Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Phastek Performance
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 500
Search took 0.42 seconds.
Search: Posts Made By: dan0617
Forum: Audio / Visual / Electronics/ Gauges / Nav 07-09-2015, 11:31 AM
Replies: 4
Views: 524
Posted By dan0617
Interested. PMing you now.

Interested. PMing you now.
Forum: Audio / Visual / Electronics/ Gauges / Nav 07-08-2015, 09:30 PM
Replies: 4
Views: 444
Posted By dan0617
$200 shipped to zip 16686? I'll pay via PayPal.

$200 shipped to zip 16686? I'll pay via PayPal.
Forum: Tuning / Diagnostics -- engine and transmission 02-17-2015, 10:38 PM
Replies: 45
Views: 2,763
Posted By dan0617
I can say I started with a JRE tune, then added...

I can say I started with a JRE tune, then added headers and converter, then later added an ESC blower kit with ZL1 pump and ADM FPCM, then added a BAP, then upgraded injectors and such again, then...
Forum: Suspension / Brakes / Chassis 02-17-2015, 10:25 PM
Replies: 2
Views: 341
Posted By dan0617
Wanted something that has power all the time,...

Wanted something that has power all the time, even with key off. Not many things do in the underhood fuse box. It isn't a problem, I used a fuse tap that plugs in and has a dedicated fuse for that...
Forum: Suspension / Brakes / Chassis 02-17-2015, 05:33 PM
Replies: 2
Views: 341
Posted By dan0617
If you want to reset your ABS without a dealer

I pulled fuse 40 and fuse tapped it to install an underhood light on a switch. All went fine but, when I started the car, the ABS light, all the traction control lights, and the "Service...
Forum: Exterior Parts & Accessories 02-08-2015, 08:26 PM
Replies: 22
Views: 2,165
Posted By dan0617
Catiandria, a post a few up stated it was matte...

Catiandria, a post a few up stated it was matte black.

Causing, Check with R&L carrier. Or Fedex. I'll give you $225 shipped to Tyrone, PA 16686
Forum: Forced Induction 08-01-2014, 10:15 PM
Replies: 1
Views: 661
Posted By dan0617
Sold.

Sold.
Forum: Forced Induction 08-01-2014, 08:53 AM
Replies: 1
Views: 661
Posted By dan0617
FS: Lingenfelter LNC-2000 Timing Controller

For sale is my Lingenfelter LNC-2000 timing controller/rev limiter. Works perfect, none of the wires or plugs are cut off, just plug in and go. Will include instructions. In pic it is still...
Forum: Forced Induction - V8 04-04-2014, 08:07 AM
Replies: 37
Views: 1,825
Posted By dan0617
+1 !!!!

+1 !!!!
Forum: Forced Induction - V8 04-04-2014, 08:03 AM
Replies: 27
Views: 1,934
Posted By dan0617
Ooh absolutely. Won't really be any faster if...

Ooh absolutely. Won't really be any faster if converter locks sooner. Just wanted to make sure the tune addresses the trans for line pressures and such to give it more holding power to take the extra...
Forum: Forced Induction - V8 04-02-2014, 03:37 PM
Replies: 27
Views: 1,934
Posted By dan0617
Sounds like power is there now, would have been...

Sounds like power is there now, would have been higher with locked converter. Make sure the tuner tunes the trans. Should stay locked I think but I'm no expert on dyno pulls. I know on the street...
Forum: Forced Induction - V8 03-31-2014, 06:57 PM
Replies: 27
Views: 1,934
Posted By dan0617
If I remember correctly Jannetty puts them at 505...

If I remember correctly Jannetty puts them at 505 rwhp with no meth and like 9 psi I think. That's auto with headers and CAI and 93 octane. You do need the ADM FPCM, although I don't know if that is...
Forum: Forced Induction - V8 03-30-2014, 09:09 AM
Replies: 2
Views: 436
Posted By dan0617
Yes. Dial it in on the motor. Then turn on the...

Yes. Dial it in on the motor. Then turn on the meth kit. Add enough water/meth to richen you up about a point, maybe a hair more, on the AFR. I like 70/30 mixes usually but am using a 50/50 mix...
Forum: Forced Induction - V8 03-28-2014, 07:58 PM
Replies: 33
Views: 2,282
Posted By dan0617
Did the shop that built it also tune it? If so...

Did the shop that built it also tune it? If so then they should be on the hook for some of it. For sure tuner should have seen fuel system being an issue. If you weren't using the ADM FPCM then you...
Forum: Forced Induction - V8 03-28-2014, 07:48 PM
Replies: 24
Views: 1,308
Posted By dan0617
LIKE

LIKE
Forum: Forced Induction - V8 03-26-2014, 09:06 AM
Replies: 37
Views: 1,825
Posted By dan0617
Put the money in ZL1 pump, ADM FPCM, LT Headers,...

Put the money in ZL1 pump, ADM FPCM, LT Headers, cat delete, a good tune, clutch, rear alignment and drag radials.
Forum: Forced Induction - V8 03-19-2014, 03:24 PM
Replies: 36
Views: 1,795
Posted By dan0617
I did the same thing with the cowl seal but I...

I did the same thing with the cowl seal but I left a piece in the middle to help support the back of the hood when closed, and I left a little of the lip so water won't run down into the engine. I...
Forum: Forced Induction - V8 03-19-2014, 01:41 PM
Replies: 36
Views: 1,795
Posted By dan0617
I see the high IATs at the end of the run because...

I see the high IATs at the end of the run because I'm pushing the blower at and a hair past it's max. Never saw high IAT's at the beginning of the run. They always start low and climb. Might see them...
Forum: Forced Induction - V8 03-18-2014, 09:13 PM
Replies: 36
Views: 1,795
Posted By dan0617
I have a pre blower Mr Freeze meth kit, using a...

I have a pre blower Mr Freeze meth kit, using a fairly small shot, and still see 160 IAT at the end of a 1/4 mile pass on a 60 degree day. Blower is overspinning just a touch at the very top of each...
Forum: Forced Induction - V8 03-18-2014, 07:51 AM
Replies: 36
Views: 1,795
Posted By dan0617
What were your 1/4 mile times?

What were your 1/4 mile times?
Forum: Forced Induction - V8 03-18-2014, 07:31 AM
Replies: 36
Views: 1,795
Posted By dan0617
Make sure engine fans are running at a lower temp...

Make sure engine fans are running at a lower temp than factory. Put in a cooler thermostat maybe, will help if fans are running.
Forum: Forced Induction - V8 03-17-2014, 09:44 PM
Replies: 36
Views: 1,795
Posted By dan0617
Those numbers are fine.

Those numbers are fine.
Forum: Forced Induction - V8 03-17-2014, 06:49 PM
Replies: 25
Views: 1,985
Posted By dan0617
dynotunenitrous.com. Stuck to dash with Velcro. ...

dynotunenitrous.com. Stuck to dash with Velcro.

http://i250.photobucket.com/albums/gg259/dan0617/Mobile%20Uploads/19C71159-6AAC-45C7-B224-8C9691FBE1C0.jpg...
Forum: Forced Induction - V8 03-16-2014, 05:36 PM
Replies: 12
Views: 932
Posted By dan0617
Getting dialed in closer. We added a touch of...

Getting dialed in closer. We added a touch of timing and removed some fuel. Ran it again Saturday. Still about 0.5 or so rich for what we are looking for. Car pulls hard. Makes me a little...
Forum: Forced Induction - V8 03-15-2014, 03:07 PM
Replies: 16
Views: 1,269
Posted By dan0617
Another option is www.dynotunenitrous.com. I...

Another option is www.dynotunenitrous.com. I bought one of their dual gauges, boost on top and wideband on bottom, then stuck it to the dash with velcro. Nice small square, mostly matches the dash...
Forum: Forced Induction - V8 03-14-2014, 05:45 AM
Replies: 27
Views: 1,328
Posted By dan0617
ZL1/ADM combo and maybe a BAP, or a twin pump...

ZL1/ADM combo and maybe a BAP, or a twin pump setup.

JRE 2800 stall converter. Nice and tight for normal driving.

Rear cradle bushings

Scrap the cats if you can

Wideband setup
Forum: Forced Induction - V8 03-13-2014, 02:18 PM
Replies: 12
Views: 932
Posted By dan0617
You are from WI.....does the weather ever...

You are from WI.....does the weather ever change?? :biggrin:
Forum: Forced Induction - V8 03-13-2014, 02:12 PM
Replies: 12
Views: 932
Posted By dan0617
No, it is only 20 degrees out here. Supposed to...

No, it is only 20 degrees out here. Supposed to be up to 55 tomorrow, if I get home from work in time, I'll try it out tomorrow afternoon.

I'm using the bad weather time to concoct the next mod: ...
Forum: Forced Induction - V8 03-13-2014, 01:57 PM
Replies: 52
Views: 2,757
Posted By dan0617
H-E, I agree totally with this alignment...

H-E, I agree totally with this alignment recommendation for Warhorse's setup. I'd suggest a hair more positive toe but yes, this is my scenario #1 above. Also totally agree that the alignment is...
Forum: Forced Induction - V8 03-13-2014, 01:20 PM
Replies: 52
Views: 2,757
Posted By dan0617
Let me see if I can clarify my basic...

Let me see if I can clarify my basic understanding in 3 different drag setup alignment setups, 3 different scenariaos, all of which are ok, depending on budget and use. Alot of my experience is from...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 12:15 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.