Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
dave@hennessey
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.03 seconds.
Search: Posts Made By: fz4k98
Forum: 5th Gen Camaro SS LS LT General Discussions 03-11-2024, 07:31 PM
Replies: 10
Views: 403
Posted By fz4k98
When it happened did the clutch disengage and...

When it happened did the clutch disengage and stay disengaged until the pedal was pulled up?
Forum: Suspension / Brakes / Chassis 03-09-2024, 08:12 AM
Replies: 9
Views: 287
Posted By fz4k98
I did a little experiment on my ss related to...

I did a little experiment on my ss related to single use bolts for the rear calipers. The left side got new bolts and the right side reused the current bolts. The left side was able to achieve the...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 02-12-2024, 08:35 AM
Replies: 13
Views: 597
Posted By fz4k98
I had a Mantic a few years ago and it went bad...

I had a Mantic a few years ago and it went bad after about 5k. The issue was the spline hub warped on the clutches which caused the clutches to wobble a little (.028 on one disk and .031 on other)...
Forum: 5th Gen Camaro SS LS LT General Discussions 01-07-2024, 08:01 AM
Replies: 3
Views: 623
Posted By fz4k98
you mentioned it happens driving or in neutral...

you mentioned it happens driving or in neutral and clutch in or out and is engine rpm related. This strongly suggests it has nothing to do with the transmission. Clutch in or out suggests it has...
Forum: 5th Gen Camaro SS LS LT General Discussions 01-04-2024, 07:22 AM
Replies: 32
Views: 1,159
Posted By fz4k98
Sounds about what i got at the track...

Sounds about what i got at the track day:smiling1:

Used up 13 gallons in 80 minutes .
Forum: Suspension / Brakes / Chassis 12-31-2023, 02:52 PM
Replies: 16
Views: 825
Posted By fz4k98
you may want to look at how much free play is in...

you may want to look at how much free play is in the axle joints. I had a clicking on left rear and it was the outer axle flex joint worn out.
Forum: 5th Gen Camaro SS LS LT General Discussions 12-24-2023, 01:59 PM
Replies: 7
Views: 604
Posted By fz4k98
Thanks for the feedback. I was not sure if...

Thanks for the feedback. I was not sure if someone had figured out a way to simplify the swap without all the harnesses, paddle shifter etc. I was thinking it might be closer trans, shifter and...
Forum: 5th Gen Camaro SS LS LT General Discussions 12-23-2023, 07:50 PM
Replies: 7
Views: 604
Posted By fz4k98
Manual to auto trans swap shop

I am considering swapping my 13 ss from manual trans to an automatic. In searching I see information related to auto to manual but not much the other way.

Is anyone aware of any shops that are...
Forum: Forced Induction - V8 12-10-2023, 08:48 AM
Replies: 25
Views: 1,506
Posted By fz4k98
You should also check the rear alignment for toe...

You should also check the rear alignment for toe and camber. These settings can make a big difference in handling and tire spin.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 12-08-2023, 07:42 AM
Replies: 1
Views: 544
Posted By fz4k98
I have a spec 3+ in my car now and it is...

I have a spec 3+ in my car now and it is performing great. It drives like a factory clutch and seems to be holding up well. My car dynod 610 rwhp for reference.

I have had two different twin disk...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-29-2023, 08:00 AM
Replies: 1
Views: 336
Posted By fz4k98
The design is for the bearing to be always...

The design is for the bearing to be always touching the finger. The slave cylinder is compressed down during normal use and extends forward toward the fingers to release the clutch when the pedal is...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-27-2023, 07:42 AM
Replies: 14
Views: 1,407
Posted By fz4k98
I used a straight edge across the pressure plate...

I used a straight edge across the pressure plate surface and a caliper with a depth tool on it. In my case the pressure plate fingers were below the pressure plate surface so I had to measure them...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-26-2023, 05:57 PM
Replies: 14
Views: 1,407
Posted By fz4k98
the measurement locations you used will work as...

the measurement locations you used will work as long as they are accurate. I did a different approach and had the clutch system mounted to the engine when I did mine.

Visually, the end result is...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-20-2023, 08:35 PM
Replies: 17
Views: 1,010
Posted By fz4k98
There are many areas on the camaro where torque...

There are many areas on the camaro where torque plus angle is used. I have ran across it on suspension parts and the angle cannot typically be achieved on a reassambly unless all parts are new...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-14-2023, 08:08 AM
Replies: 30
Views: 1,507
Posted By fz4k98
I am on my 2nd set of DSS axles. 1st set lasted...

I am on my 2nd set of DSS axles. 1st set lasted about 30k before showing wear and then a clicking noise. They did not break but did wear out. They made some changes to the design which is supposed to...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-13-2023, 07:38 AM
Replies: 10
Views: 693
Posted By fz4k98
If it does not happen in neutral the noise is...

If it does not happen in neutral the noise is most likely in the drivetrain, not the clutch system. The slave is under compression all the time and when the pedal is pushed it extends to release the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-12-2023, 07:48 AM
Replies: 10
Views: 693
Posted By fz4k98
Does it do it in neutral when letting clutch out?

Does it do it in neutral when letting clutch out?
Forum: 5th Gen Camaro SS LS LT General Discussions 10-27-2023, 05:55 PM
Replies: 81
Views: 7,972
Posted By fz4k98
Sorry to hear all u are going through but man...

Sorry to hear all u are going through but man this is some amazing problem solving u are doing.
Forum: Forced Induction - V8 10-25-2023, 03:20 PM
Replies: 14
Views: 1,378
Posted By fz4k98
i have 42k on my whipple and the only thing I...

i have 42k on my whipple and the only thing I have done is a new belt and plugs every 20k.

Pros, very reliable and awesome power across entire rpm range.

Cons, causes a lot of broken parts...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-23-2023, 05:51 PM
Replies: 1
Views: 675
Posted By fz4k98
tr6060 input shaft issue

I am looking at having to replace the input shaft bearing on my trans. I'm able to see videos of trans rebuilds but have not found anything on just replacing the input shaft and bearing.

I am...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-13-2023, 08:37 AM
Replies: 2
Views: 696
Posted By fz4k98
Its best to work from easiest to hardest. Start...

Its best to work from easiest to hardest. Start with a good bleed. Check to make sure you have good fluid flow while using pedal during the bleed ( no fluid obstruction).

I have chased this issue...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-05-2023, 07:38 AM
Replies: 6
Views: 1,367
Posted By fz4k98
You may want to try cleaning the area and...

You may want to try cleaning the area and spraying a leak trace aerosol on it to find it. I used this in the past and it worked pretty well.
Forum: 5th Gen Camaro SS LS LT General Discussions 09-30-2023, 08:08 AM
Replies: 90
Views: 5,359
Posted By fz4k98
I ordered a 13 new and still have it. Before I...

I ordered a 13 new and still have it. Before I ordered I went to a new manufacturer car show with an open mind and looked at many sport car choices but kept going back to the camaro to look at it...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-28-2023, 07:47 AM
Replies: 53
Views: 3,720
Posted By fz4k98
This is a good list. I would suggest one more...

This is a good list. I would suggest one more thing that is needed before starting, a quality attitude. If your attitude is not right, nothing else will matter.
Forum: 5th Gen Camaro SS LS LT General Discussions 09-27-2023, 03:36 PM
Replies: 53
Views: 3,720
Posted By fz4k98
Once i saw the terrible quality from the so...

Once i saw the terrible quality from the so called experts i went back to doing it all myself. I've got about 40k miles on my whipple and have broken every part after the crank at least once. I feel...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-27-2023, 07:35 AM
Replies: 53
Views: 3,720
Posted By fz4k98
You will need about $15k to achieve the goal and...

You will need about $15k to achieve the goal and another $15k for broken parts once you start using the power.

Basically you should research and plan on upgrading every driveline part after the...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-07-2023, 07:02 PM
Replies: 8
Views: 850
Posted By fz4k98
i would suggest figuring out the exact conditions...

i would suggest figuring out the exact conditions for when the vibration happens and goes away. It will point you toward the area of the car to focus on.

Is it worse with increase in speed. ...
Forum: Suspension / Brakes / Chassis 08-23-2023, 07:24 AM
Replies: 3
Views: 501
Posted By fz4k98
I have to drop the front subframe a little to get...

I have to drop the front subframe a little to get trans out. I've done it several times without issue. I use jacks to support subframe, loosen bolts allt the way out and then reinstall 3 threads....
Forum: 5th Gen Camaro SS LS LT General Discussions 08-13-2023, 04:41 PM
Replies: 24
Views: 1,769
Posted By fz4k98
I took apart my old starter to look for anything...

I took apart my old starter to look for anything that might contribute to the slower starting on my car. While there was no damage or burned wiring etc, there was a lot of metal shavings debris from...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-10-2023, 08:19 PM
Replies: 24
Views: 1,769
Posted By fz4k98
How old is the current starter? I replaced mine...

How old is the current starter? I replaced mine this year without any other changes like grounds or new battery or cables and it now spins like new. Mine was a 13 camaro with 64k mikes.
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 06:05 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.