times they put stuff like that in to get...

A lot of times they put stuff like that in to get rid of flow noise. Not sure about that particular one though. If you have ever sat in a car with bad flow noise, you will welcome small dents like...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-19-2014, 03:57 AM
Replies: 10
Views: 882
Posted By SomeGeoffGuy
The NPP tips are in the same spot between 13 and...

The NPP tips are in the same spot between 13 and 15, the regular tips moved.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-13-2014, 04:08 PM
Replies: 46
Views: 3,595
Posted By SomeGeoffGuy
Anyone have a dealer labor book? Cam swap should...

Anyone have a dealer labor book? Cam swap should be in there, and it should cost the same performance or not. Plus some dealers will give you a deal on parts if you have them do the install. Doing...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-10-2014, 07:56 PM
Replies: 17
Views: 832
Posted By SomeGeoffGuy
The good aftermarket cold air intakes actually...

The good aftermarket cold air intakes actually get calibrated on a flow bench so they won't set codes. That is why you don't go buy the super cheap one off ebay where they just stick some piping and...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 11-10-2014, 07:39 PM
Replies: 45
Views: 3,942
Posted By SomeGeoffGuy
And it was 9 seconds faster than a stock SS! ...

And it was 9 seconds faster than a stock SS!

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 11-09-2014, 05:32 PM
Replies: 45
Views: 3,942
Posted By SomeGeoffGuy
If you really look at it, most of the parts that...

If you really look at it, most of the parts that can make your car perform like a z28 are available, but the parts to make it look like a z28 are not. That is the split Guys A and B used.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-03-2014, 08:24 PM
Replies: 1
Views: 305
Posted By SomeGeoffGuy
60 psi at idle. If you had 2000 psi your fuel...

60 psi at idle. If you had 2000 psi your fuel lines would explode and your car would burn to the ground.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-03-2014, 08:22 PM
Replies: 14
Views: 859
Posted By SomeGeoffGuy
I would find another dealer. The GM dealer can...

I would find another dealer. The GM dealer can handle the calibration too. That price doesn't add up.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 11-01-2014, 05:14 PM
Replies: 46
Views: 2,249
Posted By SomeGeoffGuy
New wheels from the dealer. I wouldn't accept...

New wheels from the dealer. I wouldn't accept anything less. And get your $20 back from the tech.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-28-2014, 03:00 PM
Replies: 79
Views: 3,791
Posted By SomeGeoffGuy
So you cut the NPP mufflers off? I was going to...

So you cut the NPP mufflers off? I was going to say, if you get a mild to wild switch you can set it to be closed at startup. The stock calibration is to open the valves at startup. I would put them...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-26-2014, 02:44 PM
Replies: 4
Views: 672
Posted By SomeGeoffGuy
Looks like a cold weld - didn't get enough...

Looks like a cold weld - didn't get enough penetration on one side. It happens. Welding in the v-notch is tough, especially with a mig.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-26-2014, 02:41 PM
Replies: 59
Views: 1,679
Posted By SomeGeoffGuy
Livernois is one of the best shops in Michigan....

Livernois is one of the best shops in Michigan. You get what you pay for.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-12-2014, 07:44 PM
Replies: 26
Views: 1,669
Posted By SomeGeoffGuy
Buy them and let us know if they fit. -Geoff

Buy them and let us know if they fit.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 10-12-2014, 07:36 PM
Replies: 17
Views: 1,632
Posted By SomeGeoffGuy
I would bet that every bushing in every one of...

I would bet that every bushing in every one of those parts is different and tuned just for that suspension. That kit came up for $3200ish on one of the gm parts on-line sites, too.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-05-2014, 07:36 AM
Replies: 68
Views: 4,220
Posted By SomeGeoffGuy
Just run Turbo Blue 110 octane leaded. The stuff...

Just run Turbo Blue 110 octane leaded. The stuff smells AWESOME!

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-28-2014, 10:08 PM
Replies: 11
Views: 843
Posted By SomeGeoffGuy
I would worry it would cause you to start...

I would worry it would cause you to start throwing codes. Most of the aftermarket companies actually do a lot of work to get the MAF sensor to read exactly the same as a stock one. It is not as...
Forum: USA - Great Lakes 09-19-2014, 08:25 AM
Replies: 0
Views: 623
Posted By SomeGeoffGuy
Job Opening - GM Performance Parts Engineer

Pretty cool job opening. Might be some people in the Great Lakes Region Interested.

http://jobs.gm.com/job/Warren-Performance-Accessory-Design-Release-Engineer-Job-MI-48088/217705800/
...
Forum: Camaro Convertible Forum 09-10-2014, 01:33 PM
Replies: 27
Views: 2,299
Posted By SomeGeoffGuy
I thought they did that on purpose - between not...

I thought they did that on purpose - between not being able to drive a stick or unlatch the top, my wife never asks to borrow the car!

-Geoff
Forum: Camaro Convertible Forum 09-05-2014, 11:34 AM
Replies: 22
Views: 1,821
Posted By SomeGeoffGuy
That is why you get a pickup as your second...

That is why you get a pickup as your second vehicle.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-04-2014, 08:21 AM
Replies: 20
Views: 1,834
Posted By SomeGeoffGuy
You need a new tuner and now a new throttle body...

You need a new tuner and now a new throttle body too. You need to cut your losses and never bring your car back there.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-28-2014, 09:23 AM
Replies: 26
Views: 1,831
Posted By SomeGeoffGuy
That is just the GM RPO code for the exhaust....

That is just the GM RPO code for the exhaust. Doesn't really stand for anything offically.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 08-26-2014, 09:51 AM
Replies: 7
Views: 1,439
Posted By SomeGeoffGuy
You would need the cat's too. Z28 headers are...

You would need the cat's too. Z28 headers are longer than stock.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 07-15-2014, 11:25 AM
Replies: 25
Views: 2,293
Posted By SomeGeoffGuy
I doubt we will get any times from Ford. They...

I doubt we will get any times from Ford. They sent the last GT500 too and never released any info.

-Geoff
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 07-15-2014, 11:07 AM
Replies: 6
Views: 901
Posted By SomeGeoffGuy
Are you sure it sin't the traction control...

Are you sure it sin't the traction control kicking on? The only reason I ask is because a friend of mine with a ZL1 had the same problem hitting the passing gear on the highway.

-Geoff
Forum: Camaro Convertible Forum 07-10-2014, 10:20 PM
Replies: 10
Views: 1,742
Posted By SomeGeoffGuy
Did you look at the Z28 factory bellypan? I...

Did you look at the Z28 factory bellypan? I didn't see it on the block list.

-Geoff
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-05-2014, 09:31 PM
Replies: 25
Views: 1,988
Posted By SomeGeoffGuy
Wow, what dealer? I might get it done for that. I...

Wow, what dealer? I might get it done for that. I see you are local to me!

-Geoff
Showing results 1 to 30 of 237

 
Forum Jump

All times are GMT -5. The time now is 10:47 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.